6EP1332-1SH71

Data sheet 6EP1332-1SH71 POWER SUPPLY S7-1200 PM1207 SIMATIC S7-1200 POWER MODULE PM1207 STABILIZED POWER SUPPLY INPUT: 120/230 V AC OUTPUT: 24 V DC/2.5 A Input Input 1-phase AC Supply voltage ● 1 at AC Rated value 120 V ● 2 at AC Rated value 230 V ● Note Automatic range selection Input voltage ● 1 at AC 85 ... 132 V ● 2 at AC 176 ... 264 V Wide-range input No Overvoltage resistance 2.3 × Vin rated, 1.3 ms Mains buffering at Iout rated, min. 20 ms; at Vin = 93/187 V Rated line frequency 50 ... 60 Hz Rated line range 47 ... 63 Hz Input current ● at rated input voltage 120 V 1.2 A ● at rated input voltage 230 V 0.67 A Switch-on current limiting (+25 °C), max. 13 A Duration of inrush current limiting at 25 °C 6EP1332-1SH71 Page 1/4 16.12.2015 Changes preserved © Copyright Siemens AG ● maximum 3 ms I²t, max. 0.5 A²·s Built-in incoming fuse T 3,15 A/250 V (not accessible) Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: 16 A characteristic B or 10 A characteristic C Output Output Controlled, isolated DC voltage Rated voltage Vout DC 24 V Total tolerance, static ± 3 % Static mains compensation, approx. 0.1 % Static load balancing, approx. 0.2 % Residual ripple peak-peak, max. 150 mV Spikes peak-peak, max. (bandwidth: 20 MHz) 240 mV Product function Output voltage adjustable No Output voltage setting - Status display Green LED for 24 V OK On/off behavior No overshoot of Vout (soft start) Startup delay, max. 6 s; 2 s at 230 V, 6 s at 120 V Voltage rise, typ. 10 ms Rated current value Iout rated 2.5 A Current range 0 ... 2.5 A Active power supplied typical 60 W Short-term overload current ● on short-circuiting during the start-up typical 6 A ● at short-circuit during operation typical 6 A Duration of overloading capability for excess current ● on short-circuiting during the start-up 100 ms ● at short-circuit during operation 100 ms Parallel switching for enhanced performance Yes Numbers of parallel switchable units for enhanced performance 2 Efficiency Efficiency at Vout rated, Iout rated, approx. 83 % Power loss at Vout rated, Iout rated, approx. 12 W Closed-loop control Dynamic mains compensation (Vin rated ±15 %), max. 0.3 % Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 3 % Load step setting time 50 to 100%, typ. 5 ms Load step setting time 100 to 50%, typ. 5 ms Setting time maximum 5 ms 6EP1332-1SH71 Page 2/4 16.12.2015 Changes preserved © Copyright Siemens AG Protection and monitoring Output overvoltage protection < 33 V Current limitation, typ. 2.65 A Property of the output Short-circuit proof Yes Short-circuit protection Constant current characteristic Enduring short circuit current RMS value ● typical Overload/short-circuit indicator 2.7 A - Safety Primary/secondary isolation Yes Galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 Protection class Class I Leakage current ● maximum 3.5 mA CE mark Yes UL/CSA approval Yes UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259; cURus-Recognized (UL 60950-1, CSA C22.2 No. 60950-1) File E151273 Explosion protection ATEX (EX) II 3G Ex nA II T4; cULus (ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group ABCD, T4, File E330455 Certificate of suitability IECEx No Certificate of suitability NEC Class 2 No FM approval Class I, Div. 2, Group ABCD, T4 CB approval Yes Marine approval GL, ABS, BV, DNV, LRS, NK Degree of protection (EN 60529) IP20 EMC Emitted interference EN 55022 Class B Supply harmonics limitation not applicable Noise immunity EN 61000-6-2 Operating data Ambient temperature ● during operation — Note 0 ... 60 °C with natural convection ● during transport -40 ... +85 °C ● during storage -40 ... +85 °C Humidity class according to EN 60721 Climate class 3K3, no condensation Mechanics Connection technology screw-type terminals Connections 6EP1332-1SH71 Page 3/4 16.12.2015 Changes preserved © Copyright Siemens AG ● Supply input L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm² ● Output L+, M: 2 screw terminals each for 0.5 ... 2.5 mm² ● Auxiliary - Width of the enclosure 70 mm Height of the enclosure 100 mm Depth of the enclosure 75 mm Weight, approx. 0.3 kg Product feature of the enclosure housing for side-byside mounting Yes Installation Snaps onto DIN rail EN 60715 35x7.5/15, wall mounting MTBF at 40 °C 1 492 537 h Other information Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) 6EP1332-1SH71 Page 4/4 16.12.2015 Changes preserved © Copyright Siemens AG