CX-1HS-03

CX-1H-03 CRYSTAL 10 kHz to 600 kHz ™ Miniature Quartz Crystal for Series Oscillators DESCRIPTION The CX-1H quartz crystal is a high quality tuning fork resonator for use in Series (two cascaded inverters) oscillators. The CX-1H is hermetically sealed in a rugged, miniature ceramic package, one-fourth the size of an eight-pin mini-DIP. The CX-1H crystal is manufactured using the STATEK-developed photolithographic process, and was designed utilizing the experience acquired by producing millions of crystals for industrial, commercial, military and medical applications. FEATURES PACKAGE DIMENSIONS actual size side view Miniature tuning fork design High shock resistance Designed for low power applications Compatible with hybrid or PC board packaging Low aging Full military testing available Designed and manufactured in the USA PACKAGE HANDLING E F A D B TYP. DIM A B C D E F INCHES .315 .140 .070 .300 .020 .150 mm 8.00 3.56 1.78 7.62 0.51 3.81 C MAX. INCHES .330 .155 .080 .310 .040 .160 mm 8.38 3.94 2.03 7.87 1.02 4.06 The CX crystal is hermetically sealed in a ceramic package. Normal handling and soldering precautions for small, low thermal mass parts are adequate when installing or testing CX crystals. CX crystals may be wave soldered, with proper precaution taken to avoid desoldering the leads. A slow machine rate or too high a pre-heat temperature or solder bath temperature can damage the crystals. Lead to package solder interface temperature should not exceed 175oC, glass lid to package seal rim temperature should not exceed 210oC. If the seal rim reaches temperatures above the maximum specified, the package may lose its hermeticity. Loss of hermeticity results in a frequency decrease and motional resistance increase. EQUIVALENT CIRCUIT Leads 0.013” x 0.018” (0.33 x 0.46 mm) typical. CONVENTIONAL SERIES OSCILLATOR CIRCUIT C0 1 L1 C1 R1 2 OSCILLATOR CX-1H XTAL BUFFER Contact factory for design guidelines R1 Motional Resistance L1 Motional Inductance C1 Motional Capacitance C0 Shunt Capacitance 10102 - Rev B RSG Electronic Components GmbH, Sprendlinger Landstr. 115, 63069 Offenbach, Germany, Tel. +49 69 - 984047-0, Fax: +49 69 - 9840-77, www.rsg-electronic.de SPECIFICATIONS FIGURE 1 CX-1H TYPICAL MOTIONAL RESISTANCE (R1) Specifications are typical at 25oC unless otherwise noted. Specifications are subject to change without notice. Frequency Range 10 kHz to 600 kHz R1 (k ) 1000 500 Calibration Tolerance* (see below) Motional Resistance (R1) A,B, or C 200 100 50 20 10 10 20 50 100 200 600 Figure 1 MAX.: 2x Typ. @ 10-169.9 kHz 2.5x Typ. @ 170-600 kHz Figure 2 Figure 3 Min. is 0.25x Typ. 2.0 pF MAX 1.5 W MAX. @ 10-24.9 kHz 3.0 W MAX. @ 25-600 kHz Figure 4 5ppm MAX. 1,000g 1msec., 1/2 sine 20g rms 10-2,000 Hz -10oC to +70oC Commercial -40oC to +85oC Industrial -55oC to +125oC Military -55oC to +125oC See package handling Motional Capacitance (C1) Quality Factor (Q) Shunt Capacitance (C0) Drive Level Turning Point (TO)** Aging, first year Shock, survival*** Vibration, survival*** Operating Temperature Frequency (kHz) FIGURE 2 CX-1H TYPICAL MOTIONAL CAPACITANCE (C1) 5 Temperature Coefficient (k) -0.035 ppm/0C2 C1 (fF) 2 1.0 0.5 10 20 50 100 200 600 Frequency (kHz) FIGURE 3 CX-1H TYPICAL QUALITY FACTOR (Q) Storage Temperature Max Process Temperature * Higher frequency calibration available. ** Other turning point available. *** Higher shock and vibration available. 50 20 10 5 2 10 20 50 100 200 600 CX-1H Crystal Calibration Tolerance at 25oC Frequency Range (kHz) Calibration 10-74.9 A B C + _ + _ + _ (in 1000's) 75-169.9 + _ + _ + _ 170-249.9 + _ + _ + _ 250-600 + _ + _ + _ Frequency (kHz) FIGURE 4 CX-1H TYPICAL TURNING POINT TEMP (T0) . 0.003% 0.01% 0.1% 0.005% 0.01% 0.1% 0.01% 0.02% 0.2% 0.02% 0.05% 0.5% HOW TO ORDER CX-1H-03 LEADED CRYSTALS CX-1H “S” if special or custom design. Blank if Std. -03 Side Leads 32.768 kHz (A /I) Temp. Range: C = Commercial I = Industrial M = Military S = Specify *Other calibration fill in ppm. Frequency Calibration Tolerance* @ 250C (A) (B) (C) +80 +70 +60 +50 +40 +30 +20 +10 0 -10 -20 10 20 50 100 200 600 TO ( C) O Frequency (kHz) Note: Frequency (f) deviation from frequency (fo) @ turning point 2 f-fO = k(T-T ) O fO PACKAGING CX-1H-03 -Tray Pack (Standard) 10102 - Rev B RSG Electronic Components GmbH, Sprendlinger Landstr. 115, 63069 Offenbach, Germany, Tel. +49 69 - 984047-0, Fax: +49 69 - 9840-77, www.rsg-electronic.de