RFC1G18H4-24-S

Wideband Amplifier RFC1G18H4-24-S Product Features GaN MMIC Very Low Distortion Guaranteed Broadband Power Gain Heat Sink 99.9% Copper, Ag or Gold Plate Excellent Thermal Conductivity Single Supply Voltage @ 24V No External Circuit needed Application Drive Amplifier Package Type: SOT-115J Description The RFC1G18H4- 24 is specifically designed for up to 1GHz in frequency as amplifiers. This hybrid dynamic range amplifier module operates with a single voltage supply of 24V(DC). The RFC 1G18H4- 24-S is equipped with over-voltage suppressor. Absolute Maximum Ratings No 1 2 3 4 5 VDD / VRFOUT RFIN (CW 1-Tone) Storage Temperature Operating Ambient Temperature Operating Flange Temperature -40 -20 Parameter Min 22 Max 28 30 100 +60 +85 Unit VDC dBm ℃ ℃ ℃ Electrical Specifications No 1 2 3 4 5 6 7 8 Bandwidth (MHz) Gain @1000MHz Gain Flatness @20-1000MHz Input / Output VSWR OIP3 @20-1000MHz Power Output 3dB Comp. @20-1000MHz (dBm) IMD3 @CW 2-Tone, Po=20dBm, 1000MHz Supply Current 43 35 46 500 Parameter Min 20 18 19 1.5 2.0 : 1 44 36 48 550 Typ (TA= +25℃, VDD = 24V) Max 1000 Unit MHz dB 2 2.5 : 1 dBm dBm dBc 600 mA dBpp ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 6.0 Wideband Amplifier RFC1G18H4-24-S RFC1G18H4-24-S Typical Performance @ 25℃ No 1 2 3 4 5 6 7 8 Frequency S21 - Gain S11 - Input Return Loss S22 - Output Return Loss P3dB OIP3 Supply Voltage Current Parameter 20 19 -10 -12 36 45 24 550 Typical 500 19 -13 -10 37 45 1000 20 -20 -14 35 44 V mA Units MHz dB dB dB dBm dBm S-Parameters 30 40 20 Power Output 3dB Compression S21 10 38 Magnitude(dB) -10 S11 dBm 34 32 30 1000 1200 1400 1600 1800 2000 20 0 36 -20 S22 -30 -40 200 50 400 600 800 100 200 300 400 500 600 700 800 900 1000 Frequency(MHz) Frequency(MHz) OIP3 50 49 48 47 OIP3(dBm) 46 45 44 43 42 41 40 20 100 200 300 400 500 600 700 800 900 1000 Frequency(MHz) ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 6.0 Wideband Amplifier RFC1G18H4-24-S APPLICATIONS 1. 2. 3. On the power input port (Pin#5), use 47uF/35V capacitor GND is recommends Heat sink should be placed as tight as possible to the metal case. Suitable for safely handling electrostatic-sensitive devices. Person at a workbench should be earthed via a wrist strap and a resistor. All mains-powered equipment should be connected to the mains via an earth-leakage switch. Equipment cases should be grounded. Relative humidity should be maintained between 40% and 50%. An ionizer is recommended. Keep static materials, such as plastic envelopes and plastic trays etc., away from the workbench. One must put the power off, before adjusting the in/output matching of the system. Pay close attention to the input voltage not to over power the hybrid. The space between bottom of socket and the tip of the lead is recommended to have space of 2mm+ to protect the pin. Do not open the Plastic cover to change the matching inside the hybrid. Once opened, RFHIC will not be responsible for the hybrid. + +24V 47㎌ 4. 5. 6. 7. Package Dimensions (Type: SOT-115J) Pin No. 1 2,3,7,8 5 9 Function RF Input Ground Vcc RF Output RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 6.0