10700472

Analog 4-wire PET-On-Glass Touch Screen Specification 1. Mechanical Dimensions and Construction 1.1 1.2 General: Analog Resistive touch screen is laminated by ITO PET to ITO glass. Construction : Item Material Remarks 0.188mm ITO PET Film Antiglare coating 1 Surface hardness: 3H Resistance:300~600Ω/□ 2 ITO Patterned Glass (Bottom layer) 1.8mm ITO Glass Resistance:300~600Ω/□ 3 Tail Base Kapton Separated Tail 4 Tail cover lay Kapton 5 Connector AMP compatible 2,54mm 6 Top layer circuit Silver ink 7 Bottom layer circuit Silver ink 8 Layer to layer contacted Silver ink 9 Dot spacer UV Cure ink 10 Isolation Layer Isolation Adhesive 11 Sealing UV-Glue Description ITO PET (Top layer) Touch screen side view: Changes that contribute to technical improvement are subject to alternations 2006 Bearb. Gepr. Vert. Datum 18.08. 18.08. Name Maurer Maurer TOUCHSCREEN 14,97“, 4-Wire AMT-09543-01 SPECIFICATIONS OF ANALOG RESISTIVE PET-ON-GLASS TOUCH SCREEN Manufactured by Apex Material Technology Corp. EDV-Datasheet don’t change manually H Zu Änd. Datum Name 1070.0472 Index: - D 79346 Endingen page 1 of 5 1.3 Input Method and Activation Force Input Method 1.6mm Ø Delrin stylus 16mm Ø Silicon "finger" Average Activation Force 0,1 ~ 0,7N 0,1 ~ 0,8 N 2. Typical Optical Characteristics 2.1 2.2 Visible Light Transmission: Haze: > 80% < 13% 3. Electrical Specifications 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 Operating Voltage: Contact current: Circuit close resistance: Circuit open resistance: Contact bounce: Linear Test : Capacitance: Electrostatic Discharge Protection : 5.5V or less 20mA (maximum) X : 300 -1000Ω; Y : 200 -700Ω > 10MΩ at 25VDC < 10ms < 1.5 % 100nF(maximum) (per EN 61000-4-2 ) The touch screen withstands of 15KV air discharge and 8KV contact discharge. 4. Linearity 4.1 Linear Test Specification Direction X: