PS-DA0151-02

DC-AC INVERTER UNIT PS-DA0151-02(S) (5 W SINGLE OUTPUT) DESCRIPTION : This low profile DC to AC Inverter is developed for single lamps. Optimized for Sharp: LQ057Q3DC12, 26th Sept. 2006 02 (PRELIMINARY INFORMATION) APPLICABLE LCD: Lamp Voltage 690 Vrms Lamp Current 5.0 mArms Lamp Start Up Voltage 2.400 Vrms (Vin : 5 Vdc) FEATURES : Current balance circuit Extra high starting Voltage Dimming function over ext. PWM-signal RoHS compliant (S) TEMPERATURE & HUMIDITY : Operating Temperature Range Storage Temperature Range Humidity DIMENSIONS : -30°C ~ +70°C (only LQ057Q3DC12) -30°C ~ +85°C 95 %RH max L x B x H 100 x 30 x 9 mm Pin 1 SM02(8.0)B-BHS-1-TB (JST) Pin 1 Unit : mm Weight :15 (g) typ. Note: Please use plastic screw in case of a non-insulating mounting base! Components No. 1 2 3 Part Description PCB Connector CN1 Connector CN2 Qty. 1 1 1 Material UL94V-0 (FR-4 or CEM-3) S5B-PH-SM3 SM02(8.0)B-BHS-1-TB Note t=1m m JST or equal JST or equal Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page (1) Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Version 1.0.1, 6th October 2008 All specifications are subject to change without notice. DC-AC INVERTER UNIT PS-DA0151-02(S) (5 W SINGLE OUTPUT) Input side CN1: Pin No. Symbols Vin CN 1-1 GND CN 1-2 Ext. PWM CN 1-3 N.C. CN 1-4 N.C. CN 1-5 (PRELIMINARY INFORMATION) Output side CN2: Pin No. Symbols VLOW CN 2-1 N.C. CN 2-2 VHIGH CN 2-3 Ratings 4.75~5.25 Vdc 0 ~ 5 Vdc (L activ) - Ratings (GND) 690Vrm s (5m Arm s ) ELECTRICAL CHARACTERISTICS : Conditions Parameters Output Current Output Current Input Current Frequency Open Circuit Voltage No Load Shotdown Symbols Iout Iout Iin F Vopen Ts d Vin (V) 5±0.25 5±0.25 5±0.25 5±0.25 5.0 5±0.25 Vbr (V) 0.0 5.0 0.0 0.0 0.0 0.0 Tu (°C) -30 -30 -30 -30 -30 -30 ~ +70 ~ +70 ~ +70 ~ +70 ~ +70 ~ +70 Min. 4.5 50 2.200 Specification Typ. 5.0 10 0.7 60 2.400 1.0 Max. 5.5 1.1 70 2.700 Unit m Arm s % Adc kHz Vrm s s ec Note Dut y 100 % witho ut lo ad Note 1 : Note 2: Please keep minimum of 2mm clearance (all directions) between inverter high voltage area as marked on mechanical drawing and any conductors. The external PWM frequency should be in a range of 100 ~ 500 Hz. For other frequency please request. The optimum is normally at 250 Hz, and minimizes the interference disturbances of the vertical sync. frequency. TEST CIRCUIT : Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page (2) Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Version 1.0.1, 6th October 2008 All specifications are subject to change without notice. DC-AC INVERTER UNIT PS-DA0151-02(S) (5 W SINGLE OUTPUT) ORDER KEY : PS-DA0151-02-x With order of this innverter please give the following key: -x W ithout Vrmt -A: W ith Vrmt by CN1 Pin5 (PRELIMINARY INFORMATION) Examples: PS-DA0151-01 (S) Inverter without Vrmt PS-DA0151-01-A (S) Inverter with Vrmt Power Systems – The Power Solution Web: Email: www.Power-Systems.de Info@Power-Systems.de Page (3) Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Version 1.0.1, 6th October 2008 All specifications are subject to change without notice.