ECLPWG-30

10K / 10KH ECL Logic Pulse Width Control Modules Triggered by the input's rising edge (input pulse width 5 ns, min.), a pulse of specified width will be generated at the output High-to-low transitions will not trigger the unit. Propagation Delay of 2 ns typ., 4 ns max. 10K ECL ECLPWG Series: Designed for output duty-cycle less than 50%. 10KH ECL ECLHPW Series: Designed for output duty-cycle less than 65%. Electrical Specifications at 25OC 10K ECL Pulse Width Generator Modules Part Number ECLPWG-5 ECLPWG-6 ECLPWG-7 ECLPWG-8 ECLPWG-9 ECLPWG-10 ECLPWG-15 ECLPWG-20 ECLPWG-25 ECLPWG-30 ECLPWG-40 ECLPWG-50 ECLPWG-60 ECLPWG-75 ECLPWG-100 Maximum Freq. (MHz) 77.0 67.0 59.0 53.0 48.0 43.0 31.0 23.0 19.0 15.0 11.0 9.0 8.0 6.5 5.0 Output Pulse Width (ns) 5 ± 1.00 6 ± 1.00 7 ± 1.00 8 ± 1.00 9 ± 1.00 10 ± 1.50 15 ± 2.00 20 ± 2.00 25 ± 2.00 30 ± 2.00 40 ± 2.00 50 ± 2.50 60 ± 3.00 75 ± 3.75 100 ± 5.00 Electrical Specifications at 25OC 10KH ECL Pulse Width Generator Modules Part Number ECLHPW-5 ECLHPW-6 ECLHPW-7 ECLHPW-8 ECLHPW-9 ECLHPW-10 ECLHPW-15 ECLHPW-20 ECLHPW-25 ECLHPW-30 ECLHPW-40 ECLHPW-50 ECLHPW-60 ECLHPW-75 ECLHPW-100 Maximum Freq. (MHz) 100.0 98.0 88.0 84.0 68.0 56.0 41.0 30.0 23.0 20.0 15.0 12.7 10.6 8.2 6.3 Output Pulse Width (ns) 5 ± 1.00 6 ± 1.00 7 ± 1.00 8 ± 1.00 9 ± 1.00 10 ± 1.50 15 ± 2.00 20 ± 2.00 25 ± 2.00 30 ± 2.00 40 ± 2.00 50 ± 2.50 60 ± 3.00 75 ± 3.75 100 ± 5.00 ECLPWG Schematic IN Pin 4 OUT Pin 15 TD PW TD PW ECLHPW OUT 9 IN Pin 9 OUT Pin 3 TD PW TD PW Vcc 16 Schematic IN 9 Vcc OUT 16 15 Pulse Width Control Circuit OUT OUT Pulse Width Control Circuit 1 Vcc 4 IN 8 Vee OUT OUT 1 2 3 8 Vee Vcc OUT OUT Dimensions in Inches (mm) 16-Pin Package with Unused Leads Removed Per Schematic GENERAL: For Operating Specifications and Test Conditions, see Tables IV, V and VII on page 5 of this catalog. Delays specified for the Leading Edge. Operating Temp. Range, ECLPWG ........................... -40O to +85OC Temperature Coefficient of PW ........................... 300ppm/OC typical Supply Current, IEE , ECLPWG .................. 40 mA typ., 65 mA max. Operating Temp. Range, ECLHPW ................................ 0O to +75OC Temperature Coefficient of PW ........................... 300ppm/OC typical Supply Current, IEE , ECLHPW ................... 50 mA typ., 75 mA max. .810 (20.57) MAX. .400 (10.16) MAX. .260 .300 (6.60) (7.62) TYP. MAX. .120 (3.05) MIN. .010 (0.25) TYP. .300 (7.62) .050 (1.27) TYP. .100 (2.54) TYP. .020 (0.51) TYP. 100K ECL Logic Delay Modules Contact Factory for Data Sheets Buffered with 100K Series 300 Logic 8 Equal Delay Taps Series: DDECL 4-Bit Programmable Series: PPECL2 Stable Delay vs. Temperature: 300 ppm/ C Operating Temperature Range 0OC to +85OC IN 24 VCCA VEE VCC O 1.300 (33.02) MAX .520 (13.21) MAX. .030 .350 (0.76) (8.89) TYP. MAX .120 (3.05) MIN. .010 (0.25) TYP. .400 (10.16) Dimensions in Inches (mm) 24-Pin Package with Unused Leads Removed Per Schematic .050 (1.27) TYP. .020 (0.51) TYP. .100 (2.54) TYP. IN 22 P4 21 P3 20 P2 19 VEE 18 P1 17 19 18 13 DDECL 8-Tap 100K Schematic PPECL2 4-Bit 100K Schematic Passive Delay Network Internal Termination 100 Ohm Thevenin to -2V 100K ECL 16 to 1 MUX Output Buffer 1 Vcc 3 1 4 2 5 3 6 7 8 4 9 5 10 6 11 7 12 8 6 7 8 VCC VCCA VCC VCCA OUT ECLPW 1/98 Specifications subject to change without notice. For other values & Custom Designs, contact factory. 28 Rhombus Industries Inc. 15801 Chemical Lane, Huntington Beach, CA 92649-1595 Tel: (714) 898-0960 • Fax: (714) 896-0971