THD3004-16.384M

THD3004-16.384MHz Stratum-III TCVCXO February 2016 • Pletronics’ THD3004-16.384M is a tem perature com pensated crystal oscillator • Voltage Control Function • HCMOS output. • The package is designed for high density surface m ount designs. • 3.2 x 5 m m LCC Ceram ic Package • Tape and Reel packaging is available. Pletronics Inc. certifies this device is in accordance with the RoHS 6/6 (2011/65/EC) and WEEE (2002/96/EC) directives. Pletronics Inc. guarantees the device does not contain the following: Cadm ium , Hexavalent Chrom ium , Lead, Mercury, PBB’s, PBDE’s W eight of the Device: 0.10 gram s Moisture Sensitivity Level: 1 As defined in J-STD-020D.1 Second Level Interconnect code: e4 Absolute Maximum Ratings: Parameter Unit V CC Supply Voltage -0.5V to +6.5V Vi Input Voltage -0.5V to V CC + 0.5V Vo Output Voltage -0.5V to V CC + 0.5V Thermal Characteristics The m axim um die or junction tem perature is 155 oC The therm al resistance junction to board is 30 to 50 oC/W att depending on the solder pads, ground plane and construction of the PCB. ESD Rating Model Minimum Voltage Conditions Human Body Model 1500 MIL-STD-883 Method 3115 Charged Device Model 1000 JESD 22-C101 www.pletronics.com 425-776-1880 1 THD3004-16.384MHz Stratum-III TCVCXO February 2016 Electrical Specification for specified Vcc over the specified temperature range Item Min Frequency Range TYP Max 16.384 Unit Condition MHz Frequency Stability vs Temp. -0.28 +0.28 ppm Vcontrol = 1.50 volts (Fmax-Fmin)/2 24 Hour Holdover -0.37 0.37 ppm GR-1244-CORE Frequency Calibration -0.5 +0.5 ppm Frequency offset at 25°C, 60 minutes after reflow Frequency Stability / Supply -0.10 +0.10 ppm Load: 10K ohm // 10 pF & Vcc + _ 5% Load Sensitivity -0.20 +0.20 ppm ±2% variation in magnitude from 10K ohm ±10% || 10 pF Long Term Stability (Aging) -3.4 +3.4 ppm After 15 years. %VS Load: 10K ohm + _ 10% // 10 pF Output Waveform CMOS Output VHIGH as % of Supply 90 Output VLOW as % of Supply 10 %VS TRISE and TFALL (10% to 90%) 6.5 nS % Duty Cycle at 50% Supply Phase Noise 10 Hz 100 Hz 1 kHz 10 kHz Jitter 40 50 60 - -90 -115 -135 -145 - - - 1.7 pS dBc/Hz V Supply Range VCC 2.8 - 5.5 Volts Supply Current ICC - - 7.0 mA 2.50 Volts Vcontrol Range Frequency Pullability Linearity Operating Temperature Range Storage Temperature Range www.pletronics.com 0.5 Typical values for a 20.0 MHz oscillator at 25°C 10 Hz to 1 MHz offset from carrier 1.50 volts nominal + _ 9.2 + _ 10.0 - ppm - 0.05 2.0 % In accordance with MIL-PRF-55310 +85 o C Specified by part number +95 o C -40 -55 425-776-1880 2 THD3004-16.384MHz Stratum-III TCVCXO February 2016 Phase Noise: MTIE: www.pletronics.com 425-776-1880 3 THD3004-16.384MHz Stratum-III TCVCXO February 2016 Reliability: Environmental Com pliance Parameter Condition Mechanical Shock MIL-STD-883 Method 2002, Condition B Vibration MIL-STD-883 Method 2007, Condition A Solderability MIL-STD-883 Method 2003 Thermal Shock MIL-STD-883 Method 1011, Condition A Package Labeling Label is 1" x 2.6" (25.4mm x 66.7mm) Font is Courier New Bar code is 39-Full ASCII www.pletronics.com Label is 1" x 2.6" (25.4mm x 66.7mm) Font is Arial 425-776-1880 4 THD3004-16.384MHz Stratum-III TCVCXO February 2016 Part Marking: 1638 zzz C P zzz zz YMD 1638 P YMD z = = = = 16.384 frequency in M Hz Pletronics M anufacturing date code (see table below) Internal factory code 1638 PLE z = = = 16.384 frequency in M Hz Pletronics Internal factory code YMD = M anufacturing date code (see table below - may appear on any line on part) Or: YMD 1638.zzz YMD C PLEzzzzz YMD The actual part number is THD3004-16.384M where the model number “004” is the specification number the part is made to. This is not included in the part marking. This is included on the label on the Tape and Reel. Codes for Date Code YM D Code 4 5 6 7 8 Code A B C D E F G H J K L M Year 2014 2015 2016 2017 2018 Month JAN FEB MAR APR MAY JUN JUL AUG SEP OCT NOV DEC Code 1 2 3 4 5 6 7 8 9 A B C D E F G 16 Day 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Code H J K L M N P R T U V W X Y Z Day 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 www.pletronics.com 425-776-1880 5 THD3004-16.384MHz Stratum-III TCVCXO February 2016 Mechanical: Pad Inches mm A 0.197 + _0.008 5.00 + _0.20 B 0.126 + _0.008 3.20 + _0.20 C 0.059 max 1.50 max D1 0.0.55 1.40 E1 0.031 0.80 F1 0.043 1.10 G1 0.102 2.60 H1 0.013C 0.50C J1 0.008 0.20R Function Note 1 Vcontrol Input If this function is not specified, recommend connecting this pad to ground. 