Data sheet
6EP3336-7SB00-3AX0
SITOP PSU6200/1AC/24VDC/20A
SITOP PSU6200 24 V/20 A stabilized power supply input: 120 - 230 V AC (110 240 V DC) output: 24 V DC/20 A with diagnostic interface
input
type of the power supply network
1-phase AC or DC
supply voltage at AC
● minimum rated value
120 V
● maximum rated value
240 V
● initial value
85 V
● full-scale value
264 V
supply voltage at DC
110 ... 240 V
input voltage at DC
85 ... 275 V
wide range input
Yes
overvoltage overload capability
300 V AC for 30 s
buffering time for rated value of the output current in the event of
power failure minimum
25 ms
operating condition of the mains buffering
at Vin = 240 V
line frequency
50/60 Hz
line frequency
47 ... 63 Hz
input current
● at rated input voltage 120 V
4.3 A
● at rated input voltage 240 V
2.3 A
current limitation of inrush current at 25 °C maximum
12 A
fuse protection type
10 A
fuse protection type in the feeder
Circuit breaker from 6 A characteristic B to 16 A characteristic C or circuit
breaker 3RV2011-1HA10 (setting 8A) or 3RV2711-1HD10 (UL 489)
output
voltage curve at output
Controlled, isolated DC voltage
number of outputs
1
output voltage at DC rated value
24 V
output voltage
● at output 1 at DC rated value
24 V
output voltage adjustable
Yes; via potentiometer
adjustable output voltage
24 ... 28 V; max. 480 W (576 W up to 45°C)
relative control precision of the output voltage
● on slow fluctuation of input voltage
0.2 %
● on slow fluctuation of ohm loading
0.2 %
residual ripple
● maximum
80 mV
● typical
50 mV
voltage peak
● maximum
100 mV
● typical
60 mV
6EP33367SB003AX0
Page 1/4
5/24/2024
Subject to change without notice
© Copyright Siemens
display version for normal operation
Green LED for 24 V OK
type of signal at output
Electronic contact (NO contact, contact rating 30 V DC/0.1 A) for DC O.K. or
diagnostic interface
behavior of the output voltage when switching on
Overshoot of Vout approx. 3 %
response delay maximum
0.5 s
voltage increase time of the output voltage
● typical
100 ms
output current
● rated value
20 A
● rated range
0 ... 20 A; 24 A up to +45°C; +60 ... +70 °C: Derating 3%/K
supplied active power typical
480 W
short-term overload current
● on short-circuiting during the start-up typical
30 A
● at short-circuit during operation typical
30 A
parallel switching of outputs
can be set with DIP switch
bridging of equipment
Yes; switchable characteristic
number of parallel-switched equipment resources for increasing
the power
2
efficiency
efficiency in percent
95.5 %
power loss [W]
● at rated output voltage for rated value of the output
current typical
25 W
● during no-load operation maximum
2.6 W
closed-loop control
relative control precision of the output voltage at load step of
resistive load 10/90/10 % typical
3%
setting time
● load step 10 to 90% typical
0.5 ms
● load step 90 to 10% typical
0.5 ms
● maximum
1 ms
protection and monitoring
design of the overvoltage protection
< 32 V
property of the output short-circuit proof
Yes
design of short-circuit protection
Shutdown and periodic restart attempts
● typical
30 A
overcurrent overload capability
● in normal operation
overload capability 150 % Iout rated up to 5 s/min
safety
galvanic isolation between input and output
Yes
galvanic isolation
Safety extra low output voltage Vout according to EN 60950-1
operating resource protection class
Class I
leakage current
● maximum
protection class IP
3.5 mA
IP20
standard
● for emitted interference
EN 55022 Class B
● for mains harmonics limitation
EN 61000-3-2
● for interference immunity
EN 61000-6-2
standards, specifications, approvals
certificate of suitability
● CE marking
Yes
● UL approval
Yes; cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259; cCSAus
(CSA C22.2 No. 60950-1, UL 60950-1)
● CSA approval
Yes; cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259; cCSAus
(CSA C22.2 No. 60950-1, UL 60950-1)
● EAC approval
Yes
● Regulatory Compliance Mark (RCM)
Yes
● NEC Class 2
No
● SEMI F47
Yes
type of certification
● BIS
6EP33367SB003AX0
Page 2/4
Yes; R-41188271
5/24/2024
Subject to change without notice
© Copyright Siemens
● CB-certificate
Yes
standards, specifications, approvals hazardous environments
certificate of suitability
● IECEx
No
● ATEX
No
● ULhazloc approval
No
● cCSAus, Class 1, Division 2
No
● FM registration
No
standards, specifications, approvals marine classification
