PP0800SA

05081 PP0640SA thru PP3500SC THYRISTOR SURGE SUPPRESSOR APPLICATIONS ✔ T1/E1 Trunk & Line Card ✔ SLIC Line Card ✔ DBX Branch Exchange Switches ✔ FCC Part 68 Customer Premise Equipment ✔ Line Interface Modem ✔ xDSL Architecture Interface ✔ ISDN Architecture Interface IEC COMPATIBILITY ( EN61000-4) ✔ 61000-4-2 (ESD): Air - 15kV, Contact - 8kV ✔ 61000-4-4 (EFT): 40A - 5/50ns ✔ 61000-4-5 (Surge): 8/20µs - 95A, L4(Line-Gnd), 48A, L4(Line-Line) & 83A, L2(Power) DO-214AA DEVICE SYMBOL (BIDIRECTIONAL) FEATURES ✔ Complies with: FCC Part 68, UL 1459, Bellcore 1089, ITU-K.20 & K.21 ✔ UL File Recognition # E208219 ✔ Peak Off-State Voltage from 25 to 300 Volts ✔ Surge Current Capability (See Table 1) ✔ ESD Protection > 40 kilovolts ✔ Low Capacitance for T1/E1 Trunk & Line Card Applications ✔ Bidirectional Configurations ✔ RoHS Compliant MECHANICAL CHARACTERISTICS ✔ Molded Plastic DO-214AA Package ✔ Weight 2.5 grams (Approximate) ✔ Available in Lead-Free Pure-Tin Plating(Annealed) ✔ Solder Reflow Temperature: Pure-Tin - Sn, 100: 260-270°C ✔ Leaded Device Availability ✔ Flammability Rating UL 94V-0 ✔ 12mm Tape and Reel Per EIA Standard 481 ✔ Marking: Logo & Marking Code TABLE 1 - SURGE RATINGS SERIES IPP 2 X 10µs AMPS 150 300 500 IPP 8 X 20µs AMPS 150 300 400 IPP IPP IPP 10 X 160µs 10 X 560µs 10 X 1000µs AMPS AMPS AMPS 100 150 200 50 100 200 50 80 100 ITSM 60 Hz AMPS 20 32 60 di/dt dv/dt AMPS/µs V/µs (See Note 1) (See Note 1) 500 500 500 2000 2000 2000 SA SB SC Note 1: Critital Rate of Rise for On-State Current (di/dt) and Off-State Voltage (dv/dt). 05081.R10 2/07 1 www.protekdevices.com PP0640SA thru PP3500SC DEVICE CHARACTERISTICS MAXIMUM RATINGS @ 25°C Unless Otherwise Specified PARAMETER Surge Current - 50/60 Hz Junction Temperature Storage Temperature Thermal Resistance (Junction) - SA & SB Series Thermal Resistance (Junction) - SC Series Thermal Resistance (Ambient) - SA & SB Series Thermal Resistance (Ambient) - SC Series SYMBOL ITSM TA TSTG RQJC RQJC RQJA RQJA VALUE 60 -40 to 150 -55 to 150 28 26 90 85 UNITS Watts °C °C °C/Watt °C/Watt °C/Watt °C/Watt ELECTRICAL CHARACTERISTICS PER LINE PART NUMBER DEVICE MARKING CODE REPETITIVE PEAK OFF-STATE VOLTAGE SWITCHING VOLTAGE MINIMUM HOLDING CURRENT (See Fig. 7) di/dt = 1A/ms IH mA 150 150 150 150 150 150 150 150 150 150 150 50 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 150 @ 25°C Unless Otherwise Specified MAXIMUM OFF-STATE CURRENT (See Fig. 4) @VDRM IDRM µA 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 MAXIMUM ON-STATE VOLTAGE (See Fig. 5) @IT VT VOLTS 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 ON-STATE CURRENT TYPICAL CAPACITANCE (See Note 1) SWITCHING CURRENT VDRM VOLTS PP0640SA PP0720SA PP0800SA PP1100SA PP1300SA PP1500SA PP1800SA PP2300SA PP2600SA PP3100SA PP3500SA PP0300SB PP0640SB PP0720SB PP0800SB PP1100SB PP1300SB PP1500SB PP1800SB PP2300SB PP2600SB PP3100SB PP3500SB PP0640SC PP0720SC PP0800SC PP1100SC PP1300SC PP1500SC PP1800SC PP2300SC