ASC0402-1KF1

ASC Series Anti-Sulfur Thick Film Chip Resistor • • • • • • • Resistances from 1 Ohm to 10M Ohms Power Rating 0.05 to 1 Watt Resistance Tolerances to ± 0.5% TCR’s to ±200 ppm/°C Sizes: 0201/0402/0603/0805/1206/2010 /2512 Moisture Resistant Anti-Sulfur Construction AEC-Q200 Certified SPECIFICATIONS Resistance Range E24 / E96 values Power Rating (W) at 70°C Operating Temperature Range MAX Operating Voltage1 MAX Overload Voltage2 0201 0.05 -55 to +125 25V 50V 0402 0.0625 50V 100V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 0603 0.100 50V 100V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 0805 0.125 150V 300V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 1206 0.250 200V 400V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 1210 0.333 200V 400V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 2010 0.750 200V 400V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 2512 1 250V 500V 1Ω - 9.76Ω 10Ω - 1MΩ 1.02MΩ - 10MΩ ±200 ±100 ±200 Package Size 1 Operating Voltage = 2 Overload Voltage = 2.5 * Riedon Inc. © Riedon, Inc. -55 to +155 ±0.5% - ±1% 1Ω - 10MΩ ±5% TCR PPM/°C ±200 ( P * R ) or MAX Listed, whichever is lower. ( P * R ) or MAX Listed, whichever is lower. 300 Cypress Avenue Alhambra CA 91801 (626) 284-9901 www.riedon.com sales@riedon.com (626) 284-1704 Revised: 201812_002 ASC Series Anti-Sulfur Thick Film Chip Resistor L Recommended Land Pattern D1 C 3 4 5 W T 6 9 8 7 1 A B 2 D2 4 Alumina Substrate 21 3 Bottom Electrode 7 Edge Electrode 5 6 Barrier Layer Top Electrode Resistor Layer 8 9 Primary Overcoat External Electrode Secondary Overcoat Size L (mm) W (mm) T (mm) D1 (mm) D2 (mm) Weight* (g) 0201 0.60 ± 0.03 0.30 ± 0.03 0.23 ± 0.03 0.15 ± 0.05 0.15 ± 0.05 0.150 0402 1.00 ± 0.05 0.50 ± 0.05 0.35 ± 0.05 0.20 ± 0.10 0.20 ± 0.10 0.620 0603 1.60 ± 0.10 0.80 ± 0.10 0.45 ± 0.10 0.30 ± 0.20 0.30 ± 0.20 2.042 0805 2.00 ± 0.10 1.25 ± 0.10 0.50 ± 0.10 0.35 ± 0.20 0.40 ± 0.20 4.368 1206 3.10 ± 0.10 1.55 ± 0.10 0.55 ± 0.10 0.50 ± 0.25 0.50 ± 0.20 8.947 1210 3.10 ± 0.10 2.60 ± 0.15 0.55 ± 0.10 0.50 ± 0.25 0.50 ± 0.20 15.959 2010 5.00 ± 0.10 2.50 ± 0.15 0.55 ± 0.10 0.60 ± 0.25 0.50 ± 0.20 24.241 2512 6.35 ± 0.10 3.10 ± 0.15 0.55 ± 0.10 0.60 ± 0.25 0.50 ± 0.20 39.448 * Weight based on 1,000 pcs Derating Curve Recommended Land Pattern (mm) 100 A B C 0201 0.30 0.25 0.30 0402 0.50 0.45 0.60 0603 0.90 0.60 0.90 0805 1.20 0.70 1.30 1206 2.00 0.90 1.60 1210 2.00 0.90 2.80 2010 3.80 0.90 2.80 2512 3.80 1.60 3.50 80 Power ratio (%) Type 0402-2512 60 0201 40 20 0 0 20 40 60 80 100 120 140 160 Ambient Temperature ( °C ) Riedon Inc. © Riedon, Inc. 300 Cypress Avenue Alhambra CA 91801 (626) 284-9901 www.riedon.com sales@riedon.com (626) 284-1704 Revised: 201812_002 ASC Series Anti-Sulfur Thick Film Chip Resistor Environmental Characteristics Test Requirement ±1% and Below TCR Short Time Overload Conditions ±5% -55°C to +125, +25°C is reference temperature As Spec. ±(1%+0.05Ω) Insulation Resistance ±(2%+0.05Ω) RCWV*2.5 or Max. overload voltage for 5 seconds, 2 seconds for high power series >10 GΩ Max. Overload for 1 minute Endurance ±(2%+0.10Ω) ±(3%+0.10Ω) 70 ± 2°C, RCWV for 1000 hrs w/ 1.5 hrs “ON” and 0.5 hrs “OFF” Damp Heat with Load ±(2%+0.10Ω) ±(3%+0.10Ω) 40±2°C, 90 to 95% R.H. RCWV for 1000 hrs w/ 1.5 hrs “ON”and 0.5 hrs “OFF” Dry Heat ±(1%+0.05Ω) ±(1.5%+0.10Ω) at +125/+155°C for 1000 hrs Bending Strength ±(1%+0.05Ω) ±(1%+0.05Ω) Bending once for 5 seconds 2010,2512 sizes: 2 mm other sizes: 3 mm Solderability Terminal Finish = Nickel Tin Resistance to Soldering Heat 95% min. coverage ±(0.5%+0.05Ω) 245±5°C for 3 seconds ±(1%+0.05Ω) 260±5°C for 10 seconds Voltage Proof No breakdown or flashover 1.42 times Max. Operating Voltage for 1 minute Leaching Individual leaching area ≤ 5% Total leaching area ≤ 10% 260±5°C for 30 seconds Rapid Change of Temperature ±(0.5%+0.05Ω) ±(1%+0.05Ω) -55°C to +125/+155°C, 5 cycles Sulfur Test ±(0.5%+0.05Ω) ±(0.5%+0.05Ω) H2S, 50 ± 2°C, 91 to 93% R.H., no power rating for 1000 hrs RCWV(Rated Continuous Working Voltage) = √(P*R) or Max. Operating Voltage chichever is lower Ordering Information Part Description: Part Type - Package Size- Resistance - Tolerance - TCR Example: ASC0402 50 Ohms 0.05% 100ppm (Note: if no TCR is specified: The highest value will be supplied) Riedon Inc. © Riedon, Inc. 300 Cypress Avenue Alhambra CA 91801 (626) 284-9901 www.riedon.com sales@riedon.com (626) 284-1704 Revised: 201812_002