RFP-0895-33-27

HPA Module Product Features • Solid-state linear design • Small and light weight • Suitable for iDEN • 50 Ohm Input/Output impedance • High reliability and ruggedness • Built in Output Isolator • Built in monitoring circuit • High efficiency RFP-0895-33-27 Application • iDEN Repeater Description This HPA Module is a high gain, wide dynamic range amplifier module. It has superior performance comes with a modest price tag. Custom design available. Electrical Specifications @ VDD=+27DC, T=25°C, 50Ω System PARAMETER Frequency Range Output Power Gain Gain Flatness IMD Pout= 33dBm (30dBm/tone) ALC Second harmonic Input/Output VSWR DC Input Voltage Current Consumption Over Temperature Alarm & shutdown Over Power Alarm & shutdown Operating Temperature Dimension Size ( L × W × H ) RF Connectors To -20 ~ +60°C 150 x 120 x 25(mm) SMA Female OPS Alarm: High @ Pout ≥ 37dBm(shutdown), ALC H S11/S22 VDC IDD OTS Symbol BW P G ΔG IMD 851~869MHz Value 935 ~940MHz 33dBm (30dBm/tone) 39dB ± 1 dB @ T = 25℃ ≤60dBm, 30dBm(25kHz) ≤60dBm, 30dBm(1MHz) Operating point Operating range ≤ -50 dBc 1.3 :1 (max) to 50Ω +27V DC 1.5A(typ)@ 27VDC, 2W 90℃±5℃(shutdown), 70℃±5℃(auto recovery) 35dBm ± 0.5dB 10dB (min) ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 1.0 HPA Module Interface Connectors D-Sub, 9-Pin-Control Pin # 1 2 3 & shutdown 4 5 & shutdown 6 7 8 9 +VCC +VCC GND GND RF Power Enable Over Temperature Alarm DESCRIPTION RF Power Monitor VSWR Alarm Over Power Alarm RFP-0895-33-27 Specifications 5~35dBm(1V~4V). 100mV/dB Alarm: High @ Open port (Over + 20dBm) Alarm: High @ Pout ≥ 37dBm(shutdown), Enable: Low & GND, Disable: High & Open Alarm: High @ 90℃±5℃(shutdown), 70℃±5℃ (auto recovery & Alarm clear) +27V +27V GND GND OUTLINE DRAWING REMOVAL 1 2 3 4 5 6 7 8 9 RF Power Monitor VSWR Alarm Over Power Alarm RF Power Enable Over Temperature Alarm 27V DC 27V DC GND GND 9 1 RF IN RF OUT ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 1.0 HPA Module RFP-0895-33-27 TYPICAL PERFORMANCE GAIN & GAIN FLATNESS S11 S22 ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 1.0 HPA Module RFP-0895-33-27 Pout=2 x 30 dBm@ 937.5MHz (TS=1MHz) Pout=2 x 30 dBm@ 860MHz (TS=1MHz) Pout=2 x 30 dBm@ 860MHz (TS=25KHz) Pout=2 x 30 dBm@ 937.5MHz (TS=25KHz) RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 1.0