6EP1333-3BA00..

Product data sheet 6EP1333-3BA00-8AC0 SITOP MODULAR PLUS 5 STABILIZED POWER SUPPLY INPUT: 120-230/230-500 V AC OUTPUT: 24 V DC/5 A VERSION WITH COATED PCB Technical specifications Product SITOP modular plus Power supply, type 24 V/5 A Input Input 1-phase and 2-phase AC Supply voltage / 1 / at AC 120 … 230 V Supply voltage / 2 / at AC 230 … 500 V Voltage range • Note Set by means of selector switch on the device; starting from Vin > 90/180 V Input voltage / 1 / at AC 85 … 264 V Input voltage / 2 / at AC 176 … 550 V Wide-range input Yes Overvoltage resistance 1300 Vpeak, 1.3 ms Mains buffering at Iout rated, min. 25 ms Mains buffering at Vin = 120/230 V, typ. 150 ms at Vin = 400 V Rated line frequency 50 / 60 Hz Rated line range 47 ... 63 Hz Input current / at nominal level of the input voltage 120 V 2.2 A Input current / at nominal level of the input voltage 230 V 1.2 A Input current / at nominal level of the input voltage 500 V 0.61 A 6EP1333-3BA00-8AC0 Page 1/ 4 07/27/2012 subject to modifications © Copyright Siemens AG 2012 Switch-on current limiting (+25 °C), max. 35 A I²t, max. 1.7 A²·s Built-in incoming fuse T 3.15 A (not accessible) Protection in the mains power input (IEC 898) Recommended miniature circuit breaker at 1-phase operation: from 6 A (10 A), characteristic C (B); required at 2-phase operation: circuit breaker 2-pole connected or circuit breaker 3RV2011-1EA10 (setting 3.8 A) or 3RV2711-1ED10 (UL 489) at 230 V; 3RV2011-1DA10 (setting 3 A) or 3RV2711-1DD10 (UL 489) at 400/500 V Output Output Controlled, isolated DC voltage Rated voltage Vout DC 24 V Total tolerance, static ± 3% Static mains compensation, approx. 0.1 % Static load balancing, approx. 0.1 % Residual ripple peak-peak, max. 50 mV Spikes peak-peak, max. (bandwidth: 20 MHz) 200 mV Adjustment range 24 … 28.8 V Product feature / output voltage adjustable Yes Output voltage setting via potentiometer Status display Green LED for 24 V OK Signaling via signaling module (6EP1961-3BA10) On/off behavior Overshoot of Vout approx. 3 % Startup delay, max. 1s Voltage rise, typ. 50 ms Rated current value Iout rated 5A Current range 0…5A • Note > 60 °C Derating delivered active power / typ. 120 W constant overload current / at short-circuit during run-up / typical 5.5 A short-term overload current / at short-circuit during operation / typical 15 A Duration of overloading ability for excess current / on short-circuiting during the operational phase 25 ms Parallel switching for enhanced performance Yes • Note Numbers of parallel switchable units for enhanced performance switchable characteristic 2 Efficiency Efficiency at Vout rated, Iout rated, approx. 87 % Power loss at Vout rated, Iout rated, approx. 18 W Closed-loop control Dynamic mains compensation (Vin rated ±15 %), max. 0.1 % Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 3% 6EP1333-3BA00-8AC0 Page 2/ 4 07/27/2012 subject to modifications © Copyright Siemens AG 2012 Load step setting time 50 to 100%, typ. 2 ms Load step setting time 100 to 50%, typ. 2 ms Setting time / maximum 5 ms Protection and monitoring Output overvoltage protection < 35 V Current limitation, typ. 5.5 A Characteristic feature of the output / short-circuit protected Yes Short-circuit protection Alternatively, constant current characteristic approx. 5.5 A or latching shutdown Enduring short circuit current / Effective level / typical 5.5 A Overload/short-circuit indicator LED yellow for "overload", LED red for "latching shutdown" Safety Primary/secondary isolation Yes Potential separation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 Protection class Class I stray current / maximum 3.5 mA stray current / typical 0.25 mA CE mark Yes UL/CSA approval Yes UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259 Explosion protection - FM approval - CB approval No Marine approval - Degree of protection (EN 60529) IP20 EMC Emitted interference EN 55022 Class B Supply harmonics limitation EN 61000-3-2 Noise immunity EN 61000-6-2 Operating data Ambient temperature / in operation • Note -25 … +70 °C with natural convection Ambient temparature / on transport -40 … +85 °C Ambient temparature / in storage -40 … +85 °C Humidity class according to EN 60721 Climate class 3K3, no condensation Mechanics Connection technology screw-type terminals Connections / Supply input L, N, PE: 1 screw terminal each for 0.2 ... 2.5 mm² single-core/finely stranded 6EP1333-3BA00-8AC0 Page 3/ 4 07/27/2012 subject to modifications © Copyright Siemens AG 2012 Connections / Output L+, M: 2 screw terminals each for 0.2 ... 2.5 mm² Connections / Auxiliary - Width / of the housing 70 mm Height / of the housing 125 mm Depth / of the housing 125 mm Installation width 70 mm Mounting height 225 mm Weight, approx. 1.2 kg Product feature / of the housing / housing for side-by-side mounting Yes Type of mounting / wall mounting No Type of fixing / cap rail mounting Yes Type of mounting / S7-300 rail mounting No Installation Snaps onto DIN rail EN 60715 35x7.5/15 Electrical accessories Buffer module, signaling module Other information Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) letzte Änderung: Jul 25, 2012 6EP1333-3BA00-8AC0 Page 4/ 4 07/27/2012 subject to modifications © Copyright Siemens AG 2012