6ES71556AU010BN0

Data sheet 6ES7155-6AU01-0BN0 SIMATIC ET 200SP, PROFINET interface module IM 155-6PN Standard, max. 32 I/O modules, and 16 ET 200AL modules, single hot swap, incl. server module (6ES7193-6PA00-0AA0) General information Product type designation IM 155-6 PN ST HW functional status From FS03 Product function ● I&M data Yes; I&M0 to I&M3 ● Module swapping during operation (hot swapping) Yes ● Isochronous mode No Engineering with ● STEP 7 TIA Portal configurable/integrated from version V14 ● STEP 7 configurable/integrated from version V5.5 SP4 and higher ● PROFINET from GSD version/GSD revision V2.3 / - Configuration control via dataset Yes Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 19.2 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes Short-circuit protection Yes Mains buffering ● Mains/voltage failure stored energy time 10 ms Input current Current consumption (rated value) 450 mA Current consumption, max. 550 mA Inrush current, max. 3.7 A I²t 0.09 A²·s Power Infeed power to the backplane bus 4.5 W Power loss Power loss, typ. 1.9 W Address area Address space per module ● Address space per module, max. 256 byte; per input / output Address space per station ● Address space per station, max. 512 byte; Dependent on configuration Hardware configuration 6ES71556AU010BN0 Page 1/2 1.19.2021 Subject to change without notice © Copyright Siemens Rack ● Modules per rack, max. 32; + 16 ET 200AL modules ● Quantity of operable ET 200SP modules, max. 32 ● Quantity of operable ET 200AL modules, max. 16 Submodules ● Number of submodules per station, max. 256 Interfaces Number of PROFINET interfaces 1; 2 ports (switch) 1. Interface Interface types ● Number of ports 2 ● integrated switch Yes ● BusAdapter (PROFINET) Yes; compatible BusAdapters: BA 2x RJ45, BA 2x FC, BA 2x M12 Protocols ● PROFINET IO Device Yes ● Open IE communication Yes ● Media redundancy Yes; PROFINET MRP Interface types RJ 45 (Ethernet) ● Transmission procedure PROFINET with 100 Mbit/s full duplex (100BASE-TX) ● 10 Mbps Yes; for Ethernet services ● 100 Mbps Yes; PROFINET with 100 Mbit/s full duplex (100BASE-TX) ● Autonegotiation Yes ● Autocrossing Yes Protocols PROFINET IO Device Services — IRT Yes; with send cycles of between 250 µs and 4 ms in increments of 125 µs — PROFIenergy Yes — Prioritized startup Yes — Shared device Yes — Number of IO Controllers with shared device, max. 2 Redundancy mode ● PROFINET system redundancy (S2) No Media redundancy — MRP Yes — MRPD No Open IE communication ● TCP/IP Yes ● SNMP Yes ● LLDP Yes Interrupts/diagnostics/status information Status indicator Yes Alarms Yes Diagnostics function Yes Diagnostics indication LED ● RUN LED Yes; green LED ● ERROR LED Yes; red LED ● MAINT LED Yes; Yellow LED ● Monitoring of the supply voltage (PWR-LED) Yes; green PWR LED ● Connection display LINK TX/RX Yes; 2x green link LEDs on BusAdapter Potential separation between backplane bus and electronics No between PROFINET and all other circuits Yes between supply and all other circuits No Permissible potential difference 6ES71556AU010BN0 Page 2/3 1.19.2021 Subject to change without notice © Copyright Siemens between different circuits Safety extra low voltage SELV Isolation Isolation tested with 707 V DC (type test) Standards, approvals, certificates Security level According to Security Level 1 Test Cases V1.1.1 Ambient conditions Ambient temperature during operation ● horizontal installation, min. 0 °C ● horizontal installation, max. 60 °C ● vertical installation, min. 0 °C ● vertical installation, max. 50 °C Altitude during operation relating to sea level ● Installation altitude above sea level, max. 5 000 m; On request: Installation altitudes greater than 2 000 m Connection method ET-Connection ● via BU/BA Send Yes; + 16 ET 200AL modules Dimensions Width 50 mm Height 117 mm Depth 74 mm Weights Weight, approx. 147 g last modified: 1/17/2021 6ES71556AU010BN0 Page 3/3 1.19.2021 Subject to change without notice © Copyright Siemens