KBU6K

KBU6A THRU KBU6M SINGLE-PHASE BRIDGE RECTIFIERS Reverse Voltage – 50 to 1000 Volts Forward Current – 6.0 Amperes Features • Plastic material used carries Underwriters Laboratory Flammability Classification 94V-0 • • • • High case dielectric strength of 1500 VRMS Ideal for printed circuit boards High surge current capability High temperature soldering guaranteed: 250oC/10 seconds, 0.375 (9.5mm) lead length, 51bs. (2.3kg) tension Mechanical Data • Case: Molded plastic body • Terminals: Plated leads solderable per MIL-STD-750, Method 2026 • Mounting Position: Any (Note 1) • Weight: 0.3 ounce, 8.0 grams Absolute Maximum Ratings and Characteristics @ 25 ℃ unless otherwise specified. Symbols Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward TC = 100 C (Note 1,2) rectified output current at TA = 40OC (Note 3) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) TJ = 150OC Maximum instantaneous forward voltage drop per leg at 6A Maximum DC reverse current TA = 25 C at rated DC blocking voltage per leg TA = 125OC Typical thermal resistance per leg (Note 2) Operating junction and storage temperature range O O KBU 6A 50 35 50 KBU 6B 100 70 100 KBU 6D 200 140 200 KBU 6G 400 280 400 6 6 250 1 5 1 8.6 3.1 KBU 6J 600 420 600 KBU 6K 800 560 800 KBU 6M 1000 700 1000 Units V V V A A V µA mA O VRRM VRMS VCD IF(AV) IFSM VF IR RθJA RθJC TJ ,TS C/W O -50 to +150 C Notes: (1). Recommended mounted position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw. (2). Thermal resistance from junction to ambient with units in free air, P.C.B. mounted on 0.5x0.5” (12x12mm) copper pads, 0.375” (9.5mm) lead length. (3). Thermal resistance from junction to case with units mounted on a 2.6x1.4x0.06” thick (6.5x3.5x15 cm) Al. Plate SEMTECH ELECTRONICS LTD. ® (Subsidiary of Semtech International Holdings Limited, acompany listed on the Hong Kong Stock Exchange, Stock Code: 724) Dated : 07/10/2003