2SP0320T2C0-12

2SP0320T2Cx-12 2SP0320T2Cx-12 Preliminary Data Sheet Compact, high-performance, plug-and-play dual-channel IGBT driver based on SCALE™-2 technology for individual and parallel-connected modules in 2-level, 3-level and multilevel converter topologies Abstract The SCALE™-2 plug-and-play driver 2SP0320T2Cx-12 is a compact dual-channel intelligent gate driver designed for 1200V IGBT modules from Danfoss, Fuji or Infineon. The driver features an electrical interface with a built-in DC/DC power supply. The turn-on and turn-off gate resistors of both channels are not assembled in order to provide maximum flexibility. They must be assembled by the user before start of operation. Please refer to the paragraph on “Gate Resistor Assembly” for the recommended gate resistors. For drivers adapted to other types of high-power and high-voltage IGBT modules, refer to www.IGBT-Driver.com/go/plug-and-play Features Applications  Plug-and-play solution  Allows parallel connection of IGBT modules  For 2-level, 3-level and multilevel topologies  Shortens application development time  Extremely reliable; long service life  Built-in DC/DC power supply  20-pin flat cable interface  Duty cycle 0... 100%  Active clamping of V at turn-off  IGBT short-circuit protection  Monitoring of supply voltage  Safe isolation to EN 50178  UL compliant  Suitable for 1200V IGBT modules  Gate resistors not assembled ce www.IGBT-Driver.com  Wind-power converters  Industrial drives  UPS  Power-factor correctors  Traction  Railroad power supplies  Welding  SMPS  Radiology and laser technology  Research  and many others  Page 1 2SP0320T2Cx-12 Preliminary Data Sheet Safety Notice! The data contained in this data sheet is intended exclusively for technically trained staff. Handling all highvoltage equipment involves risk to life. Strict compliance with the respective safety regulations is mandatory! Any handling of electronic devices is subject to the general specifications for protecting electrostatic-sensitive devices according to international standard IEC 60747-1, Chapter IX or European standard EN 100015 (i.e. the workplace, tools, etc. must comply with these standards). Otherwise, this product may be damaged. Important Product Documentation This data sheet contains only product-specific data. For a detailed description, must-read application notes and common data that apply to the whole series, please refer to “Description & Application Manual for 2SP0320T SCALE-2 IGBT Drivers” on www.IGBT-Driver.com/go/2SP0320. The gate resistors on this gate driver are not assembled in order to provide maximum flexibility. For the gate resistors required for specific IGBT modules, refer to the paragraph on “Gate Resistor Assembly”. Use of gate resistors other than those specified may result in failure. Mechanical Dimensions Dimensions: See the relevant “Description and Application Manual” Mounting principle: Connected to IGBT module with screws Absolute Maximum Ratings Parameter Remarks Min Supply voltage V DC Supply voltage V CC Logic input and output voltages SO x current Gate peak current I out Average supply current I DC Output power per gate Turn-on gate resistance Turn-off gate resistance Switching frequency F Test voltage (50Hz/1min.) VDC to GND VCC to GND (Note 1) To GND Fault condition, total current Note 2 Note 16 Ambient temperature