LV3745BY-70.0M

P letronics, Inc. 19013 36 Ave. West PO Box 2607 Lynnwood, Washington 98036 U.S.A. T: 1-425-776-1880 F: 1-425-776-2760 E: ple-sales@pletronics.com www.pletronics.com th Effective January 1, 2008 The LV11xxBY and the LV11xxBW devices are discontinued. These were discontinued because the components needed to make these parts are no longer available. For the LV11xxBY Use the LV99xxDV oscillator and a 3.3V LDO. The board space required will be similar. For the LV11xxBW Use the LV77xxDW oscillator, this is a smaller footprint and superior performance Pl tronics., Inc. 19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA Manufacturer of High Quality Frequency Control Products LV1145B LVDS Series Low Voltage Differential Signal Output with Enable/Disable 6 Pad Leadless Surface Mount Oscillator Standard Specifications Overall Frequency Stability Operating Temperature Range Operable Supply Voltage (Vcc) High Level Output Voltage Low Level Output Voltage Differential Output Voltage Offset Voltage Output Leakage Current Supply Current (Icc) Enabled Supply Current (Icc) Disabled Symmetry (DC) Rise and Fall Time (Tr & Tf) RMS Jitter Enable / Disable Pin: 1.50 MHz – 650.00 MHz Consult factory for higher frequencies ± 50 PPM, ± 25 PPM and ± 20 PPM over Operating Temp. Range 0 to +80°C is standard, can be extended to - 40 to +85°C 3.3 V ± 5% standard, 5.0 V ± 10% also available 1.43 V typical and 1.60 V maximum with output enabled (100 ohm load) See Test circuit #6 0.90 V minimum and 1.10 V typical with output enabled (100 ohm load) See TC #6 247 V minimum, 330 V typical and 454 V maximum with output enabled (100 ohm load) See TC #6 1.125 V minimum, 1.25 V typical and 1.375 V maximum with output enabled (100 ohm load) See TC #6 10 uA maximum with output disabled 50 mA max < 200 MHz, 60 mA max < 500 MHz, 70 mA max 500 MHz and above 20 mA max < 200 MHz, 30 mA max < 500 MHz, 40 mA max 500 MHz and above 45/55% measured at 0°C