ISL43142IVZ-T

DATASHEET ISL43140, ISL43141, ISL43142 FN6032 Rev 2.00 Aug 24, 2015 Low-Voltage, Single and Dual Supply, High Performance, Quad SPST, Analog Switches The Intersil ISL43140–ISL43142 devices are CMOS, precision, quad analog switches designed to operate from a single +2V to +12V supply or from a 2V to 6V supply. Targeted applications include battery powered equipment that benefit from the devices’ low power consumption (1W), low leakage currents (1nA max), and fast switching speeds (tON = 30ns, tOFF = 18ns). A 12 maximum RON flatness ensures signal fidelity, while channel-to-channel mismatch is guaranteed to be less than 2.5. The 3mm x 3mm Quad NoLead Flatpack (QFN) package alleviates board space limitations, making this newest line of low-voltage switches an ideal solution. The ISL43140/ISL43141/ISL43142 are quad single-pole/ single-throw (SPST) devices. The ISL43140 has four normally closed (NC) switches; the ISL43141 has four normally open (NO) switches; the ISL43142 has two NO and two NC switches and can be used as a dual SPDT, or a dual 2:1 multiplexer. Features • Fully Specified at 5V, 12V, 5V, and 3V Supplies for 10% Tolerances • Four Separately Controlled SPST Switches • Pin Compatible with DG411/DG412/DG413 • ON Resistance (RON) . . . . . . . . . . . . . . . . . . . . . . . . 50 • RON Matching Between Channels. . . . . . . . . . . . . . . . . . . 2 • Low Charge Injection . . . . . . . . . . . . . . . . . . . . . . 5pC (Max) • Low Power Consumption (PD) . . . . . . . . . . . . . . . . . . . .2kV Thermal Resistance (Typical, Note 5) Operating Conditions Temperature Range ISL4314XIX . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to 85°C JA (°C/W) 16 Ld SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . 115 16 Ld QFN Package. . . . . . . . . . . . . . . . . . . . . . . . . 75 16 Ld TSSOP Package . . . . . . . . . . . . . . . . . . . . . . 150 Maximum Junction Temperature (Plastic Package) . . . . . . . 150°C Moisture Sensitivity (See Technical Brief TB363) All Other Packages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Level 1 QFN Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Level 2 Maximum Storage Temperature Range. . . . . . . . . . . . . -65°C to 150°C Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300°C (SOIC and TSSOP - Lead Tips Only) CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. NOTES: 4. Signals on NC, NO, COM, or IN exceeding V+ or V- are clamped by internal diodes. Limit forward diode current to maximum current ratings. 5. JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details. Electrical Specifications: ±5V Supply Test Conditions VSUPPLY = 4.5V to 5.5V, GND = 0V, VINH = 2.4V, VINL = 0.8V (Note 6), Unless Otherwise Specified PARAMETER TEST CONDITIONS TEMP (°C) (NOTE 7) MIN Full V- - V+ V 25 - 50 65  TYP (NOTE 7) MAX UNITS ANALOG SWITCH CHARACTERISTICS Analog Signal Range, VANALOG ON Resistance, RON VS = 4.5V, ICOM = 1.0mA, VNO or VNC = 3V, See Figure 5 Full - - 75  RON Matching Between Channels, RON VS = 4.5V, ICOM = 1.0mA, VNO or VNC = 3V 25 - 2 2.5  Full - - 5  RON Flatness, RFLAT(ON) VS = 4.5V, ICOM = 1.0mA, VNO or VNC = 3V, Note 9  25 - 10 12 Full - - 13  25 -1 0.01 1 nA NO or NC OFF Leakage Current, INO(OFF) or INC(OFF) VS = 5.5V, VCOM = 4.5V, VNO or VNC = +4.5V, Note 8 COM OFF Leakage Current, ICOM(OFF) VS = 5.5V, VCOM = 4.5V, VNO or VNC = +4.5V, Note 8 Full -5 - 5 nA COM ON Leakage Current, ICOM(ON) VS = 5.5V, VCOM = VNO or VNC = 4.5V, Note 8 25 -2 0.01 2 nA Full -10 - 10 nA Input Voltage High, VINH Full 2.4 1.6 - V Input Voltage Low, VINL Full - 1.6 0.8 V VS = 5.5V, VIN = 0V or V+ Full -0.5 0.03 0.5 A VS = 4.5V, VNO or VNC = 3V, RL = 300, CL = 35pF, VIN = 0 to 3V, See Figure 1 25 - 40 80 ns Full - - 100 ns 25 - 15 30 ns Full -5 - 5 nA 25 -1 0.01 1 nA DIGITAL INPUT CHARACTERISTICS Input Current, IINH, IINL DYNAMIC CHARACTERISTICS Turn-ON Time, tON Turn-OFF Time, tOFF VS = 4.5V, VNO or VNC = 3V, RL = 300, CL = 35pF, VIN = 0 to 3V, See Figure 1 Break-Before-Make Time Delay (ISL43142), tD VS = 5.5V, VNO or VNC = 3V, RL = 300, CL = 35pF, VIN = 0 to 3V, See Figure 3 Charge Injection, Q CL = 1.0nF, VG = 0V, RG = 0, See Figure 2 Full - - 40 ns Full 5 20 - ns 25 - 1 5 pC NO or NC OFF Capacitance, COFF f = 1MHz, VNO or VNC = VCOM = 0V, See Figure 7 25 - 7 - pF COM OFF Capacitance, CCOM(OFF) f = 1MHz, VNO or VNC = VCOM = 0V, See Figure 7 25 - 7 - pF COM ON Capacitance, CCOM(ON) f = 1MHz, VNO or VNC = VCOM = 0V, See Figure 7 25 - 14 - pF FN6032 Rev 2.00 Aug 24, 2015 Page 4 of 17 ISL43140, ISL43141, ISL43142 Electrical Specifications: ±5V Supply Test Conditions VSUPPLY = 4.5V to 5.5V, GND = 0V, VINH = 2.4V, VINL = 0.8V (Note 6), Unless Otherwise Specified (Continued) TEMP (°C) (NOTE 7) MIN TYP RL = 50, CL = 15pF, f = 100kHz, VNO or VNC = 1VRMS, See Figures 4, 6, and 19 25 - >90 25 - 90 - 25 - 90 - dB 25 - 90 - dB 25 -