450MXG680MLCALN35X46

Messrs. ONSTONE ALUMINUM ELECTROLYTIC CAPACITORS SPECIFICATION SHEET CUSTOMER PART No. Rubycon PART No. 450 MXG 680 M LCA LN 35X46 DRAWING No. REE – 045687 ISSUE DATE 29 July 2013 ISSUE No. 1 RUBYCON CORPORATION ENGINEERING DIVISION 1938-1, NISHIMINOWA, INA-SHI, NAGANO-KEN, JAPAN TEL No. +81-265-72-7116 FAX No. +81-265-73-3380 HIROKAZU HORIKAWA DESIGN CHECK YUZO SHIBA APPROVAL PAGE Customer Part Number Rubycon Part Number Style Operating Temperature Range The General Standard Fixed aluminum electrolytic capacitors for use in electronic equipment 1/2 450 MXG 680 M LCA LN 35X46 CE692 -25°C~+105°C JIS C 5141(1991) ＜DIMENSIONS OF TERMIANL ＞ 1.Dimensions (unit:mm) Terminal Case 5.0 ± 1.0 4.5 Negative Sine 印 ±0.1 ±0.1 X6 .0 2-1 14.5 ±0.1 Pressure Relief Vent 5.5 ± 0 . 1 Sleeve 14.2 Plate 3.0 ±0.1 2.4 ±0.1 ±0.1 0.6 ±0.1 46 5.0 ±2 4.2 ±1 5.0 ±1 ±1 φ35 φ35 ＜P.C. BOARD DIMENSIONS ＞ Name Material Appearance Sleeve P.V.C. Black 2.Electrical Performance Capacitance Nominal Tolerance Capacitance (µF) (%) 20°C/120Hz 20°C/120Hz 680 -20 ~ +20 Case Al Seal Rubber-laminated bakelite Rated Voltage Surge Voltage (V.DC) (V.DC) 450 500 Terminal Plate SPCC(Tin plating) P.V.C. Black Leakage Current Max./5min. (µA) tanδ Max. Rated Ripple Current (A r.m.s.) 20°C 20°C/120Hz 105°C/120Hz 1659 0.20 2.46 3.Marking:Unless otherwise specified,capacitor shall be clearly marked on its body. (1)Brand (2)Mark Indicating Electrolytic Capacitor (3)Maximum Operating Temperature (4)Rated Voltage CE 105 C (5)Nominal Capacitance (Tolerance) 450V 680µ F(M) (6)Series MXG (7)Polarity (8)Lot No. Lot No. DRAWING No. ISSUE No. REE - 045687 1 450 MXG 680 M LCA LN 35X46 RUBYCON CORPORATION PAGE 2/2 4.Temperature Characteristics (Impedance ratio at 120Hz) Z (-25°C)/Z (20°C): 8 MAX. 5.Load Life Test After 2000 + 72/0 hours application of D.C. rated working voltage with full rated ripple current at 105±2°C, the capacitor shall meet the following requirements. Capacitance Change :Within ±20% of the initial value Dissipation Factor : Not more than 200% of the specified value Leakage Current : Not more than the specified value 6.Notes (on the use of aluminum electrolytic capacitors) (1)Charge and discharge Do not use for a circuit where rapid charge and discharge is frequently repeated. (2)Insulation Aluminum electrolytic capacitors are covered with P.V.C. (polyvinyl chloride) sleeve which purpose is mainly indication of necessary items. The case of capacitor and the cathode terminal are not insulated. (3)Polarity Please confirm the polarity before use because this capacitor has polarity. ∗Guide to application except the above are described in our catalog and EIAJ RCR-2367C. EIAJ RCR-2367C: “Safety Application Guide for fixed aluminum electrolytic capacitors for use in electronic equipment” DRAWING No. ISSUE No. REE - 045687 1 450 MXG 680 M LCA LN 35X46 RUBYCON CORPORATION