SCP-2K4

ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice 2400W Parallel Type With PFC Function Features : SCP-2K4 series AC input 180~260VAC, 3 3 wire AC 220V, 1 or 380V, 3 4 wire(option) PF> 0.98@ 230VAC Protections: Short circuit/ Overload/ Over voltage/ Over temperature Built-in remote sense function, remote ON-OFF control Power good signal With parallel function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan Case coating with paint 3 years warranty SPECIFICATION ORDER NO. SAFETY MODEL NO. DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION SETUP, RISE, HOLD TIME VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR INPUT EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT(max.) OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE Note. 4 SCP-2K4-09 2K4S-P009 9V 266A 0 ~ 266A 2400W SCP-2K4-12 2K4S-P012 12V 200A 0 ~ 200A 2400W 120mVp-p SCP-2K4-15 2K4S-P015 15V 160A 0 ~ 160A 2400W 150mVp-p SCP-2K4-18 2K4S-P018 18V 133.3A 0 ~ 133.3A 2400W 150mVp-p SCP-2K4-24 2K4S-P024 24V 100A 0 ~ 100A 2400W 150mVp-p SCP-2K4-36 2K4S-P036 36V 66.6A 0 ~ 66.6A 2400W 200mVp-p SCP-2K4-48 2K4S-P048 48V 50A 0 ~ 50A 2400W 200mVp-p SCP-2K4-60 2K4S-P060 60V 40A 0 ~ 40A 2400W 200mVp-p 1.0% 0.5% 0.5% RIPPLE & NOISE (max.) Note.2 90mVp-p 3.0% Typical adjustment by potentiometer VOLTAGE TOLERANCE Note.3 2.0% 1.0% 1.0% 0.5% 1.5% 180 ~ 260VAC 47 ~ 63Hz >0.98 / 230VAC 83% 15A / 230VAC 60A / 230VAC 3.5mA / 240VAC 110 ~ 140% rated output power 84% 85% 0.5% 0.5% 3 0.5% 0.5% 20% ~ 100% adjustment by 1 ~ 5VDC external control 1.0% 1.0% 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 800ms, 400ms, 12ms at full load 3 wire (other system available) 86% 88% 88% 89% 89% Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A EMC (Note. 5) Compliance to EN61000-3-2,3 HARMONIC CURRENT EMS IMMUNITY POWER GOOD SIGNAL SPECIAL FUNCTION OTHERS COOLING MTBF DIMENSION PACKING NOTE Compliance to EN61000-4-2,3,4,5,6,8,11, Light industry level, criteria A Open collector of NPN transistor DC Voltage Adj., Remote sensing, remote control, parallel operation(refer to control terminal instruction manual) By fan, >20% load or >50 fan on 24.9K hrs min. MIL-HDBK-217F(25 350*212*124mm (L*W*H) 9.0kg ; 1pcs / 10kg / CARTON ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:SCP-2K4-SPEC 2006-03-28 2400W Parallel Type With PFC Function Mechanical Specification SCP-2K4 series Unit:mm 212[8.35] 332 [13.07] 8-M3X0.5 Terminal Block For Control Signal 1 23 45678 V-ADJ 1 2 5-M4X0.7 Terminal block For AC Input 34 5 123.9 [4.88] Air flow direction 6-M6 SCREW FOR DC OUTPUT POS(+) LED 320 [12.60] 30 [1.18] NEG(-) 6 [0.24] TYP 180[7.09] 4-M4X0.7 MOUNTING HOLE FOR USER 290 [11.42] 24 [0.94] Control Terminal Pin. No. Assignment : Pin No. 1 2 3 4 Assignment VS+ VSVCI VCO Pin No. 5 6 7 8 Assignment PG PAR GND INH AC Input Terminal Pin. No. Assignment Pin No. 1 2 3 Assignment FG N T Pin No. 4 5 Assignment S R Derating Curve Ta=25 100 80 OUTPUT POWER (W) -10 10 20 30 40 50 60 70 2400 2000 LOAD (%) 60 40 1200 20 900 -20 90 110 150 170 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name:SCP-2K4-SPEC 2006-03-28 ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice 2400W Parallel Type With PFC Function S C P -2K4 s eries .. LOAD LOAD t LOAD LOAD HON L.0FF USING INTERNALW LTAW CONTROL R WOTESENSINQ ON(OFFCONTR0LBY SWITCH 0NX)FF CONTROL BY TRANSISTOR Mut h 120 - 0 .VP I r n ( T y p ) POWER O(MO S1O)IW. I I I I 1 2 3 4 5 8 >v EXTERNALVOLTAGE @C) LOAD Flb Name:SCP-ZK4SPEC 200643-28 ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice 2400W Parallel Type With PFC Function FIG. A: 3 3W 220VAC SYSTEM (STANDARD MODEL FOR STOCK) R R SCP-2K4 series L1 N1 FG1 220V S L2 N2 FG2 T S N (NC) 220V FG T L3 N3 FG3 FIG. B: 1 220VAC SYSTEM L R L1 N1 S 220V L2 N2 T N L3 N3 N FG1 FG2 FG3 FG FIG. C: 3 4W 220/380VAC SYSTEM R R L1 N1 220V S L2 N2 T N N S FG 380V T L3 N3 FG1 FG2 FG3 FIG. D: 3 4W 190/110VAC SYSTEM R R 110V L1 N1 S N (N.C.) L2 N2 T L3 N3 N (NC) 190V FG T FG1 FG2 FG3 S File Name: SCP-2K4-SPEC 2006-03-28 ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice