SP-1304-2

Dynamic Speaker Electroacoustic Characteristics Sound Pressure Level SP DYNAMIC SPEAKER UNIT Acoustic Product Specification 88±3dB SPL @1.0, 1.2,1.5 and 2.0KHz in average (0dB SPL=20μPa) Measuring Condition: 0.1W (Sine wave) 10cm measured with baffler shown in Fig.1. Frequency Response Curve As shown in Figure 2 Response Frequency Product Number: SP-1304-2 1300±20%Hz @ 1V. (Without Baffler) Input Power (Nominal and Maximum) Rated Noise Power 0.5W Short Term Max Power: 0.8W must be normal at a white noise (1W, F0 ~ 20KHz) for one minute Operation Test Must be free audible noise (buzzes and rattles) Release | Revision: C/2018 (3K ~ 5KHz frequency range, input level up to 2.0 Vrms) Distortion Less than 10% @1KHz, 0.1M, 0.1W frequency range, input level up to 0.1W CONTENTS This document contains the technical specifications for the dynamic speaker unit. Page 1 Speaker Electroacoustic Characteristics General Specifications Page 2 Reliability Tests Page 3 Measuring Method (Speaker Mode) General Specifications Operating Temperature Range -20℃~+60℃ Storage Temperature Range -25℃~+65℃ Standard Test Conditions Temperature 17℃~25℃ Relative Humidity 45%~80%(RH) AC Impedance Standard Test Condition of Speakers Page 4 Frequency Response Curve Page 5 Dimensions Page 6 Packing 8±15%Ω (@2KHz 1V) without baffler DC Resistance 7.4±15%Ω Dimension Ø13.0x4.3mm WIRE (20mm) IP Level IP 50 www.soberton.com 1 Reliability Tests The sound pressure as specified will neither deviate more than ±3dB from the initial value, nor have any significant damage after any of following testing. SP DYNAMIC SPEAKER UNIT Acoustic Product Specification High Temperature Test High Temperature +60±2℃ Duration 96 hours Low Temperature Test Product Number: SP-1304-2 Low Temperature -20±2℃ Duration 96 hours Heat Shock Test High Temperature +65±2℃ Low Temperature -20±2℃ Changeover Time