CO13

THROUGH HOLE CLOCK OSCILLATORS - TTL COMPATIBLE FEATURES STANDARD 8 AND 14 PIN DIP PACKAGE TOLERANCE AND STABILITY TO ± 25 PPM LOW COST AVAILABLE IN 3.3 VOLT SPECIFICATIONS SERIES PACKAGE FREQUENCY RANGE FREQUENCY STABILITY† CO1 14 PIN DIP 500.00 KHz TO 125.00 MHz CO1100 : ±100 ppm CO1050 : ±50 ppm CO1025 : ±25 ppm OPERATING TEMPERATURE RANGE STORAGE TEMPERATURE RANGE VOLTAGE†† INPUT 0° C TO +70° C STANDARD -40° C TO +85° C EXTENDED -55° C TO +125° C +5 VDC ±0.5 VDC 500.00 KHz TO 2.999 MHz: 30 mA CURRENT (MAX) 3.00 MHz TO 31.999 MHz: 50 mA 32.00 MHz TO 79.999 MHz: 70 mA 80.00 MHz TO 125.00 MHz: 80 mA SYMMETRY (AT 1.4 VDC LEVEL) 40 TO 60% NORMAL 45 TO 55% TIGHT UNDER 9 MHz : ±15 ns MAX RISE AND FALL TIME (0.4 - 2.4 VDC) 9 MHz TO 32 MHz : ±10 ns MAX 32 MHz TO 80 MHz : ±6 ns MAX 80 MHz TO 125 MHz : ±4 ns MAX LOGIC "0" LEVEL LOGIC "1" LEVEL LOAD††† +0.5 V MAX, SINK TO 16 mA +2.4 V MIN, SOURCE 0.4 mA 1 TO 10 TTL STANDARD SERIES CO1 AND CO13 CO13 8 PIN DIP 500.00 KHz TO 125.00 MHz CO13100 : ±100 ppm CO13050 : ±50 ppm CO13025 : ±25 ppm 0° C TO +70° C STANDARD -40° C TO +85° C EXTENDED -55° C TO +125° C +5 VDC ±0.5 VDC 500.00 KHz TO 2.999 MHz: 30 mA 3.00 MHz TO 31.999 MHz: 50 mA 32.00 MHz TO 79.999 MHz: 70 mA 80.00 MHz TO 125.00 MHz: 80 mA 40 TO 60% NORMAL 45 TO 55% TIGHT UNDER 9 MHz : ±15 ns MAX 9 MHz TO 32 MHz : ±10 ns MAX 32 MHz TO 80 MHz : ±6 ns MAX 80 MHz TO 125 MHz : ±4 ns MAX +0.5 V MAX, SINK TO 16 mA +2.4 V MIN, SOURCE 0.4 mA 1 TO 10 TTL STANDARD OUTPUT 35 † FREQUENCY STABILITY INCLUSIVE OF ROOM TOLERANCE , FREQUENCY ST ABILITY OVER TEMPERATURE, 10% POWER SUPPLY VARIATION, AGING, SHOCK, AND VIBRATION †† +3.3 VOLT VERSION IS AVAILABLE. CONSULT RALTRON FOR SPECIFICATIONS ††† OUTPUT LOADS ALSO AVAILABLE AT 15 pF, 30 pF AND 50 pF. CONSULT RALTRON FOR SPECIFICATIONS ENVIRONMENTAL AND TECHNICAL CONDITIONS ENVIRONMENTAL TEMPERATURE CYCLE SHOCK VIBRATION RESISTANCE TO SOLDERING HEAT HUMIDITY MIL-STD 883, METHOD 1010, 10 CYCLES -20° C TO 85° C MIL-STD-202, METHOD 213, TEST CONDITION C MIL-STD-202, METHOD 204, TEST CONDITION A MIL-STD-202, METHOD 210, TEST CONDITION B 85% RELATIVE HUMIDITY AT 85° C 250 HOURS MECHANICAL GROSS LEAK TEST FINE LEAK TEST TERMINAL STRENGTH MARKING INK MOISTURE RESISTANCE SOLDERABILITY SOLVENT RESISTANCE