C8051F302-GM

C8051F302 25 MIPS, 8 kB Flash, 8-Bit ADC, 11-Pin Mixed-Signal MCU Analog Peripherals 8-Bit ADC High-Speed 8051 µC Core - - ±1 LSB INL; no missing codes Programmable throughput up to 500 ksps Up to 8 external inputs; programmable as single-ended or differential Programmable amplifier gain: 4, 2, 1, 0.5 VREF from external pin or VDD Internal or external start of conversion sources Data-dependent windowed interrupt generator Built-in temperature sensor (±3 °C) Programmable hysteresis and response time Configurable to generate interrupts or reset Low current (0.4 µA) Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks Up to 25 MIPS throughput with 25 MHz clock Expanded interrupt handler 256 bytes data RAM 8 kB Flash; in-system programmable in 512 byte sectors (512 bytes are reserved) 8 port I/O; all are 5 V tolerant Enhanced Hardware SMBus™ (I2C™ compatible) and UART serial ports Programmable 16-bit counter/timer array with three capture/compare modules, WDT 3 general-purpose 16-bit counter/timers Dedicated watchdog timer; bidirectional reset Real-time clock mode using PCA or timer and external clock source Internal oscillator: 20 MHz nominal External oscillator: Crystal, RC, C, or Clock (1 or 2 Pin Modes) Can switch between clock sources on-the-fly 11-pin MLP (Standard Lead and Lead-free packages) Lead-free package: C8051F302-GM Standard package: C8051F302 Memory Comparator Digital Peripherals POR/Brown-Out Detector On-Chip Debug On-chip debug circuitry facilitates full speed, non-intrusive in-system debug (no emulator required) Provides breakpoints, single stepping, watchpoints Inspect/modify memory, registers, and stack Superior performance to emulation systems using ICE-chips, target pods, and sockets Typical operating current: 5.8 mA at 25 MHz 11 µA at 32 kHz Typical stop mode current: