3RM10023AA14

Data sheet 3RM1002-3AA14 Direct starter, 3RM1, 500 V, 0.09 - 0.75 kW, 0.4 - 2 A, 110-230 V AC, screw/spring-type terminals product brand name SIRIUS product category Motor starter product designation Direct-on-line starter design of the product with electronic overload protection product type designation 3RM1 General technical data trip class CLASS 10A product function ● intrinsic device protection Yes suitability for operation device connector 3ZY12 No power loss [W] for rated value of the current at AC in hot operating state per pole 0.1 W insulation voltage rated value 500 V surge voltage resistance rated value 6 kV maximum permissible voltage for safe isolation ● between main and auxiliary circuit 500 V ● between control and auxiliary circuit 250 V shock resistance 6g / 11 ms vibration resistance 1 ... 6 Hz, 15 mm; 20 m/s², 500 Hz operating frequency maximum 1 1/s mechanical service life (switching cycles) typical 30 000 000 reference code acc. to IEC 81346-2 Q Substance Prohibitance (Date) 01.03.2017 00:00:00 product function ● direct start Yes ● reverse starting No product function short circuit protection No Electromagnetic compatibility conducted interference ● due to burst acc. to IEC 61000-4-4 3 kV / 5 kHz ● due to conductor-earth surge acc. to IEC 61000-4-5 2 kV ● due to conductor-conductor surge acc. to IEC 61000-4-5 1 kV ● due to high-frequency radiation acc. to IEC 610004-6 10 V electrostatic discharge acc. to IEC 61000-4-2 4 kV contact discharge / 8 kV air discharge conducted HF interference emissions acc. to CISPR11 Class B for domestic, business and commercial environments; Class A for industrial environments at 110 V DC field-bound HF interference emission acc. to CISPR11 Class B for domestic, business and commercial environments; Class A 3RM10023AA14 Page 1/2 1.21.2021 Subject to change without notice © Copyright Siemens for industrial environments at 110 V DC Main circuit number of poles for main current circuit 3 design of the switching contact as NO contact for signaling function OUT, electronic, 24 V DC, 15 mA adjustable current response value current of the current-dependent overload release 0.4 ... 2 A minimum load [%] 20 % type of the motor protection solid-state ● operating voltage rated value 48 ... 500 V relative symmetrical tolerance of the operating voltage 10 % operating frequency 1 rated value 50 Hz operating frequency 2 rated value 60 Hz relative symmetrical tolerance of the operating frequency 10 % operational current ● at AC at 400 V rated value 2A ● at AC-53a at 400 V at ambient temperature 40 °C rated value 2A ampacity when starting maximum 16 A operating power for 3-phase motors at 400 V at 50 Hz 0.09 ... 0.75 kW Inputs/ Outputs input voltage at digital input ● at DC rated value 110 V ● with signal at DC 0 ... 40 V ● for signal at DC 79 ... 121 input voltage at digital input ● at AC rated value 110 V ● with signal at AC 0 ... 40 V ● for signal at AC 93 ... 253 V input current at digital input ● for signal at DC 1.5 mA ● with signal at DC 0.25 mA input current at digital input with signal at AC ● at 110 V 0.2 mA ● at 230 V 0.4 mA input current at digital input for signal at AC ● at 110 V 1.1 mA ● at 230 V 2.3 mA number of CO contacts for auxiliary contacts 1 operational current of auxiliary contacts at AC-15 at 230 V maximum 3A operational current of auxiliary contacts at DC-13 at 24 V maximum 1A Control circuit/ Control type of voltage of the control supply voltage AC/DC control supply voltage 1 at AC ● at 50 Hz 110 ... 230 V ● at 60 Hz 110 ... 230 V control supply voltage frequency ● 1 rated value 50 Hz ● 2 rated value 60 Hz ● control supply voltage 1 at DC rated value 110 V operating range factor control supply voltage rated value at DC ● initial value 0.85 ● full-scale value 1.1 operating range factor control supply voltage rated value at AC at 50 Hz 3RM10023AA14 Page 2/3 1.21.2021 Subject to change without notice © Copyright Siemens ● initial value 0.85 ● full-scale value 1.1 operating range factor control supply voltage rated value at AC at 60 Hz ● initial value 1.1 ● full-scale value 0.85 control current at AC ● at 110 V in standby mode of operation 16 mA ● at 230 V in standby mode of operation 9 mA ● at 110 V when switching on 55 mA ● at 230 V when switching on 33 mA ● at 110 V during operation 36 mA ● at 230 V during operation 22 mA control current at DC ● in standby mode of operation 6 mA ● when switching on 15 mA ● during operation 30 mA Response times switch ON delay time 60 ... 90 ms OFF delay time 60 ... 90 ms Installation/ mounting/ dimensions mounting position vertical, horizontal, standing (observe derating) fastening method screw and snap-on mounting onto 35 mm standard mounting rail height 100 mm width 22.5 mm depth 141.6 mm required spacing ● with side-by-side mounting — forwards 0 mm — backwards 0 mm — upwards 50 mm — downwards 50 mm — at the side 0 mm ● for grounded parts — forwards 0 mm — backwards 0 mm — upwards 50 mm — at the side 3.5 mm — downwards 50 mm Ambient conditions installation altitude at height above sea level maximum 4 000 m relative humidity during operation 10 ... 95 % ● air pressure acc. to SN 31205 900 ... 1 060 hPa Communication/ Protocol product function bus communication No Connections/ Terminals type of electrical connection screw-type terminals for main circuit, spring-loaded terminals (push-in) for control circuit ● for main current circuit screw-type terminals ● for auxiliary and control circuit spring-loaded terminals (push-in) type of electrical wiring ● for main current circuit 1 or 2 conductors ● for auxiliary and control circuit 1 or 2 conductors type of connectable conductor cross-sections ● for main contacts — solid 1x (0,5 ... 4 mm²), 2x (0,5 ... 2,5 mm²) — finely stranded with core end processing 1x (0,5 … 4 mm²), 2x (0,5 … 1,5 mm²) ● at AWG cables for main contacts 3RM10023AA14 Page 3/4 1x (20 ... 12), 2x (20 ... 14) 1.21.2021 Subject to change without notice © Copyright Siemens connectable conductor cross-section for main contacts ● solid or stranded 0.5 ... 4 mm² ● finely stranded with core end processing 0.5 ... 4 mm² connectable conductor cross-section for auxiliary contacts ● solid or stranded 0.5 ... 1.5 mm² ● finely stranded with core end processing 0.5 ... 1 mm² ● finely stranded without core end processing 0.5 ... 1.5 mm² type of connectable conductor cross-sections ● for auxiliary contacts — solid 1x (0.5 ... 1.5 mm²), 2x (0.5 ... 1.5 mm²) — finely stranded with core end processing 1x (0,5 ... 1,0 mm²), 2x (0,5 ... 1,0 mm²) — finely stranded without core end processing 1x (0.5 ... 1.5 mm²), 2x (0.5 ... 1.5 mm²) ● at AWG cables for auxiliary contacts 1x (20 ... 16), 2x (20 ... 16) ● AWG number as coded connectable conductor cross section for main contacts 20 ... 12 ● AWG number as coded connectable conductor cross section for auxiliary contacts 20 ... 16 UL/CSA ratings yielded mechanical performance [hp] ● for single-phase AC motor — at 230 V rated value 0.125 hp ● for 3-phase AC motor — at 200/208 V rated value 0.333 hp — at 220/230 V rated value 0.333 hp — at 460/480 V rated value 0.75 hp Certificates/ approvals General Product Approval EMC Declaration of Conformity Miscellaneous Declaration of Conformity other Confirmation Further information Information- and Downloadcenter (Catalogs, Brochures,…) https://www.siemens.com/ic10 Industry Mall (Online ordering system) https://mall.industry.siemens.com/mall/en/en/Catalog/product?mlfb=3RM1002-3AA14 Cax online generator http://support.automation.siemens.com/WW/CAXorder/default.aspx?lang=en&mlfb=3RM1002-3AA14 Service&Support (Manuals, Certificates, Characteristics, FAQs,...) https://support.industry.siemens.com/cs/ww/en/ps/3RM1002-3AA14 Image database (product images, 2D dimension drawings, 3D models, device circuit diagrams, EPLAN macros, ...) http://www.automation.siemens.com/bilddb/cax_de.aspx?mlfb=3RM1002-3AA14&lang=en 3RM10023AA14 Page 4/5 1.21.2021 Subject to change without notice © Copyright Siemens 3RM10023AA14 Page 5/6 1.21.2021 Subject to change without notice © Copyright Siemens 3RM10023AA14 Page 6/7 1.21.2021 Subject to change without notice © Copyright Siemens last modified: 3RM10023AA14 Page 7/7 12/21/2020 1.21.2021 Subject to change without notice © Copyright Siemens