C-13-155-T-SST3-G5

155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Features • Duplex SC\ST\FC Single Mode Transceiver • Industry Standard 1x9 Footprint • Intermediate reach SONET OC-3 SDH STM-1 Compliant • Single +5V Power Supply • PECL/LVPECL Differential Inputs and Outputs • PECL/LVPECL Signal Detection Output • Wave Solderable and Aqueous Washable • LED Multisourced 1x9 Transceiver Interchangeable • Class 1 Laser Int. Safety Standard IEC 825 compliant • Uncooled laser diode with MQW structure • Complies with Telcordia (Bellcore) GR-468-CORE • ATM 155 Mbps links • RoHS compliant Absolute Maximum Rating Parameter Power Supply Voltage Output Current Soldering Temperature Storage Temperature Symbol Vcc Iout - Min. 0 -40 Max. 6 30 260 85 Unit V mA ºC ºC Note 10 seconds on leads only Tstg Recommended Operating Condition Parameter Power Supply Voltage1 Operating Temperature1 (Case) Data Rate Symbol Vcc Topr Min. 4.75 0 Typ. 5 70 155 Max. 5.25 ºC Mbps Unit V Note 1 : Please refer to ordering information Transmitter Specifications Parameter Optical Optical Transmit Power Output center Wavelength Output Spectrum Width Extinction Ratio Output ulse Mask Output Eye Optical Rise Time Optical Fall Time Relative Intensity Noise Total Jitter Po λ ∆λ ER 8.2 Compliant with FDDI SMF-PMD1 Compliant with ITU-T recommendation G.957 tr tf RIN TJ 2 2 -116 1.2 ns ns dB/Hz ns Measured with 223-1 PRBS with 72 ones and 72 zeros. 10% to 90% Values 10% to 90% Values -15 1261 1310 -8 1360 7.7 dBm nm nm dB RMS(σ) Output power is coupled into a 9/125 µm single mode fiber Symbol Min Typical Max Unit Notes LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Transmitter Specifications Parameter Electrical Power Supply Current Data Input Current-Low Data Input Current-High Differential Input Voltage Data Input Voltage-Low Data Input Voltage-High ICC IIL IIH VIH-VIL VIL-VCC VIH-VCC -350 300 -2.0 -1.1 160 350 -1.58 -0.74 mA µA µA mV V V These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs Maximum current is specified at Vcc= Maximum @ maximum temperature Symbol Min Typical Max Unit Notes Receiver Specifications Parameter Optical Sensitivity Maximum Input Power Signal Detect-Asserted Signal Detect-Deasserted Signal Detect-Hysteresis Wavelength of Operation Pin Pa Pd -7 -47 1.0 1100 -34 -34 4.0 1600 dBm dBm dBm dBm dB nm Measured on transition: low to high Measured on transition: high to low Measured with 223-1 PRBS with 72 ones and 72 zeros. Symbol Min Typical Max Unit Notes Receiver Specifications Parameter Electrical Power Supply Current Data Input Voltage-Low Data Input Voltage-High Signal Detect Output Voltage-Low Signal Detect Output Voltage-High ICC VOL -Vcc VOH- Vcc VSDL-Vcc VSDH- Vcc -2 -1.1 -2 -1.1 100 -1.58 -0.74 -1.58 -0.74 mA V V V V These outputs are compatible with 10K, 10KH and 100KECL and PECL outputs. The current excludes the output load current Symbol Min Typical Max Unit Notes LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Connection Diagram 1. (Rx GND) 2. (RD +) 3. (RD-) 4. (SD) 5. (Rx Vcc) 6. (Tx Vcc) 7. (TD-) 8. (TD+) 9. (Tx GND) NC Top View NC Receiver Signal Ground Receiver Data Out Receiver Data Out Bar Signal Detect Receiver Power Supply Transmitter Power Supply Transmitter Data In Bar Transmitter Data in Transmitter Signal Ground PIN 1 2 3 4 5 6 7 8 Warnings 9 Legal Notice Symbol RxGND RD+ RDSD RxVcc TxVcc TDTD+ TxGND Notes Directly connect this pin to the receiver ground plane See recommended circuit schematic See recommended circuit schematic Active high on this indicates a received optical signal +5V dc power for the receiver section +5V dc power for the transmitter section See recommended circuit schematic See recommended circuit schematic Directly connect this pin to the transmitter ground plane LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Recommended Circuit Schematic C-13-155-T-Sxx3(-55)-G5 Tx Vcc C5 Rx Vcc 9 R1 R3 8 7 6 5 43 2 1 R9 R5 R7 C6 TD + TD - RD + RD - Tx Vcc Rx Vcc R2 R4 R10 R6 SD R8 No internal connection Transceiver Top view No internal connection L1 Vcc Notes +5V: R1=R3=R5=R7=R9=82� R2=R4=R6=R8=R10=130� C1=C2=C3=C5=C6=0.1�F C4=10�F L1=L2=1�H Rx Vcc C3 C1 Tx Vcc L2 C4 C2 The split-loaded terminations for ECL signals need to be located at the input of devices receiving those ECL signals. The power supply filtering is required for good EMI performance. Use short tracks from the inductor L1/L2 to the module Rx Vcc. / Tx Vcc. A GND plane under the module is required for good EMI and sensitivity performance. LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Package Diagram (10.4 mm SC transceiver assembly) Top View Front View Units: mm Side View Rear View LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Package Diagram (ST transceiver assembly) y Top View Front View Units: mm Side View Package Diagram (FC transceiver assembly) Rear View Top View Front View Units: mm Side View LUMINENTOIC.COM Rear View LUMNDS1930-Aug0508 Rev A.0 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Ordering Information Available Options:  C-13-155-T-SSC3-G5 C-13-155-T-SST3-G5 C-13-155-T-SFC3-G5 C-13-155-T-SSC3-55-G5 C-13-155-T-SST3-55-G5 C-13-155-T-SFC3-55-G5 Part numbering Definition: C - 13 - 155 - T - S SC TxPower Temperature and Package -xx -RoHS • 13 = Wavelength 1310nm • Communication protocol (155 Mbps) 155 = PECL Signal Detection Output • T = +5V Transceiver, FP • Single mode fiber • Connector options SC/ST/FC • Tx Power range 3= -15 to -8 dBm • Temperature range and package Blank = commercial temperature(0 to 70 ºC), 10.4 mm, Black case • -55 = lead soldered Blank = lead free solderd • Blank = RoHS non-compliant product G5 = RoHS compliant LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS1930-Aug0508 Rev A.0 155 Mbps Single Mode Transceiver C-13-155-T-Sxx3(-55)-G5 Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 8 LUMNDS1930-Aug0508 Rev A.0