SRS-2415-2

DC-DC Converter UNIT SR Series (0,5W TO 1W REGULATED DC-DC CONVERTER) FEATURES 1000VDC ISOLATION EFFICIENCY UP TO 72% INTERNAL SMD TECHNOLOGY LOW COST NO HEATSINK REQUIRED UP TO 1W REGULATED OUTPUT POWER DUAL IN LINE PACKAGE 100% BURNED IN MTBF > 2,000,000 HOURS OUTPUT SPECIFICATIONS Voltage Setpoint Accuracy Temperature Coefficient Ripple & Noise (20MHz BW) Line Regulation1 Load Regulation 2 INPUT SPECIFICATIONS +/-2% max +/-0.03%/ OC Input Voltage Range Input Filter +/-10% max Capacitor Type 100mVp-p max +/-0.5% max +/-0.5% max Current limit Protection Automatic GENERAL SPECIFICATIONS Efficiency Isolation Voltage 3 Short Circuit Protection Short Circuit Restart 50% min 1000 VDC min 9 10 ohms min 50 KHz min 80pF max 2,000,000 Hours 3.1g Typ Non-Conductive Plastic 22.6mm*9.9mm*8.4mm ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Cooling -25 OC to +71 OC -55 OC to +125 OC Free-Air Convection Isolation Resistance Switching Frequency Isolation Capacitance MTBF Weight ALL SPECIFICATIONS TYPICAL AT NOMINAL LINE, FULL LOAD , AND 25 O Case Material Case Size C UNLESS OTHERWISE NOTED. 1 2 3 High Line to Low Line. Load Regulation is for output load current change from 20% to 100%. For 60 seconds www.Power-Systems.de Page: 1 / 5 Version: 4-Oct-02 DC-DC Converter UNIT SR Series (0,5W TO 1W REGULATED DC-DC CONVERTER) SELECTION GUIDE 0.5W-1W OUTPUT MODEL NUMBER INPUT (VDC) 4.5-5.5 4.5-5.5 4.5-5.5 4.5-5.5 10.8-13.2 10.8-13.2 10.8-13.2 10.8-13.2 21.6-26.4 21.6-26.4 21.6-26.4 21.6-26.4 43.2-52.8 43.2-52.8 43.2-52.8 43.2-52.8 4.5-5.5 4.5-5.5 4.5-5.5 4.5-5.5 10.8-13.2 10.8-13.2 10.8-13.2 10.8-13.2 21.6-26.4 21.6-26.4 21.6-26.4 21.6-26.4 43.2-52.8 43.2-52.8 43.2-52.8 43.2-52.8 OUTPUT (VDC) 5 9 12 15 5 9 12 15 5 9 12 15 5 9 12 15 5 9 12 15 5 9 12 15 5 9 12 15 5 9 12 15 OUTPUT (mA) 100 56 42 34 100 56 42 34 100 56 42 34 100 56 42 34 200 111 84 67 200 111 84 67 200 111 84 67 200 111 84 67 INPUT CURRENT(mA) EFF ISOLATION FULL LOAD NO LOAD 12 11 11 37 7 5 5 5 4 3 9 3 2 2 2 2 23 22 22 21 12 13 11 11 7 6 6 6 4 3 3 3 62 57 62 58 67 63 65 65 65 65 58 70 58 58 65 65 62 60 62 62 67 62 64 64 68 65 70 70 70 70 72 72 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 1000 OUTPUT POWER (Watt) 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 0.5W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W 1W VOLTAGE VOLTAGE CURRENT (%) (VDC) SRS-0505-1 SRS-0509-1 SRS-0512-1 SRS-0515-1 SRS-1205-1 SRS-1209-1 SRS-1212-1 SRS-1215-1 SRS-2405-1 SRS-2409-1 SRS-2412-1 SRS-2415-1 SRS-4805-1 SRS-4809-1 SRS-4812-1 SRS-4815-1 SRS-0505-2 SRS-0509-2 SRS-0512-2 SRS-0515-2 SRS-1205-2 SRS-1209-2 SRS-1212-2 SRS-1215-2 SRS-2405-2 SRS-2409-2 SRS-2412-2 SRS-2415-2 SRS-4805-2 SRS-4809-2 SRS-4812-2 SRS-4815-2 161 175 161 173 62 66 64 64 32 32 36 30 18 18 16 16 322 333 322 322 124 134 130 130 61 64 60 60 30 30 29 29 www.Power-Systems.de Page: 2 / 5 Version: 4-Oct-02 DC-DC Converter UNIT SR Series (0,5W TO 1W REGULATED DC-DC CONVERTER) MECHANICAL DIMENSIONS & RECOMMENDED FOOTPRINT DETAILS PIN 1 & 16 6 & 11 7 & 10 8&9 SINGLE +Vin -Vout +Vout -Vin www.Power-Systems.de Page: 3 / 5 Version: 4-Oct-02 DC-DC Converter UNIT SR Series (0,5W TO 1W REGULATED DC-DC CONVERTER) SIMPLIFIED SCHEMATIC TYPICAL APPLICATIONS INPUT +Vout +Vin +Vout +Vin OSCILLATOR DRIVER REGULATOR OUTPUT -Vin -Vout DC-DC CONVERTER -Vin -Vout LOAD TYPICAL PERFORMANCE CUREVES DERATING CURVE 1.2 EFFICIENCY VS LOAD EFFICIENCY(%) 70 100 OUTPUT POWER(W) 0.9 0.6 0.3 0.0 -25 0 25 50 80.0 60.0 40.0 20.0 0.0 0 20 40 60 80 100 SAFE OPERATING AREA TA(degree C) % OF RATED LOAD(%) SR SERIES APPLICATION NOTES: EXTERNAL CAPACITANCE REQUIREMENTS: No external capacitance is required for operation of the SR series. To meet the reflected ripple requirements of the converter, an input impedance of less than 0.5 ohm from DC to 250KHz is required. External output capacitance is not required for operation, however it is recommended that 10uF tantalum and 0.1uF ceramic capacitance be selected for reduced system noise. Additional output capacitance may be added for increased filtering, but should not exceed 100uF. www.Power-Systems.de Page: 4 / 5 Version: 4-Oct-02 DC-DC Converter UNIT SR Series (0,5W TO 1W REGULATED DC-DC CONVERTER) Negative Outputs: A negative output voltage may be obtained by connecting the +OUT to circuit ground and connecting –OUT as the negative output. FOR MORE INFORMATION CALL: Power Systems – The Power Solution 74360 Ilsfeld-Auenstein ( Germany ) Dörnet 8 E-mail: Info@Power-Systems.de Tel: + 49 / 70 62 / 67 59 – 6 Fax: + 49 / 70 62 / 67 59 -80 Home Page: www.Power-Systems.de www.Power-Systems.de Page: 5 / 5 Version: 4-Oct-02