RQRA-0433-0484

RQR VCO SERIES Page 1 of 4 RQRA-0433-0484 ELECTRICAL SPECIFICATIONS PARAMETER CONDITION SYMBOL VALUE Lower Frequency 1.2 Tuning Voltage:0.5V fo(Vt) Upper Frequency 1.2 Tuning Voltage:9.5V fo(Vt) 484 Tuning Voltage Vt 0.5 Supply Voltage Vcc 4.75 Min. Typ. Tuning Sensitivity Max. 433 MHz MHz 5.0 Supply Current Maximum to Minimum ratio UNIT df/dVt 9.5 V 5.25 V 30 mA 1.5 - Tuning Sensitivity Over 433-484MHz df/dVt Pushing Over Supply Variation 5V±5% df/dVcc 7.0 200 MHz/V KHz Pulling 1.3 VSWR= Load=2:1 All phase df/dZl 200 KHz Operating Temperature Ta -30 85 °C Storage Temperature Tstor -45 105 °C 8.0 V Maximum Voltage Vcc(abs) Moisture Sensitivity Level MSL JEDEC J-STD-2 HBM Human body model JESD22-A114 Termination Finish 1 Glass-reinforced laminate base and nickel-silver cover ESD Sensitivity kV 3 OUTPUT CHARACTERISTICS SINE-WAVE VALUE PARAMETER SYMBOL Output Power Pw 2nd Harmonic Suppression 3nd Harmonic Suppression Spurious (Non-Harmonic) Output Load 2 h 3 h Sp CONDITION Min Typ. Max UNIT 2.0 5.5 8.0 dBm Output termination 50 Vcc=5V ±5% -30 dBc -30 dBc -f ≤4.0KHz -60 -f >4.0KHz -100 OCL dBc 50 rd R A L T R O N E L E C T R O N I C S  1 0 4 0 0 N .W . 3 3 S t r e e t  M i a m i , F l o r i d a 3 3 1 7 2  U . S . A . Telephone: +1-305-593-6033  Fax:1+ 305-594-3973  e-mail: sales@raltron.com  web: www.raltron.com Ω RQR VCO SERIES Page 2 of 4 RQRA-0433-0484 PHASE NOISE VALUE PARAMETER SSB Phase noise @ offset frequency over 0 to 55 °C SYMBOL CONDITION Min Typ Max f=1.0kHz -90 -89 f=12.5kHz -114 -113 f=25kHz -125 -120 f=50kHz -128 -127 f=100kHz -140 -138 f=200kHz -143 -140 f=500kHz -147 -145 f=1.0MHz -150 -145 f=>5MHz -165 -160 UNIT  f) dBc/Hz  rd R A L T R O N E L E C T R O N I C S  1 0 4 0 0 N .W . 3 3 S t r e e t  M i a m i , F l o r i d a 3 3 1 7 2  U . S . A . Telephone: +1-305-593-6033  Fax:1+ 305-594-3973  e-mail: sales@raltron.com  web: www.raltron.com RQR VCO SERIES Page 3 of 4 RQRA-0433-0484 MECHANICAL DIMENSIONS AND PIN FUNCTIONING H-Max=  4.0 mm 0.157 inch Marking: RQRA 0433-0484  Date code Top View . rd R A L T R O N E L E C T R O N I C S  1 0 4 0 0 N .W . 3 3 S t r e e t  M i a m i , F l o r i d a 3 3 1 7 2  U . S . A . Telephone: +1-305-593-6033  Fax:1+ 305-594-3973  e-mail: sales@raltron.com  web: www.raltron.com RQR VCO SERIES Page 4 of 4 RQRA-0433-0484 COMMON SPECIFICATIONS 1.1 -Load impedance is 50 Ohms. 1.2- The frequency range is defined between the (max) lower frequency and (min) upper frequency. 1.3 -Pulling is measured with 12dB return loss, all phases. 1.4- Package outline tolerances are typ. ±0.38mm / ±0.015inch if not stated differently on the drawing. 1.5 -It is recommended to provide two bypass-capacitors (ceramic), from Vcc to Gnd, 1nF || 100pF. 1.6- Solder temperature (peak) is 260°C for 10-20s REFLOW PROFILE tP TP Critical Zone TL to TP Ramp-up TL tL TSMAX Temp. [°C] TSMIN Ramp-down tS Preheat Time [sec] t[25°C] to Peak Temperature Min Preheat Temperature Max Preheat Time (TSMIN to TSMAX) Temperature Peak Temperature Ramp-up rate Ramp-down rate Time within 5°C of Peak Temperature Time t[25°C] to Peak Temperature Time Recommended Solder Reflow Profile TSMIN TSMAX tS TL TP RUP RDOWN tP t[25°C] to Peak tL 150°C 175°C 60-180 sec. 217°C 260°C 3°C/sec max. 6°C/sec max. 10-20 sec max. 480 sec. 60-150 sec. APPROVALS Eng. approval, date: IM Created by, date: MH 02/02/2016 02/02/2016 Revision: A rd R A L T R O N E L E C T R O N I C S  1 0 4 0 0 N .W . 3 3 S t r e e t  M i a m i , F l o r i d a 3 3 1 7 2  U . S . A . Telephone: +1-305-593-6033  Fax:1+ 305-594-3973  e-mail: sales@raltron.com  web: www.raltron.com