shipbuilding approval
Yes
Marine classification association
● American Bureau of Shipping Europe Ltd. (ABS)
Yes
● French marine classification society (BV)
No
● Det Norske Veritas (DNV)
No; in preparation
● Lloyds Register of Shipping (LRS)
No
standards, specifications, approvals Environmental Product Declaration
Environmental Product Declaration
Yes
Global Warming Potential [CO2 eq]
● total
811.6 kg
● during manufacturing
28 kg
● during operation
782.6 kg
● after end of life
0.7 kg
ambient conditions
ambient temperature
● during operation
-30 ... +70 °C; with natural convection a monotonically increasing start-up from
-25 °C, safe start-up from -40 °C
● during transport
-40 ... +85 °C
● during storage
-40 ... +85 °C
environmental category according to IEC 60721
Climate class 3K3, 5 ... 95% no condensation
connection method
type of electrical connection
push-in terminals
● at input
L1/+, L2/N/-, PE: push-in for 0.5 ... 4 mm² single-core/finely stranded
● at output
+1, +2, -1, -2, -3: push-in for 0.5 ... 6 mm²
● for auxiliary contacts
13, 14 (alarm signal): 1 push-in terminal each for 0.2 ... 1.5 mm²
mechanical data
width × height × depth of the enclosure
70 × 155
installation width × mounting height
70 mm
required spacing
● top
45 mm
● bottom
45 mm
● left
0 mm
● right
0 mm
fastening method
Snaps onto DIN rail EN 60715 35x7.5/15
● standard rail mounting
Yes
● S7 rail mounting
No
● wall mounting
No
housing can be lined up
Yes
net weight
1.5 kg
accessories
electrical accessories
Buffer module, redundancy module
mechanical accessories
Identification labels SIMATIC ET 200SP 6ES7193-6LF30-0AW0
further information internet links
internet link
● to website: Industry Mall
https://mall.industry.siemens.com
● to web page: selection aid TIA Selection Tool
https://siemens.com/tst
● to website: Industrial communication
http://www.siemens.com/simatic-net
● to website: CAx-Download-Manager
http://www.siemens.com/cax
● to website: Industry Online Support
https://support.industry.siemens.com
additional information
other information
6EP33367SB003AX0
Page 3/4
Specifications at rated input voltage and ambient temperature +25 °C (unless
otherwise specified)
5/24/2024
Subject to change without notice
© Copyright Siemens
security information
security information
Siemens provides products and solutions with industrial cybersecurity functions
that support the secure operation of plants, systems, machines and networks.
In order to protect plants, systems, machines and networks against cyber
threats, it is necessary to implement – and continuously maintain – a holistic,
state-of-the-art industrial cybersecurity concept. Siemens’ products and
solutions constitute one element of such a concept. Customers are responsible
for preventing unauthorized access to their plants, systems, machines and
networks. Such systems, machines and components should only be connected
to an enterprise network or the internet if and to the extent such a connection is
necessary and only when appropriate security measures (e.g. firewalls and/or
network segmentation) are in place. For additional information on industrial
cybersecurity measures that may be implemented, please visit
www.siemens.com/cybersecurity-industry. Siemens’ products and solutions
undergo continuous development to make them more secure. Siemens strongly
recommends that product updates are applied as soon as they are available
and that the latest product versions are used. Use of product versions that are
no longer supported, and failure to apply the latest updates may increase
customer’s exposure to cyber threats. To stay informed about product updates,
subscribe to the Siemens Industrial Cybersecurity RSS Feed under
https://www.siemens.com/cert. (V4.7)
Classifications
Version
Classification
eClass
14
27-04-07-01
eClass
12
27-04-07-01
eClass
9.1
27-04-07-01
eClass
9
27-04-07-01
eClass
8
27-04-90-02
eClass
7.1
27-04-90-02
eClass
6
27-04-90-02
ETIM
9
EC002540
ETIM
8
EC002540
ETIM
7
EC002540
IDEA
4
4130
UNSPSC
15
39-12-10-04
Approvals Certificates
General Product Approval
Manufacturer Declaration
Declaration of Conformity
General Product Approval
Marine / Shipping
Environment
BIS CRS
last modified:
6EP33367SB003AX0
Page 4/4
5/22/2024
5/24/2024
Subject to change without notice
© Copyright Siemens
很抱歉,暂时无法提供与“6EP3336-7SB00-3AX0”相匹配的价格&库存,您可以联系我们找货
免费人工找货