6ES71583AD100XA0

Data sheet 6ES7158-3AD10-0XA0 SIMATIC PN/PN Coupler for deterministic data exchange between max.4 PN-Controller per subnet, also from subnet to subnet, PROFIsafe data exchange, I/O-, MSI-, MSO- and data record communication, redundant power supply, PN-connection via SIMATIC BusAdapter (BA), delivery w/o BusAdapter General information Product type designation PN/PN coupler Firmware version ● FW update possible Yes Product function ● I&M data Yes; I&M0 to I&M3 ● Isochronous mode No; For operation on isochronous bus ● Tool changer Yes; Docking station and docking unit ● Local coupling, IO data Yes — Number of coupling modules 16 — Number of coupling submodules per module 4; 1x write, 3x read ● Local coupling, data records Yes — Number of coupling modules 16 — Number of coupling submodules per module 4; 1x write, 3x read — Record length, max. 4 096 byte — FIFO depth in storage mode 8 Engineering with ● STEP 7 TIA Portal configurable/integrated from version STEP 7 V15.1 or higher ● PROFINET from GSD version/GSD revision V2.3 Installation type/mounting Mounting Mounting rail 7.5 mm and 15 mm Supply voltage Rated value (DC) 24 V permissible range, lower limit (DC) 19.2 V permissible range, upper limit (DC) 28.8 V Reverse polarity protection Yes Mains buffering ● Mains/voltage failure stored energy time 10 ms Input current Current consumption, max. 360 mA; For 19.2 V input voltage at the right-hand supply terminal, including 2 plugged BA 2x LC Inrush current, max. 1.6 A I²t 0.031 A²·s from supply voltage 1L+, max. 320 mA; For 19.2 V input voltage at the left-hand supply terminal, including 2 plugged BA 2x LC Power loss Power loss, typ. 6ES71583AD100XA0 Page 1/3 4 W; For 24 V input voltage and 2 plugged BA 2x RJ45 If BusAdapters with an optical interface are plugged, there is an additional 750 mW per optical interface (3 W with 2 plugged BA 2x LC) 7/8/2022 Subject to change without notice © Copyright Siemens Address area Address space per module ● Address space per module, max. 254 byte; max. 254 bytes of input data and 253 bytes of output data Address space per station ● Address space per station, max. 1 440 byte; per input / output Hardware configuration Submodules ● Number of submodules per station, max. 116 Interfaces Number of PROFINET interfaces 2; One PROFINET interface per line side Optical interface Yes; Via SIMATIC BusAdapter Transmission rate, max. 100 Mbit/s 1. Interface Interface types ● Number of ports 2; via BusAdapter ● integrated switch Yes ● BusAdapter (PROFINET) Yes; Compatible BusAdapter: BA 2x RJ45, BA 2x FC, BA 2x SCRJ, BA SCRJ / RJ45, BA SCRJ / FC, BA 2x LC, BA LC / RJ45, BA LC / FC Protocols ● PROFINET IO Device Yes ● Open IE communication Yes ● Media redundancy Yes; As MRP or MRPD client; max. 50 or 30 devices in the ring 2. Interface Interface types ● Number of ports 2; via BusAdapter ● integrated switch Yes Protocols ● PROFINET IO Device Yes ● Open IE communication Yes ● Media redundancy Yes; As MRP or MRPD client; max. 50 or 30 devices in the ring Interface types RJ 45 (Ethernet) ● Transmission procedure PROFINET with 100 Mbit/s full duplex (100BASE-TX) ● 10 Mbps No ● 100 Mbps Yes; PROFINET with 100 Mbit/s full duplex (100BASE-TX) ● Autonegotiation Yes ● Autocrossing Yes Protocols Supports protocol for PROFINET IO Yes Protocols (Ethernet) ● TCP/IP Yes ● SNMP Yes ● LLDP Yes ● ping Yes ● ARP Yes PROFINET IO Device Services — IRT Yes — PROFIenergy No — Prioritized startup Yes — Shared device Yes — Number of IO Controllers with shared device, max. 4; per line side Redundancy mode ● PROFINET system redundancy (S2) Yes; NAP S2 acc. to IEC ● H-Sync forwarding Yes Media redundancy — MRP Yes — MRPD Yes Open IE communication 6ES71583AD100XA0 Page 2/3 7/8/2022 Subject to change without notice © Copyright Siemens ● TCP/IP Yes ● SNMP Yes ● LLDP Yes Interrupts/diagnostics/status information Status indicator Yes Alarms Yes Diagnostics function Yes; Parameterizable Diagnostics indication LED ● RUN LED Yes; green LED ● ERROR LED Yes; red LED ● MAINT LED Yes; Yellow LED ● LINK LED Yes; 2x green link LEDs on BusAdapter ● Monitoring of the supply voltage (PWR-LED) Yes; green PWR LED Potential separation between supply voltage and electronics Yes; to power input 2 between Ethernet and electronics Yes Isolation Isolation tested with 707 V DC (type test) Standards, approvals, certificates Network loading class 3 Security level According to Security Level 1 Test Cases V1.1.4 Ambient conditions Ambient temperature during operation ● min. -30 °C; From FS05 ● max. 60 °C; = Tmax for horizontal installation; for vertical installation Tmax = 50 °C Altitude during operation relating to sea level ● Installation altitude above sea level, max. 5 000 m; restrictions for installation altitudes > 2 000 m, see section "Climatic and mechanical environmental conditions" Mechanics/material Strain relief Yes; Optional, for RJ45 and FC BusAdapter only Dimensions Width 100 mm; Minimized with good handling Height 117 mm Depth 74 mm; with mounting rail Weights Weight, approx. 200 g; without BusAdapter last modified: 3/22/2021 6ES71583AD100XA0 Page 3/3 7/8/2022 Subject to change without notice © Copyright Siemens