SCP-1K2-15

ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice 900~1200W Parallel Type With PFC Function Features : SCP-1K2 series AC 180~260VAC input PF>0.98@ 230VAC Protections: Short circuit/ Overload/ Over voltage/ Over temperature Built in remote sense function Built-in remote ON-OFF control Power good signal With parallel function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan 3 years warranty SPECIFICATION ORDER NO. SAFETY MODEL NO. DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION SETUP, RISE, HOLD TIME VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR INPUT EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT (max.) OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SCP-1K2-05 SCP-1K2-09 SCP-1K2-12 SCP-1K2-15 SCP-1K2-18 SCP-1K2-24 SCP-1K2-36 SCP-1K2-48 SCP-1K2-60 1K2S-P005 5V 200A 0 ~ 200A 1000W 1K2S-P009 9V 133A 0 ~ 133A 1200W 100mVp-p 1K2S-P012 12V 100A 0 ~ 100A 1200W 120mVp-p 1K2S-P015 15V 80A 0 ~ 80A 1200W 150mVp-p 1K2S-P018 18V 66.6A 0 ~ 66.6A 1200W 180mVp-p 1K2S-P024 24V 50A 0 ~ 50A 1200W 240mVp-p 1K2S-P036 36V 33.3A 0 ~ 33.3A 1200W 360mVp-p 1K2S-P048 48V 24A 0 ~ 24A 1152W 480mVp-p 1.0% 0.5% 0.5% 1K2S-P060 60V 20A 0 ~ 20A 1200W 500mVp-p 1.0% 0.5% 0.5% RIPPLE & NOISE (max.) Note.2 100mVp-p 3.0% Typical adjustment by potentiometer 20%~100% adjustment by 1~5VDC external control 1.5% 1.0% 1.0% 1.0% 1.0% 1.0% VOLTAGE TOLERANCE Note.3 2.0% 0.5% 1.5% 180 ~ 260VAC 47 ~ 63Hz >0.98 / 230VAC 80% 10A / 230VAC 60A / 230VAC 3.5mA / 240VAC 82% 84% 85% 86% 89% 89% 0.5% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 500ms, 50ms, 16ms at full load 260 ~ 370VDC see the derating curve 90% 90% 105 ~ 140% rated output power Note. 4 Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A EMC (Note. 5) Compliance to EN61000-3-2,3 HARMONIC CURRENT EMS IMMUNITY POWER GOOD SIGNAL SPECIAL FUNCTION OTHERS COOLING MTBF DIMENSION PACKING NOTE Compliance to EN61000-4-2,3,4,5,6,8,11, Light industry level, criteria A Open collector of NPN transistor DC Voltage Adj., remote sensing, remote control, parallel operation(refer to control terminal instruction manual) By fan, >20% load or >50 fan on 37.4K hrs min. MIL-HDBK-217F(25 290*120*132mm (L*W*H) 4.5kg; 4pcs /19kg /CARTON ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: SCP-1K2-SPEC 2006-03-28 900~1200W Parallel Type With PFC Function Mechanical Specification SCP-1K2 series Unit:mm 290 120 123 AC INPUT 132.5 #6-32-4 M3(NUT) 3H-4 TB1 12345678 Vadj 200 200 103 LED POS+ NEG- LED 30 26.5 251 M3(NUT) 3H-4 Air flow direction 89 Terminal Pin. No. Assignment Pin No. 1 2 3 Assignment AC/L AC/N FG Control terminal Pin. No. Assignment (TB1) : Dinkle 51HDBC-O8P or equivalent Pin No. 1 2 3 4 Assignment VS+ VSVCI VCO Pin No. 5 6 7 8 Mating With Assignment PG PAR Dinkle 51SDB-O8P or equivalent GND INH Derating Curve Ta=25 100 1800 80 OUTPUT POWER (W) -10 10 20 30 40 50 60 70 1600 1400 1200 1100 1000 800 600 LOAD (%) 60 40 20 -20 90 110 130 150 160 180 200 220 240 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz F ile Name: SCP-1K2-SPEC 2006-03-28 ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice