RCOB-700

• Low Cost 230VAC LED Power Supply • 350mA to 1050mA Output, 25-44VDC • Active Power Factor Correction >0.95 • Designed to drive 15W-46W COB LEDs • Terminal Block Input/Output with Cable Clamps • Fully Protected (OLP, SCP, OCP, OTP) • Suitable for Class I and Class II Luminaires Features LED Driver Description AC/DC Converter RCOB Constant 3 Current Active PFC Single Output 3Y These COB LED drivers are available with eleven preset output currents between 350mA and 1050mA. They are designed to drive COB (Chip On Board) high power LEDs with a forward voltage between 25V and 44VDC from a 230VAC supply (198-264VAC). They operate with efficiencies of up to 90%, feature active PFC and are fully protected against short circuit, output overvoltage, open-circuit and over-temperature conditions. The LED drivers are suitable for both independent and built-in installations and for installations inside furniture. wa EAR rranty Selection Guide Part Number Input Output Output Efficiency Rated Voltage Range Voltage Range Current typ. Power [VAC] [VDC] [mA] [%] [W] RCOB-350 198-264 25-44 350 87 15 RCOB-400 198-264 25-44 400 87 17 RCOB-450 198-264 25-44 450 88 20 RCOB-500 198-264 25-44 500 88 22 RCOB-550 198-264 25-44 550 88 24 RCOB-600 198-264 25-44 600 89 26 RCOB-650 198-264 25-44 650 89 28 RCOB-700 198-264 25-44 700 89 31 EN-61347-1 Compliant NOT RECOMMENDED FOR NEW DESIGNS RCOB-800 EN-61347-2-13 Compliant 198-264 25-44 800 90 35 RCOB-900 198-264 25-44 900 90 40 RCOB-1050 EN-55015 Compliant EN-61547 Compliant 198-264 25-44 1050 90 46 EN-61000-3-2 Compliant EN-61000-3-3 Compliant All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. Specifications (measured @ ta= 25°C, 230VAC and rated load) BASIC CHARACTERISTICS Parameter Condition Input Voltage Range Inrush Current Min. Typ. Max. 198VAC 230VAC 264VAC 10µs 8A Start-up Time 1s Input Frequency Range Power Factor 47Hz full load 63Hz 0.95 continued on next page www.recom-power.com REV.: 3/2016 L-1 RCOB AC/DC Converter Series Specifications (measured @ ta= 25°C, 230VAC and rated load) Efficiency vs. Output Voltage RCOB-500 Efficiency [%] 95 90 85 80 75 70 50 60 70 90 80 100 Output Voltage [%] REGULATIONS Parameter C ondition Output Current Accuracy Value includes: line, load and tolerance ±8% typ. PROTECTION Parameter Condition Value Input Fuse T1A, slow blow Short Circuit Protection (SCP) constant current limit at Inominal and recovers after fault condition is removed Over Load Protection (OLP) power limiting if forward voltage of LED’s is higher than 44VDC Output Over Voltage Protection (OVP) Zener clamp 56VDC max. Output Over Current Protection (OCP) constant current source Over Temperature Protection (OTP) automatic recovery after cool down Isolation Voltage 3kVAC / 1 minute L-N L,N-FG Surge Capacity 2kV 4kV Maximum loading of automatic circuit breakers* * @ 230VAC, 1Ohm, 90° phase angle and max. load Power ≥ 7W ≥ 15W ≥ 25W ≥ 35W ≥ 45W L-2 Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A B 61 100 121 150 C 121 164 221 291 B 35 57 69 85 C 57 87 109 134 B 24 38 46 58 C 38 62 74 92 B 18 30 35 43 C 29 46 55 69 B 17 28 33 41 C 24 39 47 57 REV.: 3/2016 www.recom-power.com RCOB DC/DC Converter Series Specifications (measured @ ta= 25°C, 230VAC and rated load) ENVIRONMENTAL Parameter Condition Value Operating Temperature Range -20°C to +50°C, Ambient RCOB-350 to -500 RCOB-550 to -700 RCOB-800 to -1050 RCOB-800 to -1050 RCOB-350 to -700 Max. Case Temperature Operating Humidity 80°C max. 85°C max. 90°C max. 45% to 85% RH 5% to 85% RH, non condensing IP Rating IP20 MTBF at Tc= 80°C Derating Graph 50 x 10 hours 3 Output Current [%] 100 80 60 40 20 0 -20 -10 0 10 20 30 40 50 60 Ambient Temperature [°C] SAFETY AND CERTIFICATIONS Certificate Type Standard Lamp Controlgear General Requirments for Safety Compliant Lamp Controlgear Particular Requirements RoHS EN61347-1 EN61347-2-13 RoHS 6/6 EMC Compliance Standard / Criterion Equipment for general Lighting Purpose EMC Immunity Requirements EN61547 Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment Limits of Harmonic Current Emissions Voltage Fluctuations and Flicker in Public Low-Voltage Systems