BU33TA2WHFV

CMOS LDO Regulators for Portable Equipments 1ch 200mA CMOS LDO Regulators BUTA2WNVX series, BUTA2WHFV series No.11020ECT01 ●Description BU□□TA2WNVX /HFV series is high-performance FULL CMOS regulator with 200-mA output, which is mounted on microminiature package SSON004X1216 (1.2 mm  1.6 mm  0.6 mm) &HVSOF5(1.6mm  1.6mm  0.6mm). It has excellent noise characteristics and load responsiveness characteristics despite its low circuit current consumption of 40 µA. It is most appropriate for various applications such as power supplies for logic IC, RF, and camera modules. Microminiature package SSON004X1216 & HVSOF5 with built-in heatsink is adopted for the package, which contributes to the space-saving design of the set. ●Features 1) High-accuracy output voltage of 1% (25 mV on 1.5-V & 1.8-V products） 2) High ripple rejection: 70 dB (Typ., 1 kHz, VOUT1.8 V)) 3) Compatible with small ceramic capacitor (CIN=Co=1.0 µF) 4) Low current consumption: 40 µA 5) ON/OFF control of output voltage 6) With built-in overcurrent protection circuit and overheat protection circuit 7) With built-in output discharge circuit 8) Adopting microminiature power package SSON004X1216 ●Applications Battery-powered portable equipment, etc. ●Line up ■ 200 mA BU□□TA2WNVX / HFV series Product Name BU□□TA2WNVX BU□□TA2WHFV 1.5 ○ ○ 1.8 ○ ○ 2.5 ○ ○ 2.6 ○ ○ 2.7 ○ ○ 2.8 2.85 2.9 ○ ○ ○ ○ ○ ○ 3.0 ○ ○ 3.1 ○ ○ 3.2 ○ ○ 3.3 ○ ○ 3.4 ○ ○ Package SSON004X1216 HVSOF5 Model name: BH□□TA2W□□□ a b Symbol Contents Specification of output voltage □□ 15 a 18 25 26 27 b Package Output voltage (V) 1.5V(Typ.) 1.8V(Typ.) 2.5V(Typ.) 2.6V(Typ.) 2.7V(Typ.) □□ 28 2J 29 30 31 NVX :SSON004X1216 HFV :HVSOF5 Output voltage (V) 2.8V(Typ.) 2.85V(Typ.) 2.9V(Typ.) 3.0V(Typ.) 3.1V(Typ.) □□ 32 33 34 Output voltage (V) 3.2V(Typ.) 3.3V(Typ.) 3.4V(Typ.) - www.rohm.com © 2011 ROHM Co., Ltd. All rights reserved. 1/29 2011.01 - Rev.C BUTA2WNVX series, BUTA2WHFV series ●Absolute maximum rating Parameter Symbol Ratings -0.3 ~ +6.5 Unit V mW ℃ +85 +125 ℃ ℃ Technical Note Maximum applied power voltage VMAX Power dissipation Maximum junction temperature Operational temperature range Storage temperature range *1 *2 Pd1 Pd2 TjMAX Topr Tstg 220*1 (SSON004X1216) 410*2 (HVSOF5) +125 -40 ~ -55 ~ When 1 PCB (70 mm  70 mm, thickness 1.6-mm glass epoxy) a standard ROHM board is implemented. Reduced to 2.2 mW/C when used at Ta=25C or higher. When 1 PCB (70 mm  70 mm, thickness 1.6-mm glass epoxy) a standard ROHM board is implemented. Reduced to 4.1 mW/C when used at Ta=25C or higher. ●Recommended operating range (Do not exceed Pd.) Parameter Input power supply voltage Maximum output current Symbol VIN IMAX Ratings 2.5 ~ 200 5.5 Unit V mA ●Recommended operating conditions Parameter Input capacitor Output capacitor *3 Symbol CIN CO Ratings Min. 0.5*3 0.5*3 Typ. 1.0 1.0 Max. － － Unit μF μF Conditions A ceramic capacitor is recommended. A ceramic capacitor is recommended. Set the capacity value of the capacitor so that it does not fall below the minimum value, taking temperature characteristics, DC device characteristics, and change with time into consideration. www.rohm.com © 2011 ROHM Co., Ltd. All rights reserved. 2/29 2011.01 - Rev.C BUTA2WNVX series, BUTA2WHFV series ●Electrical characteristics (Unless otherwise specified Parameter Technical Note Ta=25℃, VIN=VOUT+1.0 V (VIN=3.5 V on VOUT=1.8-V and1.5-V products), STBY=1.5 V, CIN=1.0 µF, CO=1.0 µF) Limits Symbol Unit Conditions Min. Typ. Max. VOUT ×0.99 VOUT -25 mV VOUT ×1.01 VOUT +25 mV V IOUT=10 μA, VOUT≥2.5 V IOUT=10 μA, VOUT