RPI-576N1

RPI-576N1 Photointerrupter, General type Absolute maximum ratings (Ta=25°C) Parameter Input (LED) Forward current Reverse voltage Power dissipation Collector-emitter voltage Emitter-collector voltage Collector current Collector power dissipation Operating temperature Storage temperature Soldering temperture ∗ 1mm from the body bottom. External dimensions (Unit : mm) 13.7 Through hole 10 2.35 2-φ 0.8 Symbol IF VR PD VCEO VECO IC PC Topr Tstg Tsol Limits 50 5 80 30 4.5 30 80 −25 to +85 −40 to +85 260 / 3 ∗ Unit mA V mW V V mA mW 5.85 576 Printers Facsimiles AV equipment 2.54 5.2 8.95 Cross-section A-A 5 0.5 0.8 R2.5 (photo- ) transistor Output Features 1) Heat resistance (170°C). 2) Small gap (0.5mm) and good accuracy. 3) Quick response time. 4) Filter against visible ray is built-in. 5) Kinked forming. Gap °C °C °C / s 2.5 A 7.5 Optical axis center Electrical and optical characteristics (Ta=25°C) Parameter Infrared Transfer Output Input Photo characteristics charac- charactransistor light emitter teristics teristics diode Forward voltage Reverse current Dark current Peak sensitivity wavelength Collector current Collector-emitter saturation voltage Response time Symbol VF IR ICEO Min. − − − − 0.5 − − − − − Typ. 1.3 − − 800 − 0.1 10 10 1 950 Max. 1.6 10 0.5 − − 0.5 − − − − Unit V µA µA nm mA V µs µs MHz nm µs nm 10 Conditions IF=50mA VR=5V VCE=10V − VCE=5V, IF=20mA IF=20mA, IC=0.5mA VCC=5V, IF=20mA, RL=100Ω 3.6± 0.4 1.45 4-0.4 (10) 0.7 A 4-0.85 4-0.45 (2.54) λP IC VCE(sat) tr tf fC 14 13.6± 0.1 4.65± 0.1 Cathode Collector Rise time Fall time Cut-off frequency Peak light emitting wavelength 0.4± 0.1 5.6± 0.1 0.9 IF=50mA λP tr tf ∗ Non-coherent Infrared light emitting diode used. Response time Maximum sensitivity wavelength − − 10 800 − − VCC=5V, IC=1mA, RL=100Ω ∗ This product is not designed to be protected against electromagnetic wave. 2-φ 0.7 Anode Emitter Notes: 1. Unspecified tolerance shall be ± 0.2 . 2. Dimension in parenthesis are show for reference. λP − Electrical and optical characteristics curves RELATIVE COLLECTOR CURRENT : Ic (%) 5 1000 FORWARD CURRENT : IF (mA) 100 80 60 40 20 0 0 d FORWARD CURRENT : IF (mA) DARK CURRENT : ID (nA) RESPONSE TIME : t (µs) 40 40 30 20 10 0 25°C 0°C 25°C 50°C 75°C COLLECTOR CURRENT : Ic (mA) 50 4 6 100 200 100 50 tf tr 20 10 tr tf tr tf RL=5kΩ RL=2kΩ RL=1kΩ 3 30 10 2.6 4-φ 1.0 Applications 20 2 1 VCE=30V VCE=20V VCE=10V 10 0 0.2 1 0.1 1 2 3 4 5 −20 0 20 40 60 80 100 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 0 0 10 20 30 40 50 10 20 50 100 200 500 1000 2000 25 0 25 50 75 100 DISTANCE : d (mm) AMBIENT TEMPERATURE : Ta (°C) FORWARD VOLTAGE : VF (V) FORWARD CURRENT : IF (mA) COLLECTOR CURRENT : Ic (mA) AMBIENT TEMPERATURE : Ta (°C) Fig.1 Relative output vs. distance ( ) RELATIVE COLLECTOR CURRENT : Ic (%) POWER DISSIPATION / COLLECTOR POWER DISSIPATION : PD / Pc (mW) Fig.2 Forward current falloff Fig.3 Forward current vs. forward voltage RELATIVE COLLECTOR CURRENT : Ic (%) 160 Fig.7 Collector current vs. forward current 3.0 COLLECTOR CURRENT : IC (mA) Fig.8 Response time vs. collector current Fig.9 Dark current vs. ambient temperature Input VCC d 100 80 60 40 20 0 0 140 120 100 80 60 40 20 0 40 20 0 20 40 60 80 100 100 80 60 40 20 0 PD PC 2.0 IF=25mA 20mA Input Output RL 90% 10% 15mA 1.0 Output 10mA 5mA td tr td : Delay time t r : Rise time (time for output current to rise tf 1 2 3 4 5 20 0 20 40 60 80 100 0 0 2 4 6 8 10 from 10% to 90% of peak current) t f : Fall time (time for output current to fall DISTANCE : d (mm) AMBIENT TEMPERATURE : Ta (°C) AMBIENT TEMPERATURE : Ta (°C) COLLECTOR-EMITTER VOLTAGE : VCE (V) from 90% to 10% of peak current) Fig.4 Relative output vs. distance ( ) Fig.5 Power dissipation / collector power dissipation vs. ambient temperature Fig.6 Relative output vs. ambient temperature Fig.10 Output characteristics Fig.11 Response time measurement circuit Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1