PP2600SC PP3100SC PP3500SC GC GD GE GF GG GH GI GJ GK GL GM GN GP GQ GR GS GT GU GV GW GX GY GZ HC HD HE HF HG HH HI HJ HK HL HM 58 65 75 90 120 140 160 190 220 275 300 25 58 65 75 90 120 140 160 190 220 275 300 58 65 75 90 120 140 160 190 220 275 300 @100V/µs VS VOLTS 77 88 98 130 160 180 220 260 300 350 400 40 77 88 98 130 160 180 220 260 300 350 400 77 88 98 130 160 180 220 260 300 350 400 IS mA 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 800 IT AMPS 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 2.2 @2V, 1 MHz C pF 60 60 60 60 40 40 40 30 30 30 30 110 60 60 60 60 40 40 40 30 30 30 30 120 120 120 120 80 80 80 60 60 60 60 Note 1: Capacitance imbalance between positive and negative polarities is typically < 15pF. 05081.R10 2/07 2 www.protekdevices.com PP0640SA thru PP3500SC GRAPHS FIGURE 1 PULSE WAVE FORM tf TEST WAVEFORM PARAMETERS tf = 10µs td = 1,000µs td = t I /2 PP 50 IDRM VT e-t 0 0 1 t - Time - µs 2 3 VDRM 100 IPP - Peak Pulse Current - % of IPP FIGURE 2 V-I CHARACTERISTIC CURVE IPP ITSM IT IS IH VS Peak Value IPP Non-Repetitive On-State Current (ITSM) - Amps 100 FIGURE 3 ON-STATE CURRENT VS SURGE CURRENT DURATION PPxxxxSA PPxxxxSC PPxxxxSB 10 1 1 10 100 Surge Current Duration - Full Cycles Supply Frequency - 60 Hz Sinusoidal 1,000 05081.R10 2/07 3 www.protekdevices.com PP0640SA thru PP3500SC GRAPHS 10 FIGURE 4 TYPICAL PEAK OFF-STATE CURRENT VS JUNCTION TEMPERATURE 100 FIGURE 5 TYPICAL ON-STATE CURRENT VS ON-STATE VOLTAGE IDRM - Peak Off-State Current - µA 1 IT - On-State Current - A 10 0.1 0.01 -40 0 40 80 tA- Temperature - °C 120 1 0 1 2 3 4 VT - On-State Voltage - V 5 6 7 FIGURE 6 TYPICAL NORMALIZED SWITCHING VOLTAGE VS JUNCTION TEMPERATURE 1.15 1.1 1.05 Normalized VS Normalized IH FIGURE 7 TYPICAL NORMALIZED HOLDING CURRENT VS JUNCTION TEMPERATURE 2.5 2 1 0.95 0.9 1.5 1 0.5 0.85 0.8 -40 0 -40 0 40 80 tA- Temperature - °C 120 0 40 80 tA- Temperature - °C 120 05081.R10 2/07 4 www.protekdevices.com PP0640SA thru PP3500SC APPLICATION NOTE FIGURE 1: UL 1459 & FCC Part 68 - Metallic Protection The TSS (Thyristor Surge Suppressor) device is located across the tip-to-ring after a limiting resistor and fuse combination. RTIP and RRING resistors are optional depending upon the TSS device selection. Without the resistors, the PP3100SB/SC is recommended. However, with a resistance value of 7.5 Ohms for tip and ring, the PP3100SA is recommended. Digital signals may use a lower TSS device depending upon the total tip to ring voltage range. Selection of the TSS device, either PPxxxxSA or SB/SC is based upon the value of the tip and ring resistors. For the National Electric Code (NEC) article 800, it is recommended that at least one fuse be used in the tip or ring line for metallic surges. Fuses may be replaced with a suitable Positive Temperature Coefficient (PTC) automatic resettable current limiting device. TIP Fuse RTip To Protected Equipment RRing RING FIGURE 1 - Metallic Protection R TIP Tip FIGURE 2 - UL 1459 & FCC Part 68 - Longitudinal Protection There are two TSS devices, one located from tip-to-ground and one ring-to-ground. For standard analog signals, the PP3100SA is recommended with a typical resistor value for tip and ring of 15 Ohms. The PP3100SB/SC is recommended for resistor values of 7.5 Ohms each. The National Electric Code (NEC) article 800 requires two fuse elements when connecting to ground. Fuses or a suitable Positive Temperature Coefficient (PTC) automatic resettable current limiting device may be used. The purpose of this circuit is to limit AC power current from getting on the ground line causing any safety hazard. To Protected Equipment R RING Ring FIGURE 2 - Longitudinal Protection FIGURE 3 - UL 1459 & FCC Part 68 - Metallic & Longitudinal Protection Three equal TSS devices are used in this application for metallic (tipto-ring) and longitudinal (tip-to-ground and ring-to-ground) protection. For analog signals, the PP3100SB/SC is recommended. With a resistance value of 15 Ohms for the tip and ring resistors, the PP3100SA may be used. The National Electric Code (NEC) article 800 requires two fuse elements when connecting to ground. Fuses or a suitable Positive Temperature Coefficient (PTC) automatic resettable current limiting device may be used. This circuit is recommended for protection against the Bellcore requirement: First Level Lightning Surge Tests (Telecommunications Port), document # GR-1089-CORE. R TIP Tip To Protected Equipment R RING Ring FIGURE 3 - Metallic & Longitudinal Protection 05081.R10 2/07 5 www.protekdevices.com PP0640SA thru PP3500SC DO-214AA PACKAGE OUTLINE & DIMENSIONS PACKAGE OUTLINE DO-214AA (SMB) A B DIM A B C D E F G H NOTES DIMENSIONS MILLIMETERS MIN MAX 1.96 3.30 4.06 2.00 0.76 5.21 0.10 0.15 2.21 3.94 4.57 2.50 1.52 5.59 0.20 0.31 INCHES MIN MAX 0.077 0.130 0.160 0.079 0.030 0.205 0.004 0.006 0.087 0.155 0.180 0.098 0.060 0.220 0.008 0.012 C H D G E F 1. Dimensions are exclusive of mold flash and metal burrs. TAPE & REEL ORDERING NOMENCLATURE 1. Surface mount product is taped and reeled in accordance with EIA-481. 2. Suffix-T = 13 Inch Reel - 3,000 pieces per 12mm tape, i.e., PP0640SA-T. 3. Suffix - LF = Lead-Free, Pure-Tin Plating, .e., PP0640SA-LF-T. Outline & Dimensions: Rev 0 - 4/02, 06030 COPYRIGHT © ProTek Devices 2007 SPECIFICATIONS: ProTek reserves the right to change the electrical and or mechanical characteristics described herein without notice (except JEDEC). DESIGN CHANGES: ProTek reserves the right to discontinue product lines without notice, and that the final judgement concerning selection and specifications is the buyer’s and that in furnishing engineering and technical assistance, ProTek assumes no responsibility with respect to the selection or specifications of such products. ProTek Devices 2929 South Fair Lane, Tempe, AZ 85282 Tel: 602-431-8101 Fax: 602-431-2288 E-Mail: sales@protekdevices.com Web Site: www.protekdevices.com www.protekdevices.com 05081.R10 2/07 6