MIL-STD-883, METHOD 1014, TEST CONDITION C MIL-STD-883, METHOD 1014, TEST CONDITION A MIL-STD-202, METHOD 211, TEST CONDITION A AND C EPOXY, HEAT CURED. MIL-STD 202, METHOD 106, OMIT STEP 7B MIL-STD-202, METHOD 208, 95% COVERAGE MIL-STD-202, METHOD 2002, METHOD 215 OUTPUT WAVEFORM tf VCC tr "1" LEVEL +2.5 VDC +1.5 VDC "0" LEVEL 0 VDC +0.5 VDC t T PART NUMBERING SYSTEM S ERIES CO1 CO13 (14 PIN DIP) (8 PIN DIP) FREQUENCY STA B ILITY 100 050 025 ±100 PPM ± 50 PPM ± 25 PPM IN MHz FREQUENCY EXT EXTENDED TEMPERA TURE T TIGHT SY MMETRY SY MMETRY OPTIONS TR TA PE A ND REEL* GW GULL W ING 3.3 +3.3 V EXAMPLE: CO1100-20.000-EXT-T, CO13050-32.000-T-TR * Available for Gull Wing only Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A. Tel: 305-593-6033 Fax: 305-594-3973 e-mail: sales@raltron.com Internet: http://www.raltron.com THROUGH HOLE CLOCK OSCILLATORS-TTL COMPATIBLE SERIES CO1 AND CO13 TEST CIRCUIT .01µF + POWER SUPPLY +5 VDC A V .031 ± .003 0.79 ± .08 6.35 MIN .250 MIN FREQUENCY STANDARD R = SEE TABLE D FREQUENCY COUNTER OSCILLOSCOPE 14(8) VCC 8(5) OUT D D=1N914 OSCILLATOR N/C 1 GND 7(4) D D LOADS 10 5 2 1 RESISTANCE (R) 390 OHM 750 OHM 1800 OHM 3900 OHM C=15 pF MAX OUTLINE DRAWINGS CO1 PACKAGE (FULL SIZE 14 PIN DIP) Scale n one Di mensi on in mm inch CO13 PACKAGE (HALF SIZE 8 PIN DIP) Scale none Di mensi on in mm inch COLORED DOT INDICATES PIN 1 LOCATION MARKING AREA MARKING AREA 36 COLORED DOT INDICATES PIN 1 LOCATION 5.08 MAX .200 MAX 5.08 MAX .018 ± .003 DIA .200 MAX 0.46 ± .08 DIA PIN 1 15.24 ± .13 .600 ± .005 7.62 ± .13 .300 ± .005 PIN 1 PIN 4 PIN 7 13.20 MAX .519 MAX .300 ± .005 7.62 ± .13 4.57 .180 .300 ± .005 13.21 MAX PIN 8 13.21 MAX .520 MAX PIN 5 7.62 ± .13 PIN 14 12.19 .480 20.80 MAX PIN 8 .819 MAX PIN CONNECTION PIN 1 7 8 14 FUNCTION N/C GROUND OUTPUT VCC PIN CONNECTION NOTE: PIN 7 IS INTERNAL TO HEADER PIN 1 4 5 8 FUNCTION N/C GROUND OUTPUT VCC NOTE: PIN 4 IS INTERNAL TO HEADER PACKAGING 14 PIN DIP: 25 PIECES PER ELECTROSTATIC TUBE 8 PIN DIP: 40 PIECES PER ELECTROSTATIC TUBE Raltron Electronics Corporation 10651 NW 19th St. Miami, Florida 33172 U.S.A. Tel: 305-593-6033 Fax: 305-594-3973 e-mail: sales@raltron.com Internet: http://www.raltron.com .520 MAX 6.35 MAX .250 MAX 0.46 ± .08 DIA .018 ± .003 DIA .031 ± .003 0.79 ± .08