2903912

https://www.phoenixcontact.com/us/products/2903912 Hybrid motor starter - ELR H5-I-PT- 24DC/500AC-9 - 2903912 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Hybrid motor starter for reversing 3~ AC motors up to 550 V AC, with 24 V DC input, 9 A output current, adjustable overload shutdown, and push-in connection. The figure shows the ELR H5-IESPT- 24DC/500AC-9 version Product Features     Key commercial data Packing unit 1 pc Weight per Piece (excluding packing) 280.0 GRM Custom tariff number 85371099 Country of origin Germany Technical data Input data Input name Device supply Rated control supply voltage US 24 V DC (According to IEC 60947-1) Voltage range with reference to US 0.8 ... 1.25 Rated control supply current IS ≤ 40 mA Protective circuit Protection against polarity reversal Surge protection Operating voltage display Green LED Status display Yellow LED Indication Red LED Input name Control input right/left Typical input current at UN ≤ 5 mA Rated control supply current IS ≤ 40 mA (According to IEC 60947-1) 05/18/2015   Page 1 / 6 https://www.phoenixcontact.com/us/products/2903912 Hybrid motor starter - ELR H5-I-PT- 24DC/500AC-9 - 2903912 Technical data Input data Rated actuating voltage UC 24 V DC Voltage range with reference to UC 0.8 ... 1.25 Rated actuating current IC ≤ 5 mA Protective circuit Protection against polarity reversal Typical response time < 35 ms Typical turn-off time < 40 ms Output data load output Rated operating voltage Ue 500 V AC Operating voltage range 42 V AC ... 550 V AC Load current max. 9 A (see derating curve) Min. load current 1.5 A Rated operating current at AC-51 9A Rated operating current at AC-53a 6.5 A Leakage current 0 mA Residual voltage < 0.5 V (at Ie) Protective circuit Surge protection Output data reply output Note Confirmation 01: floating change-over contact, signal contact Contact type 1 PDT Contact material AgSnO2, hard gold-plated Maximum switching voltage 30 V AC 36 V DC Minimum switching voltage 100 mV AC/DC (at 10 mA) Min. switching current 1 mA (at 24 V) Maximum inrush current 50 mA Limiting continuous current 50 mA Interrupting rating (ohmic load) max. 1.2 W (at 24 V DC) Note the following values are applicable if a gold layer is destroyed Maximum switching voltage 250 V AC/DC Minimum switching voltage 5 V (at 100 mA) Min. switching current 10 mA (at 12 V) Limiting continuous current 6A Interrupting rating (ohmic load) max. 140 W (at 24 V DC) 20 W (at 48 V DC) 18 W (at 60 V DC) 23 W (at 110 V DC) 05/18/2015   Page 2 / 6 https://www.phoenixcontact.com/us/products/2903912 Hybrid motor starter - ELR H5-I-PT- 24DC/500AC-9 - 2903912 Technical data Output data reply output 40 W (at 220 V DC) 1500 VA (for 250 V AC) Switching capacity according to IEC 60947-5-1 2 A (at 24 V, DC13) 0.2 A (at 110 V, DC13) 0.1 A (at 220 V, DC13) 3 A (at 24 V, AC15) 3 A (at 120 V, AC15) 3 A (at 230 V, AC15) Measuring technology and signaling contact Measuring via Current transformer for line current on L1 and L3 Connection data Connection method Push-in connection Stripping length 10 mm Conductor cross section solid min. 0.2 mm² Conductor cross section solid max. 2.5 mm² Conductor cross section flexible min. 0.2 mm² Conductor cross section flexible max. 2.5 mm² Conductor cross section AWG min. 24 Conductor cross section AWG max. 14 General Test voltage input/output 4 kVrms Mounting position Vertical (horizontal DIN rail) Assembly instructions can be aligned with spacing: see derating Operating mode 100% operating factor Designation Air clearances and creepage distances between the power circuits Standards/regulations DIN EN 50178 Insulation Safe isolation (EN 50178) for mains voltage ≤ 500 V AC Safe isolation (IEC 60947-1) for mains voltage ≤ 300 V AC Basic insulation (IEC 60947-1) for mains voltage of 300 ... 500 V AC Pollution degree 2 Surge voltage category III Designation Standards/regulations Standards/regulations IEC 60947-1 EN 60947-4-2 Dimensions 05/18/2015   Page 3 / 6 https://www.phoenixcontact.com/us/products/2903912 Hybrid motor starter - ELR H5-I-PT- 24DC/500AC-9 - 2903912 Technical data Dimensions Width 22.5 mm Height 99 mm Depth 114.5 mm Ambient conditions Ambient temperature (operation) -25 °C ... 70 °C Ambient temperature (storage/transport) -40 °C ... 80 °C Degree of protection IP20 UL data Short-circuit current rating (SCCR) 100 kA (500 V AC (30 A CC/30 A J (high fault) fuse)) 5 kA (500 V AC (20 A RK5 (standard fault) fuse)) Classifications eCl@ss eCl@ss 4.0 27371102 eCl@ss 4.1 27371102 eCl@ss 5.0 27371601 eCl@ss 5.1 27371601 eCl@ss 6.0 27371601 eCl@ss 7.0 27371601 eCl@ss 8.0 27370905 ETIM ETIM 3.0 EC000066 ETIM 4.0 EC000066 ETIM 5.0 EC001037 UNSPSC UNSPSC 6.01 30211915 UNSPSC 7.0901 39121514 UNSPSC 11 39121514 UNSPSC 12.01 39121514 UNSPSC 13.2 39121514 Approvals Approvals 05/18/2015   Page 4 / 6 https://www.phoenixcontact.com/us/products/2903912 Hybrid motor starter - ELR H5-I-PT- 24DC/500AC-9 - 2903912 Approvals Approvals UL Listed / cUL Listed / IECEE CB Scheme / UL Listed / cUL Listed / cULus Listed Ex Approvals Approvals submitted Approval details UL Listed  cUL Listed  IECEE CB Scheme  UL Listed  cUL Listed  cULus Listed  Drawings 05/18/2015   Page 5 / 6 https://www.phoenixcontact.com/us/products/2903912 Hybrid motor starter - ELR H5-I-PT- 24DC/500AC-9 - 2903912 Load current [A] Diagram Block diagram MAN RES AUTO 9 8 7 6 5 4 3 2 1 0,18 RES 1/L1 3/L2 5/L3 Logic µP Us T 0 50 60 70 Ambient temperature [°C] = aligned with > 20 mm spacing = aligned without spacing 10 20 30 40 R L & Error 97 96 95 2/T1 4/T2 6/T3 Derating diagram Phoenix Contact 2015 © - all rights reserved http://www.phoenixcontact.com 05/18/2015   Page 6 / 6