6ES71426BG000AB0

Data sheet 6ES7142-6BG00-0AB0 SIMATIC DP, ET 200ECO PN, 8 DO 24 V DC/1.3 A; 8xM12, Degree of protection IP67 Supply voltage Rated value (DC) 24 V Reverse polarity protection Yes Load voltage 1L+ ● Rated value (DC) 24 V ● permissible range, lower limit (DC) 20.4 V ● permissible range, upper limit (DC) 28.8 V ● Reverse polarity protection Yes Load voltage 2L+ ● Rated value (DC) 24 V ● permissible range, lower limit (DC) 20.4 V ● permissible range, upper limit (DC) 28.8 V ● Reverse polarity protection Yes Input current Current consumption, typ. 100 mA from supply voltage 1L+, max. 4A from load voltage 1L+ (unswitched voltage) 4A from load voltage 2L+, max. 4A Power loss Power loss, typ. 5.5 W Digital outputs Number of digital outputs ● in groups of Short-circuit protection ● Response threshold, typ. 8 4 Yes 1.8 A Limitation of inductive shutdown voltage to Typ. (L1+, L2+) -47 V Controlling a digital input Yes Switching capacity of the outputs ● on lamp load, max. 5W Output current ● for signal "1" rated value 1.3 A; Maximum ● for signal "0" residual current, max. 1.5 mA Parallel switching of two outputs ● for uprating No ● for redundant control of a load Yes Switching frequency 6ES71426BG000AB0 Page 1/2 1.19.2021 Subject to change without notice © Copyright Siemens ● with resistive load, max. 100 Hz ● with inductive load, max. 0.5 Hz ● on lamp load, max. 1 Hz Total current of the outputs (per group) all mounting positions — up to 60 °C, max. 3.9 A Cable length ● unshielded, max. 30 m Interfaces Transmission procedure 100BASE-TX Number of PROFINET interfaces 1 1. Interface Interface types ● integrated switch Yes Interface types M12 port ● Autonegotiation Yes ● Autocrossing Yes ● Transmission rate, max. 100 Mbit/s Protocols Supports protocol for PROFINET IO Yes PROFINET CBA No PROFIsafe No PROFINET IO Device Services — IRT with the option "high flexibility" Yes — Prioritized startup Yes Redundancy mode Media redundancy — MRP Yes Open IE communication ● TCP/IP No ● SNMP Yes ● DCP Yes ● LLDP Yes ● ping Yes ● ARP Yes Interrupts/diagnostics/status information Diagnostics function Yes Alarms ● Diagnostic alarm Yes Diagnoses ● Diagnostic information readable Yes ● Monitoring the supply voltage Yes; green "ON" LED ● Wire-break in actuator cable Yes ● Short-circuit Yes ● Group error Yes; Red/yellow "SF/MT" LED Potential separation between the load voltages Yes between load voltage and all other switching components No between Ethernet and electronics Yes Potential separation channels ● between the channels No Isolation tested with ● 24 V DC circuits 707 V DC (type test) ● Test voltage for interface, rms value [Vrms] 1 500 V; According to IEEE 802.3 6ES71426BG000AB0 Page 2/3 1.19.2021 Subject to change without notice © Copyright Siemens Standards, approvals, certificates Suitable for safety-related tripping of standard modules Yes Highest safety class achievable for safety-related tripping of standard modules ● Performance level according to ISO 13849-1 PL d ● Category according to ISO 13849-1 Cat. 3 ● SILCL according to IEC 62061 SILCL 2 Connection method Design of electrical connection 4/5-pin M12 circular connectors Dimensions Width 60 mm Height 175 mm Depth 49 mm Weights Weight, approx. 910 g last modified: 12/19/2020 6ES71426BG000AB0 Page 3/3 1.19.2021 Subject to change without notice © Copyright Siemens