GaN-SiC Pallet Amplifier
Product Features
• Doherty amplifier design • GaN on SiC HEMT • Small and light weight • 50 Ohm Input/Output impedance matched • Highly reliable and rugged design • High efficiency, High Gain • 16W typical PAVG
RTP26020-S0
Application
• WiMAX DPD amplifier • General purpose RF amplifier
Description
The RTP26020-S0 is designed for RF system application frequencies from 2496MHz to 2690MHz, with high gain. This Pallet Amplifier uses GaN on SiC HEMT technology which performs high breakdown voltage, high linearity, high efficiency. The RTP26020-S0 is DPD application amplifier.
Electrical Specifications @ VDD=+30VDC, T=25°C, 50Ω
System PARAMETER
Frequency Range Output Power Output Power @ Psat G.C.P Small Signal Gain Small Signal Gain Flatness Gain Variation ACLR @ WiMAX 10MHz 2FA Input VSWR Forward Coupling Operating Voltage Efficiency @ Pout 16Watt
Symbol
BW PAVG Psat SSG ΔG ΔGt ACLR S11 FC VDC E
Min
2496 45 -
Typ
16 100 ± 1.0 ± 3.0 -25dBr
Max
2690 20 ±2
Unit
MHz Watt Watt dB dB dB dBr
28
1.5:1 -30 30 30
1.7:1 -
dB Volt %
※ Test Signal Condition : WCDMA 4FA
Environmental Characteristics
PARAMETER
Operating Temperature Storage Temperature
Symbol
Tc Ts
Min
-20 -30
Typ
-
Max
+50 +60
Unit
°C °C
Mechanical Specifications
PARAMETER
Dimensions ( L x W x H ) RF Connectors In/Out RF Connector Coupling DC Connectors / Controls Cooling
▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com
Value 150 x 90 x 18.5 SMA Female MCX Female Main 4Pin, Sub 6Pin External Heat sink + airflow
Units mm
Limits Max
▪ All specifications may change without notice. ▪ Version 0.3
GaN-SiC Pallet Amplifier
RF Interface Connectors
Pin # 1 2 3 RF IN RF OUT RF FWD Port Description
RTP26020-S0
Specifications RF Input signal from TRx B’d RF Output signal to TDD switch RF Forward Detection signal For Feed-back
Main DC Connector
Pin # 1,2 3,4 Description Drive, Main Amp Stage +Vdd GND +28V ~ +48V Ground Specifications
Sub DC Connector
Pin # 1, 2 3, 4 5 6 Description Gain Block Amp Stage +Vgg GND TDD Signal Temp. Monitor +5V Ground PA TDD control signal for switching gate bias Reporting Temperature data [0.75V/25℃(10mV/℃)] Specifications
Outline Drawing
1
▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com
▪ All specifications may change without notice. ▪ Version 0.3
GaN-SiC Pallet Amplifier
*Typical Performance( at +25℃)
S-Parameter
RTP26020-S0
WCDMA 4FA signal @ 2600MHz
WCDMA 4FA signal @ 2640MHz
WCDMA 4FA signal @ 2640MHz
RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC.
▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com
▪ All specifications may change without notice. ▪ Version 0.3
很抱歉,暂时无法提供与“RTP26020-S0”相匹配的价格&库存,您可以联系我们找货
免费人工找货