VS2TRH

VCXO Page 1 of 2 REV B. VS2 SERIES: VCXO OSCILLATOR, HCMOS, +5.0 VDC, 7x5mm Package DESCRIPTION: A crystal controlled, high frequency, highly stable, voltage controlled oscillator, adhering to HCMOS Standards. The output can be Tri-stated to facilitate testing or combined multiple clocks. The device is contained in a sub-miniature, very low profile, leadless ceramic SMD package with 6 gold contact pads. This miniature oscillator is ideal for today's automated assembly environments. APPLICATIONS AND FEATURES: " Common Frequencies: 16.384 MHz; 19.44 MHz; 27 MHz; 38.88 MHz; 51.84 MHz; " +5.0 VDC HCMOS " Frequency Range from 1 to 51.84 MHz " Miniature Ceramic SMD Package Available on Tape and Reel " Lead Free ELECTRICAL PARAMETERS: PARAMETER Nominal Frequency Supply Voltage Supply Current MAX Output Logic Type Load Output Voltage Levels Duty Cycle Rise / Fall Time Jitter Overall Frequency Stability Control Voltage Range Settability Absolute Pull Range Input Impedance Modulation Bandwidth Pin 2 Output Enabled Output Disabled Voh Vol DC tr / tf J ∆f/fc VC Vfo APR Zin BW En Dis Vcc(abs) -3 dB High Voltage or No Connect Ground Non-Destructive Minimum guaranteed freq. pull over ∆f/fc Measured at 50% of Vcc Measured at 20/80% and 80/20% Vcc Levels RMS, Fj = 12 kHz…20 MHz Op. Temp., Aging, Load, Supply and Cal. Variations Positive slope; 10% linearity MAX Connected from output to ground SYMBOL fo Vcc Is TEST CONDITIONS*1 VALUE 1.000 ~ 51.840 +5.0 ±10% 35.0 HCMOS 15 0.9•Vcc MIN 0.1•Vcc MAX 40/60 to 60/40 or 45/55 to 55/45 6.0 MAX *2 1 TYP ±50 *4 $ UNIT MHz VDC mA pF VDC VDC % ns ps ppm VDC VDC *3 0 to +5.0 +2.5 ± 0.5 See Part Numbering 10 MIN 10 MIN 0.7•Vcc MIN 0.3•Vcc MAX -0.5…+7.0 ppm kΩ kHz VDC VDC VDC Absolute voltage range *1 Test Conditions Unless Stated Otherwise: Nominal Vcc, Nominal Load, +25 ±3°C *2 Frequency Dependent *3 Not All APR’s Available With All Temperature Ranges—Consult Factory For Availability *4 Tighter stabilities available at narrow temperature ranges—Consult Factory For Availability $ ENVIRONMENTAL PARAMETERS: PARAMETER SYMBOL Ta T(stg) TEMPERATURE RANGE (°C) R: 0…+50 S: 0…+70 U: -20…+70 V: -40…+85 APR (ppm) F: ±32 ppm H: ±50 ppm G: ±80 ppm J: ±100 ppm FREQUENCY (MHz) 1.000…51.840 TESTCONDITIONS*1 VALUE SEE PART NUMBER TABLE -55…+90 UNIT °C °C Operating temperature range Storage temperature range $ PART NUMBERING SYSTEM: SERIES SYMMETRY A: 40/60 to 60/40% T: 45/55 to 55/45% VS2: VCXO with HCMOS Output EXAMPLE: VS2ASH-38.880 VCXO Oscillator, 7x5mm Package, +5.0 VDC Supply Voltage, HCMOS Output, 40/60% Symmetry, 0…+70°C Operating Temperature Range, ±50 ppm APR, 38.880 MHz RALTRON ELECTRONICS CORP. ! 10651 N.W . 19 th St ! Miami, Florida 33172 ! U.S.A. phone: (305) 593-6033 ! fax: (305) 594-3973 ! e-mail: sales@raltron.com ! WEB: http://www.raltron.com Rev. X2, September 29, 2003; Approved: C. Husted VCXO Page 2 of 2 REV B. Consult the factory for any custom requirements. $ MECHANICAL PARAMETERS: INDICATES PIN 1. .276 ±.008 7.0 ±0.2 .200 5.08 .100 2.54 1 2 3 .197 ±.008 5.0 ±0.2 .079 MAX. 2.00 MAX. .079 TYP. 2.00 TYP. .087 2.20 .050 1.27 6 5 .055 TYP. 1.40 4 .071 1.80 .100 2.54 .150 3.81 SOLDER PATTERN *0.01µF external by-pass filter is recommended as shown on solder pattern. OUTLINE TOLERANCE: ±0.006” / 0.15mm (Unless otherwise specified) PIN FUNCTIONS: [1] VOLTAGE CONTROL [2] ENABLE/DISABLE [3] CASE GROUND [4] OUTPUT [5] NO CONNECT [6] SUPPLY VOLTAGE TYP. MARKING: VS2ASH 38.88 RAL D/C RALTRON ELECTRONICS CORP. ! 10651 N.W . 19 th St ! Miami, Florida 33172 ! U.S.A. phone: (305) 593-6033 ! fax: (305) 594-3973 ! e-mail: sales@raltron.com ! WEB: http://www.raltron.com Rev. X2, September 29, 2003; Approved: C. Husted