BH5510KV

1/3 Structure Product series Type Function 特 長 Silicon Monolithic Integrated Circuit PWM Driver for combi drive BH5510KV ・ Super silent spindle drive by S!PWM×2 technology. ・ Built in 2mode of spindle driver’s gain for low-speed stability rotation. ○ Absolute maximum ratings Parameter Power MOS supply voltage Control circuit power supply voltage Maximum driver output current Power dissipation Operating temperature range Storage temperature range Joint part temperature S ymbol PVcc Vcc IoMAX Pd Topr Tstg Tjmax Limits 6 6 3 ＃1 1.18 ＃ 2 -40～ 85 -55～ 150 150 Unit V V A W ℃ ℃ ℃ #1 The current is guaranteed 3.0A in case of the current is turned on/off in a duty-ratio of less than 1/10 with a maximum on-time of 5msec. #2 PCB (70mm×70mm×1.6mm,occupied copper foil is less than 3%,glass epoxy standard board) mounting. Reduce power by 9.5mW for each degree above 25℃. ○ Recommended operating conditions(Ta=-10～ +70℃ ) 〔 Set the power supply voltage taking allowable dissipation into considering 〕 Parameter Power MOS supply voltage Control circuit power supply voltage Symbol PVcc Vcc MIN. 3.0 4.0 TYP. 5.0 5.0 MAX. 5.5 5.5 Unit V V This product described in this specification isn’t judged whether it applies to COCOM regulations. Please confirm in case of export. This product isn’t designed for protection against radioactive rays. Application example The application circuit is recommended for use. Make sure to confirm the adequacy of the characteristics. When using the circuit with changes to the external circuit constants, make sure to leave an adequate margin for external components including static and transitional characteristics as well as dispersion of the IC. Note that ROHM cannot provide adequate confirmation of patents. The product described in this specification is designed to be used with ordinary electronic equipment or devices (such as audio-visual equipment, office-automation equipment, communications devices, electrical appliances, and electronic toys). Should you intend to use this product with equipment or devices which require an extremely high level of reliability and the malfunction of which would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. ROHM assumes no responsibility for use of any circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free from patent infringement. REV. A 2/3 ○ Electrical characteristics (Unless otherwise noted Ta=25℃ , Vcc=PVcc=5V, Vref=1.25V, RL(act)=8Ω+47μH, RL(SP)=2Ω+47μH, SPRNF=0.2Ω) Parameter Circuit current Quiescent current Current in standby mode Input dead zone (one side) Stepping driver block Output offset voltage Voltage gain Output On resistor（top and bottom） Symbol ICC IST VDZSTP4,5 VOO4,5 GVC4,5 RON4,5 f4,5CH VDZSP1 VDZSP2 gm1 gm2 RONSP VLIMSP fSP VDZACT1,2,3 VOO1,2,3 GVC1,2,3 RON1,2,3 f1,2,3CH VMVref VMVcc VSTH VSTHZ VSTL MIN. － － 10 -50 12.0 － 240 2 10 0.8 0.16 － 0.16 60 － -50 12.0 － 240 － 3.2 2.6 1.6 0 TYP. 10.5 － 30 － 14.0 1.5 300 50 210 1.0 0.2 0.6 0.20 80 － － 14.0 1.3 300 0.7 3.6 － － － MAX. 20 0.1 50 50 16.0 2.3 360 100 460 1.2 0.24 1.2 0.24 100 3 50 16.0 2.0 360 1.0 4.0 3.3 2.0 1.0 Unit mA mA mV mV dB Ω kHz mV mV A/V A/V Ω V kHz mV mV dB Ω kHz V V V V V Condition VST=2.6V VST=1.0V Io=500mA PWM frequency Input dead zone of gm1(one side) Input dead zone of gm2(one side) Spindle driver block Input output gain 1 Input output gain 2 Output On resistor（top and bottom） GVSW=L GVSW=H SPRNF=0.2Ω GVSW=L SPRNF=0.2Ω GVSW=H Io=500mA SPRNF=0.2Ω Output limit voltage PWM frequency Input dead zone (one side) Actuator driver block Output offset voltage Voltage gain Output On resistor（top and bottom） Value of design guarantee Io=500mA PWM frequency Vref drop mute ON threshold voltage Vcc drop mute ON threshold voltage Others Standby High level voltage range Standby Hi-Z level voltage range Standby Low level voltage range OPEN(Hi-z) is also available. ○ Package outlines BH5510KV Lot No. (UNIT : mm) Figure No. ; EX259-5001-1 REV. A 3/3 ○Block diagram / Application circuit PVcc1 10kΩ IN1 Logic 150Ω 0.047μF CNF1 NF amp VO1F Pre driver POWER MOS VO1R 5V 10kΩ IN2 Logic 150Ω VO2F Pre driver POWER MOS VO2R 0.047μF CNF2 NF amp IN3 Logic Pre driver POWER MOS VO3F VO3R PGND1 0.047μF CNF3 NF amp PVcc3 IN4 Logic Pre driver POWER MOS VO4F M VO4R 5V 0.033μF CNF4 NF amp IN5 Logic Pre driver POWER MOS VO5F VO5R PGND3 0.033μF CNF5 NF amp OSC 5V 100kΩ FG FG 3phase PHASE SHIFT REVERSE PROTECT HB HUP HUN 5V HVP HVN HWP HWN HB PVcc21, PVcc22 U V W SPCNF 0.01μF OSC INSP 180deg MATRIX Pre driver POWER MOS 5V LIMIT CPH 1000pF GVSW BMSW STBY Vref GVSW BMSW STBY GND T.S.D. Vcc 22μF 5V PH RNF1, RNF2 RNF=0.2Ω REV. A Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of which would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. It is our top priority to supply products with the utmost quality and reliability. However, there is always a chance of failure due to unexpected factors. Therefore, please take into account the derating characteristics and allow for sufficient safety features, such as extra margin, anti-flammability, and fail-safe measures when designing in order to prevent possible accidents that may result in bodily harm or fire caused by component failure. ROHM cannot be held responsible for any damages arising from the use of the products under conditions out of the range of the specifications or due to non-compliance with the NOTES specified in this catalog. Thank you for your accessing to ROHM product informations. More detail product informations and catalogs are available, please contact your nearest sales office. ROHM Customer Support System www.rohm.com Copyright © 2007 ROHM CO.,LTD. THE AMERICAS / EUPOPE / ASIA / JAPAN Contact us : webmaster@ rohm.co. jp 21, Saiin Mizosaki-cho, Ukyo-ku, Kyoto 615-8585, Japan TEL : +81-75-311-2121 FAX : +81-75-315-0172 Appendix1-Rev2.0