CXA-L0605-VJL

DC-AC INVERTER UNIT CXA-L0605-VJL (4.0W SINGLE OUTPUT WITH DIMMING FUNCTION) DESCRIPTION : This DC to AC Inverter was developed for notebook computer and many other low LCD Backlight power supply as low profile applications, either for Note Book PC or Industrial. APPLICABLE LCD: 10 to 12 inches single lamp type Lamp Voltage 600V Lamp Current 6mA FEATURES : Current Feedback Circuit High Efficiency Low noise with voltage resonant circuit Regulated output current TEMPERATURE & HUMDITY : Operating Temperature Range Storage Temperature Range Humidity DIMENSIONS : 95.5 max (4.5) (4) 82 ±0.2 Unit : mm Weight : 13.7g typ. 0 °C ~ +60 °C -30 °C ~ +85 °C 95 %RH max (PRELIMNARY, STANDARD) 20 max 12.8 ±0.2 CN1 2 1 2-φ2.2 ±0.1 1 CN2 3 1 8 max 1.0 max No. 1 2 3 Part Discription PCB Connector CN1 Connector CN2 Qty. 1 1 1 Material UL94V-0 (CEM-3) 53261-0590 SM02(8.0)B-BHS-1 Note t=1.0mm Molex JST Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page ( 1 / 4 ) Address: D örnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 80 VER, 0 4 October 2002 All specification are subject to change without notice. DC-AC INVERTER UNIT CXA-L0605-VJL (4.0W SINGLE OUTPUT WITH DIMMING FUNCTION) (PRELIMNARY, STANDARD) Input Side CN1 Output Side CN2 Pin No. Symbols CN 1-1 Vin CN 1-2 GND CN 1-3 CN 1-4 CN 1-5 Vrmt Vbr N.C. Ratings 4.75~5.25V 0V 2.5~Vin (Active High) / 0~0.5V 0~3V - Pin No. Symbols Ratings CN 2-1 V HIGH 600Vrms CN 2-2 N.C. CN 2-3 V LOW (2V) ELECTRICAL CHARACTERISTICS: Items Output Current Input Current Frequency Open Circuit Voltage Symbols Iout1 Iout2 Iout3 Iin F Vopen Vin [V] 4.75~5.25 5 4.75~5.25 4.75~5.25 Conditions Vbr [V] Ta [°C] 18~28 0 0~60 3 18~28 0 0~60 0 0~60 0~3 0~60 RL [KΩ] 80 70~90 226 70~90 70~90 ∞ Specification Unit Min. Typ. Max. 5.4 6 6.6 5.3 6 6.7 mArms 2.4 3 3.6 800 1000 mA DC 35 45 55 kHz 1500 1600 Vrms DIMMING CHARACTERISTICS (Refernce): 7,0 6,0 Iout (mArms) 5,0 4,0 3,0 2,0 1,0 0,0 0,0 0,5 1,0 1,5 2,0 2,5 3,0 Vbr (VDC) Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page ( 2 / 4 ) Address: D örnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 80 VER, 0 4 October 2002 All specification are subject to change without notice. DC-AC INVERTER UNIT CXA-L0605-VJL (4.0W SINGLE OUTPUT WITH DIMMING FUNCTION) (PRELIMNARY, STANDARD) APPLICATION (for example): REMOTE TERMINAL CIRCUIT (Reference): Voltage Dimming Type CN1-1(Vin) Vin SW Active On CN1-2(GND) CN1-3(Vrmt) Vrmt Vbr 0~3V CN1-4(Vbr) CN1-5(NC) CN2-1(Iout) CXA -L0612-VJL SM02(8.0)B -BHS (JST) CCFL RL CN2-3(Iout-ret) Resistor Dimming Type CN1-1(Vin) Vin SW Active On CN1-2(GND) CN1-3(Vrmt) Vrmt Vbr 3V 10kΩ CN1-4(Vbr) CN1-5(NC) CN2-1(Iout) CXA -L0612-VJL SM02(8.0)B -BHS (JST) CCFL RL CN2-3(Iout-ret) None Dimming Type CN1-1(Vin) Vin CN1-2(GND) CN1-3(Vrmt) CN1-4(Vbr) CN1-5(NC) CN2-1(Iout) CXA -L0612-VJL SM02(8.0)B -BHS (JST) CCFL RL CN2-3(Iout-ret) TEST CIRCUIT: Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page ( 3 / 4 ) Address: D örnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 80 VER, 0 4 October 2002 All specification are subject to change without notice. DC-AC INVERTER UNIT CXA-L0605-VJL (4.0W SINGLE OUTPUT WITH DIMMING FUNCTION) (PRELIMNARY, STANDARD) Note 1. Note 2. For circuit connection, please prefer to test circuit diagram. Please use minimum of 2mm clearance (all directions) between inv erter high voltage area and any conductors. Please refer to mechanical drawing for marking of hi gh voltage area. Open voltage (strike voltage) is measured across the transformer secondary winding at no load as the reading at the output connector would be less than the actual va lue. If the start up voltage falls below Cold Cathode Tube strike vol tage, the CCFL will not light up easily specially at lower ambient temperature. Please review mounting i nstruction to avoid any abnormal operation due to coupling/leakage capacitance of inverter high v oltage area to any surrounding conductor. Please check your lamp characteristic for minimum operational cu rrent and set the limit point in your design to avoid flickering and/or abnormal operation. For proper operation of circuit protection (FUSE or IC PROTECTOR ), please use minimum of 2A capacity for input power supply. Note 3. Note 4. Note 5. Note 6. Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page ( 4 / 4 ) Address: D örnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 80 VER, 0 4 October 2002 All specification are subject to change without notice.