FMD1S

RECTRON SEMICONDUCTOR TECHNICAL SPECIFICATION FMD1S THRU FMD7S SINGLE-PHASE GLASS PASSIVATED MINI FAST RECOVERY SURFACE MOUNT BRIDGE RECTIFIER VOLTAGE RANGE 50 to 1000 Volts CURRENT 0.8 Ampere FEATURES * Surge overload rating - 30 amperes peak * Ideal for printed circuit board * Reliable low cost construction utilizing molded * Glass passivated device * Polarity symbols molded on body * Mounting position: Any * Weight: 0.5 gram MD-S MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in millimeters MAXIMUM RATINGS (At TA = 25oC unless otherwise noted) RATINGS Maximum Recurrent Peak Reverse Voltage Maximum RMS Bridge Input Voltage Maximum DC Blocking Voltage Maximum Average Forward Output Rectified Current T A = 3 0oC -on glass-epoxy P.C.B. ( NOTE 1 ) -on aluminum substrate ( NOTE 2 ) Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Typical Junction Capacitance ( Note3 ) Operating and Storage Temperature Range ELECTRICAL CHARACTERISTICS (At TA = 25oC unless otherwise noted) CHARACTERISTICS Maximum Forward Voltage Drop per Bridge Element at 0.4A DC Maximum Reverse Current at rated DC Blocking Voltage per element Maximum Reverse Recovery Time ( Note 4 ) @TA = 25 C @TA = 125oC IR trr 150 o SYMBOL VRRM VRMS VDC IO FMD1S 50 35 50 FMD2S 100 70 100 FMD3S 200 140 200 FMD4S 400 280 400 0.5 0.8 FMD5S 600 420 600 FMD6S 800 560 800 FMD7S 1000 700 1000 UNITS Volts Volts Volts Amp IFSM CJ TJ,TSTG SYMBOL VF FMD1S FMD2S 30 15 -55 to + 150 FMD3S FMD4S 1.30 10 100 250 500 FMD5S FMD6S FMD7S Amps pF 0 C UNITS Volts uAmps uAmps nSec 1998-8 NOTE: 1. On glass-epoxy P.C.B. mounted on 0.05 X 0.05” (1.3 X 1.3mm) pads. 2. On aluminum substrate P.C.B. with an area of 0.8 X 0.8 X 0.25” (20 X 20 X 6.4mm) mounted on 0.05 X 0.05” (1.27 X 1.27mm) solder pad. 3. Measured at 1MHz and applied reverse voltage of 4.0 volts. 4. Test Conditions: IF = 0.5A, IR = 1.0A, IRR = 0.25A. 5. Suffix “-S” Surface Mount for Mini Dip Bridge. RECTRON