QPDD10-48S05

Qualtek 10Watts DC-DC Single Output P P C Electronics Corporation QPDD10-48S Series Features: Approved to IEC/EN60950, UL60950 Safety Standards Wide Input Voltage: 36VDC - 75VDC Single Outputs: 3.3VDC, 5VDC, 12VDC, 15VDC Trim Function; Remote Control No Minimum Load Requirement Model QPDD10-48S3V3 QPDD10-48S05 QPDD10-48S12 QPDD10-48S15 Output Characteristics DC Output 3.3V 5V 12V 15V Rated Current 3A 2A 0.83A 0.67A Current Range 0~3A 0~2A 0~0.83A 0~0.67A Efficiency (Typical) 77% 81% 83% 84% Ripple and Noise (max) 100mVpp Voltage Adjust. 90% to 110% Vout Voltage Accuracy ±1.0% Line Regulation (max) 0.2% Load Regulation (max) 0.5% Temperature Coefficient ±0.02%/°C Input Characteristics Voltage Range 36VDC~75VDC Normal Voltage 48VDC Remote Control Control Postive Logic HIGH=ON (3.5VDC to 10VDC); LOW=OFF (-0.7VDC to 0.8VDC) Voltage Negative Logic LOW=ON (-0.7VDC to 0.8VDC); HIGH=OFF (3.5VDC to 10VDC) Control Positive Logic 2mA max. Current Negative Logic 4mA max. Protection Over Current Continuous, auto recovery (3.3V, 5V) Short Circuit >120% output current, auto recovery (3.3V, 5V) Environmental Characteristics Operating Amb. Temp. -40°C~55°C Operating Case Temp. -40°C~100°C Storage Temp. -55°C~125°C Safety Standards IEC/EN60950, UL60950 Isolation Voltage (one minute) Input-Output: 1500VDC. Input-Case: 1500VDC. Output-Case: 1500VDC General Characteristics MTBF More than 2,000,000Hrs Dimension (LxWxH) 50.8x25.4x10.16mm (2”x1”x0.4”) Pin Assignment 50.8 [2.000] 20.32 [0.800] 5 2 20.32 [0.800] 1 6 3 +0.05 6- 1.0 -0.10 36 [1.417] L 1.2 [0.047] 0.5 [0.020] Pin No. 1 2 3 4 5 6 Output +Vin -Vin CNT +Vout TRIM COM Pin Length: 3.8mm 10.16 [0.400] 25.4 [1.000] 5.08 [0.200] 4 Unit: mm[inch] TOLERANCES: X.Xmm = ±0.5mm X.XXmm = ±0.25mm Page 1 of 1