QPDS15-48S05

Qualtek 15Watts DC-DC Single Output P QPDS15-48S Series P C Electronics Corporation Features: Approved to IEC/EN60950, UL60950 Safety Standards Wide Input Voltage: 36VDC - 75VDC Single Outputs: 3.3VDC, 5VDC, 12VDC, 15VDC Remote Control No Minimum Load Requirement Model QPDS15-48S3V3 QPDS15-48S05 QPDS15-48S12 QPDS15-48S15 Output Characteristics DC Output 3.3V 5V 12V 15V Rated Current 3.5A 3A 1.25A 1A Current Range 0~3.5A 0~3A 0~1.25A 0~1A Efficiency (Typical) 78% 82% 84% 85% Ripple and Noise (max) 60mVpp Voltage Accuracy ±1.0% Line Regulation (max) 10mV Load Regulation (max) 25mV Temperature Coefficient ±0.02%/°C Input Characteristics Voltage Range 36VDC~75VDC Normal Voltage 48VDC Under-Voltage Shutdown 32VDC~34VDC Remote Control Control Voltage (Positive Logic) HIGH=ON (3.5VDC to 12VDC); LOW=OFF (-0.7VDC to 0.6VDC) Control Current (Positive Logic) 2mA max. Protection Over Current Continuous, auto recovery (3.3V, 5V) Short Circuit >120% output current, auto recovery (3.3V, 5V) Environmental Characteristics Operating Amb. Temp. -40°C~55°C Operating Case Temp. -40°C~100°C Storage Temp. -55°C~125°C Safety Standards IEC/EN60950, UL60950 Isolation Voltage (one minute) Input-Output: 1500VDC. Input-Case: 1500VDC. Output-Case: 1500VDC General Characteristics MTBF More than 2,000,000Hrs Dimension (LxWxH) 41.9x37.1x10.16mm (1.65”x1.46”x0.4”) 41.9 [1.650] Pin Assignment 3.81 [0.150] 38.1 [1.500] +0.05 6- 1.0 -0.10 4 3.81 [0.150] 5 1 3 5.83 [0.230] 11.95 [0.470] 2 7.62 [0.300] 10.16 [0.400] 7.62 [0.300] 6 3 10.16 [0.400] 37.1 [1.461] 1.27 [0.050] 6 2 1 5 4 + 0.05 6 - 1.3 - 0.10 Pin No. 1 2 3 4 5 6 Output +Vin -Vin CNT -Vout +Vout NC Pin Length: 3.8mm L TOLERANCES: X.Xmm = ±0.5mm X.XXmm = ±0.25mm Unit: mm[inch] Page 1 of 1