EB01-FS150R17KE3G
Data Sheet EB01-FS150R17KE3G
Basic Board for Infineon EconoPACK+
Modules FS150R17KE3G
Abstract
The EB01-FS150R17KE3G is a basic board to be used with six-channel driver 6SD312EI
for reliable driving and safe operation of Infineon IGBT modules FS150R17KE3G.
The basic board EB01-FS150R17KE3G (with driver 6SD312EI) is fully matched to IGBT
module FS150R17KE3G. Its plug-and-play capability makes it ready to operate
immediately after mounting. The user needs invest no effort in designing or adjusting it
to a specific application.
Product Highlights
Plug-and-play solution
Suitable for FS150R17KE3G
No electrolytic capacitors
Extremely reliable; long service life
Shortens application development time
IGBT-Driver.com
Applications
Three-phase inverters
Motor drives
UPS
Power-factor correctors
Wind-power converters
Welding
SMPS
and many others
Page 1
EB01-FS150R17KE3G
Basic Board Data Sheet
Important: Please refer to the relevant manuals!
This data sheet contains only product-specific data for the basic board.
Information specific to the relevant driver can be found in the
corresponding data sheet.
A detailed description, must-read application notes and general data
applicable to this driver family are found in: “Description and Application
Manual, Six-Channel Driver 6SD312EI for the EconoPACK+ Modules ”.
Dimensions
Dimensions: 162 x 100 mm.
Height including driver: 21 mm (30 mm with connector X1 and flat cable).
Mounting principle: soldered onto an EconoPACK+ IGBT module FS150R17KE3G.
Absolute Maximum Ratings
Parameter
Remarks
Input power per channel
Switching frequency
DC link voltage
Operating temperature
Storage temperature
Note 1
Note 2
Note 3
Min Max
Units
3
57
1200
-40 +85
-40 +90
W
kHz
V
°C
°C
All data refer to +25°C unless otherwise specified
Page 2
CT-Concept.com
EB01-FS150R17KE3G
Basic Board Data Sheet
Electrical Characteristics
Short-circuit protection
Remarks
V ce -monitoring threshold
Response time
Betw. aux. terminals
Gate output
Remarks
Min Typ. Max
Units
3.65
11.3
V
µs
Min Typ. Max
Units
9.1
10
Ω
Ω
Min Typ. Max
Units
Note 4
Turn-on gate resistor R g(on)
Turn-off gate resistor R g(off)
Electrical insulation
Test conditions
Creep path between channels
9
mm
All data refer to +25°C unless otherwise specified
Footnotes to the key data
1)
2)
3)
4)
The input power is limited by the on-board gate resistors.
If the specified max. switching frequency is exceeded, the gate resistors may overheat.
This limit is due to active clamping. Refer to the “Description and Application Manual, Six-Channel
Driver 6SD312EI for the EconoPACK+ Modules”.
Pulse width of the direct output of the gate drive unit (excluding the gate-resistor delay).
IGBT-Driver.com
Page 3
EB01-FS150R17KE3G
Basic Board Data Sheet
Important Notice
The data contained in this product data sheet is intended exclusively for technically
trained staff. Handling all high-voltage equipment involves risk to life. Strict compliance
with the respective safety regulations is mandatory!
Any handling of electronic devices is subject to the general specifications for protecting
electrostatic-sensitive devices according to international standard IEC 747-1, Chapter IX
or European standard EN 100015 (i.e. the workplace, tools, etc. must comply with
these standards). Otherwise, this product may be damaged.
Disclaimer
This data sheet specifies devices but cannot promise to deliver any specific
characteristics. No warranty or guarantee is given – either expressly or implicitly –
regarding delivery, performance or suitability.
CT-Concept Technology AG reserves the right to make modifications to its technical
data and product specifications at any time without prior notice. The general terms and
conditions of delivery of CT-Concept Technology AG apply.
Page 4
CT-Concept.com
EB01-FS150R17KE3G
Basic Board Data Sheet
Ordering Information
The general terms and conditions of delivery of CT-Concept Technologie AG apply.
Related IGBT
CONCEPT Driver Type #
Infineon (eupec) FS150R17KE3G
6SD312EI
Connection
CONCEPT Modular Cable Type #
6SD312EI to EB01-FS150R17KE3G
MIC01A (6 items per driver)
Related IGBT
CONCEPT Basic Board Type #
Infineon (eupec) FS150R17KE3G
EB01-FS150R17KE3G
Information about Other Products
For drivers adapted to other high-voltage or high-power IGBT modules
Direct link: www.IGBT-Driver.com/go/plug-and-play
For other drivers and evaluation systems
Please click: www.IGBT-Driver.com
© Manufacturer
CT-Concept Technologie AG
Intelligent Power Electronics
Renferstrasse 15
CH-2504 Biel-Bienne
Switzerland
Tel.
Fax
+41 - 32 - 344 47 47
+41 - 32 - 344 47 40
E-mail
Internet
Info@IGBT-Driver.com
www.IGBT-Driver.com
Copyright 1998…2007 by CT-Concept Technologie AG - Switzerland.
We reserve the right to make any technical modifications without prior notice.
IGBT-Driver.com
All rights reserved.
Version of 2016-05-20
Page 5
很抱歉,暂时无法提供与“EB01-FS150R17KE3G”相匹配的价格&库存,您可以联系我们找货
免费人工找货