2 Ground (GND) 3 Output 4 Supply Voltage (VCC) Connect an appropriate power supply bypass capacitors as close as possible. - N. C. All other pads on the bottom shall not be connected. These are internally connected and were for the TCXO compensation process Layout and application information All connection points in the designated region have solder mask cover to avoid any electrical connections For Optimum Stability and Jitter Performance, Pletronics recom mends: • • • • • a ground plane under the device no large transient signals (both current and voltage) should be routed under the device do not layout near a large magnetic field such as a high frequency sw itching pow er supply do not place near piezoelectric buzzers or mechanical fans. minimize air flow across the device www.pletronics.com 425-776-1880 6 THD3004-16.384MHz Stratum-III TCVCXO February 2016 Reflow Cycle (typical for lead free processing) The part may be reflowed 2 times without degradation. Tape and Reel: available for quantities of 250 to 1000 per reel, cut tape for < 250 Constant Dimensions Table 1 Tape Size D0 8mm D1 Min E1 P0 P2 1.0 T Max 0.6 0.6 0.1 2.0 +0.05 _ 12mm 1.5 1.5 1.75 4.0 16mm +0.1 -0.0 1.5 _ +0.1 _0.1 + 24mm T1 Max S1 Min 2.0 _ +0.1 1.5 Variable Dimensions Table 2 Tape Size B1 Max E2 Min F P1 T2 Max W Max Ao, Bo & Ko 16 mm 12.1 14.25 7.5 _ +0.1 8.0 _ +0.1 8.0 16.3 Note 1 Note 1: Embossed cavity to conform to EIA-481-B scale Dimensions in mm Not to REEL DIMENSIONS A B inches 7.0 10.0 13.0 mm 177.8 254.0 330.2 inches 2.50 4.00 3.75 mm 63.5 101.6 95.3 Tape Width 16.4 +2.0 -0.0 16.0 C mm D mm 13.0 +0.5 / -0.2 16.4 +2.0 -0.0 16.4 +2.0 -0.0 Reel dimensions may vary from the above www.pletronics.com 425-776-1880 7 THD3004-16.384MHz Stratum-III TCVCXO February 2016 IM PORTANT NOTICE Pletronics Incorporated (PLE) reserves the right to make corrections, improvements, modifications and other changes to this product at anytime. PLE reserves the right to discontinue any product or service without notice. Customers are responsible for obtaining the latest relevant information before placing orders and should verify that such information is current and complete. All products are sold subject to PLE’s terms and conditions of sale supplied at the time of order acknow ledgment. PLE warrants perform ance of this product to the specifications applicable at the time of sale in accordance with PLE’s limited warranty. Testing and other quality control techniques are used to the extent PLE deems necessary to support this warranty. Except where mandated by specific contractual documents, testing of all parameters of each product is not necessarily performed. PLE assumes no liability for application assistance or customer product design. Customers are responsible for their products and applications using PLE components. To m inimize the risks associated with the customer products and applications, customers should provide adequate design and operating safeguards. PLE products are not designed, intended, authorized or w arranted to be suitable for use in life support applications, devices or systems or other critical applications that may involve potential risks of death, personal injury or severe property or environmental damage. Inclusion of PLE products in such applications is understood to be fully at the risk of the customer. Use of PLE products in such applications requires the written approval of an appropriate PLE officer. Questions concerning potential risk applications should be directed to PLE. PLE does not warrant or represent that any license, either express or implied, is granted under any PLE patent right, copyright, artw ork or other intellectual property right relating to any combination, machine or process which PLE product or services are used. Information published by PLE regarding third-party products or services does not constitute a license from PLE to use such products or services or a warranty or endorsement thereof. Use of such information may require a license from a third party under the patents or other intellectual property of the third party, or a license from PLE under the patents or other intellectual property of PLE. Reproduction of information in PLE data sheets or web site is permissible only if the reproduction is without alteration and is accompanied by associated warranties, conditions, limitations and notices. Reproduction of this information with alteration is an unfair and deceptive business practice. PLE is not responsible or liable for such altered docum ents. Resale of PLE products or services w ith statements different from or beyond the parameters stated by PLE for that product or service voids all express and implied warranties for the associated PLE product or service and is an unfair or deceptive business practice. PLE is not responsible for any such statements. Contacting Pletronics Inc. Pletronics Inc. Tel: 425-776-1880 th 19013 36 Ave. W est Fax: 425-776-2760 Lynnw ood, WA 98036-5761 USA E-mail: ple-sales@ pletronics.com URL: w w w .pletronics.com Copyright © 2011, Pletronics Inc. www.pletronics.com 425-776-1880 8