RTP26010-S0

GaN-SiC Pallet Amplifier Product Features • Doherty amplifier design • GaN on SiC HEMT • Small and light weight • 50 Ohm Input/Output impedance matched • Highly reliable and rugged design • High efficiency, High Gain • 8W typical PAVG RTP26010-S0 Application • WiMAX DPD amplifier • General purpose RF amplifier Description The RTP26010-S0 is designed for RF system application frequencies from 2496MHz to 2690MHz, with high gain. This Pallet Amplifier uses GaN on SiC HEMT technology which performs high breakdown voltage, high linearity, high efficiency. The RTP26010-S0 is DPD application amplifier. Electrical Specifications @ VDD=+30VDC, T=25°C, 50Ω System PARAMETER Frequency Range Output Power Output Power @ Psat G.C.P Small Signal Gain Small Signal Gain Flatness Gain Variation ACLR @ WiMAX 10MHz 2FA Input VSWR Forward Coupling Operating Voltage Efficiency @ Pout 10Watt Symbol BW PAVG Psat SSG ΔG ΔGt ACLR S11 FC VDC E Min 2496 45 - Typ 8 50 ± 1.0 ± 3.0 -25dBr Max 2690 10 ±2 Unit MHz Watt Watt dB dB dB dBr 28 1.5:1 -30 30 30 1.7:1 - dB Volt % ※ Test Signal Condition : WCDMA 4FA Environmental Characteristics PARAMETER Operating Temperature Storage Temperature Symbol Tc Ts Min -20 -30 Typ - Max +50 +60 Unit °C °C Mechanical Specifications PARAMETER Dimensions ( L x W x H ) RF Connectors In/Out RF Connector Coupling DC Connectors / Controls Cooling Value 150 x 90 x 18.5 SMA Female MCX Female Main 4Pin, Sub 6Pin External Heat sink + airflow Units mm Limits Max ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.3 GaN-SiC Pallet Amplifier RF Interface Connectors Pin # 1 2 3 RF IN RF OUT RF FWD Port Description RTP26010-S0 Specifications RF Input signal from TRx B’d RF Output signal to TDD switch RF Forward Detection signal For Feed-back Main DC Connector Pin # 1,2 3,4 Description Drive, Main Amp Stage +Vdd GND +28V ~ +48V Ground Specifications Sub DC Connector Pin # 1, 2 3, 4 5 6 Description Gain Block Amp Stage +Vgg GND TDD Signal Temp. Monitor +5V Ground PA TDD control signal for switching gate bias Reporting Temperature data [0.75V/25℃(10mV/℃)] Specifications Outline Drawing 1 ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.3 GaN-SiC Pallet Amplifier S-Parameter vs. Frequency RTP26010-S0 WCDMA 4FA Signal @ 2500MHz WCDMA 4FA Signal @ 2550MHz WCDMA 4FA Signal @ 2600MHz WCDMA 4FA Signal @ 2650MHz WCDMA 4FA Signal @ 2700MHz RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.3