BU2630F-E2

Communication ICs Dual PLL frequency synthesizer BU2630F / BU2630FV The BU2630F / BU2630FV are a CMOS LSI with an internal dual PLL synthesizer. VCOs for transmission and reception can be controlled independently, and the reference frequency and main counter settings can also be programmed separately. This product is designed for applications involving cordless telephones and communications equipment worldwide.
Applications Cordless telephones, amateur short wave radios, industrial transceivers, VHF / UHF frequency generators, and others
Features 1) Operation possible at up to 80MHz (VDD = 2.5). 2) Low current dissipation Dual-system operation : 2.2mA (typ), VDD = 3V Single-system operation : 1.2mA (typ), VDD = 3V Non-operating state : 0.2mA (typ), VDD = 3V 3) 4) 5) 6) 7) 16-bit main counter. Internal 14-bit reference frequency counter. Unlock detection possible. Four output ports. (open drain) Control possible using 3-wire serial input.
Block diagram 91 Communication ICs FAbsolute maximum ratings (Ta = 25_C) FRecommended operating conditions (Ta = 25_C) FPin descriptions 92 BU2630F / BU2630FV Communication ICs BU2630F / BU2630FV
Input / output circuits 93 Communication ICs BU2630F / BU2630FV FElectrical characteristics (unless otherwise noted, Ta = 25_C, VDD = 3.0V, VSS = 0V) 94 Communication ICs BU2630F / BU2630FV
Circuit operation 95 Communication ICs Description of data (1) Programmable divider data: D0
D15 (2) Reference frequency data: R0
R13 (3) Output port control data : P-T (P-R) TON (RON) 1 : Open drain output ON (LO) 0 : Open drain output OFF (HI) (4) OFF transmission side (reception side) : Operation stopped F - T (F - R) pull-down : TPD (RPD) high-impedance, LD = OFF (5) PS Programmable device change : No. of divisions = 3
4095 96 BU2630F / BU2630FV Communication ICs BU2630F / BU2630FV (6) PL, PH, and PD pin control 0 0 : PLL operation 1 0 : Forced LO state 0 1 : Forced HI state 1 1 : Forced LO state (7) LD0, LD1, LD pin control (valid only on TX side) 0 0 : ON when unlocked (LO) 0 1 : Air pulse output 1 0 : Forced ON state (LO) 1 1 : Forced OFF state (HI) (8) Input (00) to test T0 and T1.
Application example 97 Communication ICs
Electrical characteristic curves
External dimensions (Units: mm) 98 BU2630F / BU2630FV Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document use silicon as a basic material. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.0