6ES71484PC000HA0

Data sheet 6ES7148-4PC00-0HA0 SIMATIC ET200PRO PS/1AC/24VDC/8A/IP67 SIMATIC ET200pro PS Regulated power supply in protection type IP67 input: 3 AC 400-480 V output: 24 V/8 A DC Input Input 3-phase AC Rated voltage value Vin rated 400 ... 480 V Voltage range AC 340 ... 550 V ● Note 320 ... 340 V for max. 1 min Wide-range input Yes Overvoltage resistance Implemented internally with varistors Mains buffering at Vin = 400 V Mains buffering at Iout rated, min. 15 ms; at Vin = 400 V Rated line frequency 1 50 Hz Rated line frequency 2 60 Hz Rated line range 45 ... 66 Hz input current ● at rated input voltage 400 V 0.5 A Switch-on current limiting (+25 °C), max. 40 A I²t, max. 3.5 A²·s Built-in incoming fuse T4A Protection in the mains power input (IEC 898) Required: Circuit breaker 3RV2011-1DA10 or 3RV2711-1DD10 (UL 489) Output Output Controlled, isolated DC voltage Rated voltage Vout DC 24 V Total tolerance, static ± 3% Static mains compensation, approx. 0.5 % Static load balancing, approx. 0.5 % Residual ripple peak-peak, max. 200 mV Spikes peak-peak, max. (bandwidth: 20 MHz) 250 mV product function output voltage adjustable No Output voltage setting - Status display Green LED for 24 V OK Signaling max. 30 V, 10 mA; Power-Good (High-Pegel 1L+ for Vout in range 21.3 ... 29 V); Overtemperature warning at least 30 s before switch-off (high level 1L+ when the max. internal temperature is exceeded) On/off behavior Overshoot of Vout < 2 % Startup delay, max. 1.5 s 6ES71484PC000HA0 Page 1/2 1.15.2021 Subject to change without notice © Copyright Siemens Voltage rise, typ. 40 ms Rated current value Iout rated 8A Current range 0 ... 8 A supplied active power typical 192 W short-term overload current ● on short-circuiting during the start-up typical 50 A ● at short-circuit during operation typical 50 A duration of overloading capability for excess current ● on short-circuiting during the start-up 100 ms ● at short-circuit during operation 100 ms Parallel switching for enhanced performance No Efficiency Efficiency at Vout rated, Iout rated, approx. 88 % Power loss at Vout rated, Iout rated, approx. 25 W Closed-loop control Dynamic mains compensation (Vin rated ±15 %), max. 0.5 % Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 1% setting time maximum 2 ms Protection and monitoring Output overvoltage protection < 33 V Current limitation, typ. 9.4 A property of the output short-circuit proof Yes Short-circuit protection Electronic shutdown, automatic restart enduring short circuit current RMS value ● maximum Overload/short-circuit indicator 10 A - Safety Primary/secondary isolation Yes galvanic isolation Protective extra low output voltage Vout according to EN 60950-1 and EN 50178 Protection class Class I leakage current ● maximum 3.5 mA ● typical 0.4 mA Degree of protection (EN 60529) IP67, enclosure type 5 indoor Approvals CE mark Yes UL/cUL (CSA) approval UL-Listed (UL 508) according to NFPA compatibility (National Fire Protection Association), see operating instructions Explosion protection - certificate of suitability NEC Class 2 No FM approval - CB approval Yes Marine approval - EMC Emitted interference EN 55022 Class A Supply harmonics limitation - Noise immunity EN 61000-6-2 environmental conditions ambient temperature ● during operation — Note -25 ... +55 °C with natural convection ● during transport -40 ... +70 °C ● during storage -40 ... +70 °C Humidity class according to EN 60721 Climate class 3K3, 5 … 95% no condensation Mechanics Connection technology screw-type terminals Connections 6ES71484PC000HA0 Page 2/3 1.15.2021 Subject to change without notice © Copyright Siemens ● Supply input L1, L2, L3, PE: Plug connector HAN Q4/2 (counterpart see "Electrical accessories") ● Output L+, M: 2 x 1.5 mm² each (4-pole cable for +/- with open, labeled ends, 4 x 1.5 mm²) ● Auxiliary Alarm signals: M12 plug-in connector 5-pin width of the enclosure 310 mm height of the enclosure 135 mm depth of the enclosure 90 mm Weight, approx. 2.8 kg product feature of the enclosure housing can be lined up No Installation Can be mounted onto ET200pro mounting rail electrical accessories Power connector (Input: 3RK1911-2BE30 (6 mm²)) (Output: 3RK19112BF10 (4 mm²)) MTBF at 40 °C 196 354 h other information Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) 6ES71484PC000HA0 Page 3/3 1.15.2021 Subject to change without notice © Copyright Siemens