10700456

Analog 4-wire PET-On-Glass Touch Screen Specification 1. Mechanical Dimensions and Construction 1.1 1.2 General: Analog Resistive touch screen is laminated by ITO PET to ITO glass. Construction : Item 1 2 3 4 5 6 7 8 9 10 11 12 13 Description ITO PET (Top layer) ITO Patterned Glass (Bottom layer) Tail Base Tail Coverlay Conductor Top layer circuit Bottom layer circuit Layer to layer contacted Dot spacer Isolation Layer Stiffener Glue Tape Material 0.188mm ITO PET Film 1.10mm ITO Glass Kapton Kapton Copper Silver ink Silver ink Silver ink UV Cure ink Isolation Adhesive Polyester UV Glue PET Film Remarks Antiglare coating Surface hardness: 3H Resistance:300~600Ω/□ Resistance:300~600Ω/□ Separated Tail Touch screen side view: Changes that contribute to technical improvement are subject to alternations 2006 Bearb. Gepr. Vert. Datum 21.08. 21.08. Name Maurer Maurer TOUCH SCREEN 5,72“, 4 Wire AMT-09532-5-A1 SPECIFICATIONS OF ANALOG RESISTIVE PET-ON-GLASS TOUCH SCREEN Manufactured by Apex Material Technology Corp. EDV-Datasheet don’t change manually H Zu Änd. Datum Name 1070,0456 Index: - D 79346 Endingen page 1 of 4 1.3 Input Method and Activation Force Input Method 1.6mm Ø Delrin stylus 16mm Ø Silicon "finger" Average Activation Force 0,10 ~ 0,70 N 0,10 ~ 0,70 N 2. Typical Optical Characteristics 2.1 Visible Light Transmission: 2.2 Haze: > 80% < 13% 3. Electrical Specifications 3.1 3.2 3.3 3.4 3.5 3.6 3.7 Operating Voltage: Contact current: Circuit close resistance: Circuit open resistance: Contact bounce: Linear Test : Capacitance: 5.5V or less 20mA (maximum) X : 350~900Ω Y : 200~700Ω > 10MΩ at 25VDC < 10ms