GP1A75EJ000F

GP1A75EJ000F GP1A75EJ000F Gap : 5mm Slit : 0.5mm *OPIC Output, Screw fixing type Transmissive Photointerrupter with Connector ■ Description GP1A75EJ000F are standard, OPIC output, transmissive photointerrupters with opposing emitter and detector in a case, providing non-contact sensing. For this family of devices, the emitter and detector are inserted in a case, and a 3-pin connector is included to allow remotemount or off-board designs. ■ Agency approvals/Compliance 1. Compliant with RoHS directive ■ Applications 1. General purpose detection of object presence or motion. 2. Example: PPC, FAX, Printer ■ Features 1. Transmissive with OPIC output 2. Highlights : • Includes additional screw fixing holes • Straight drop insertion 3. Key Parameters : • Gap Width : 5mm • Slit Width (detector side): 0.5mm • Package : 24×12.8×8mm (without connector and hooks) • Connector : Tyco Electronics AMP (PN : 292133-3) • Output Type : Low when the object is present. 4. Lead free and RoHS directive compliant * "OPIC"(Optical IC) is a trademark of the SHARP Corporation. An OPIC consists of a light-detecting element and a signalprocessing Notice The content of data sheet is subject to change without prior notice. In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device. 1 Sheet No.: D3-A04801EN Date Oct. 3. 2005 © SHARP Corporation GP1A75EJ000F ■ Internal Connection Diagram Voltage regulator Amp. 1 1 2 3 15kΩ 2 VCC VOUT GND 3 Truth table Condition Light beam interrupted Light beam uninterrupted Output Low High ■ Outline Dimensions Date code (6.8) (7.8) (Unit : mm) 8 φ3 .2 2.5 24 Case surface 9.6 4.3 13.6 5 4.3 2.6 6.8±1 Connector : 292133-3 (Tyco Electronics AMP K.K.) 4.7 2.35 1.5±0.2 2−0.5±0.1 Slit width 7.2 5.6 (5.8) 1 2 3 1.8 18.1 2.4 23 1 0.3 0.9+0.2 −0.15 2− R3 .2 • Unspecified tolerance shall be as follows ; Chip resistor Dimensions d≤5 5≤d