SP-48-LR2-RNA

OC-48 LR-2/STM16 L-16.2 SFP Transceiver SP-48-LR2 Features • Compliant with OC48/STM-16 Standards • Single 3.3 V supply • 80 km reach • 26 dB min, 30.5 dB typical link budget • Commerical and Reduced Industrial temperature available • 1550nm DFB Laser • APD Receiver • SFP MSA SFF-8074i compliant • GR 253/STM G.957 compliant • Telcordia GR-468 compliant • Digital Diagnostic SFF-8472 Rev. 9.3 compliant • White color coated bail latch • RoHS 5/6 compliant (Lead Exemption) General Operating Parameter Supply Voltage Total Current Power Supply Noise Rejectiona Operating Temperature(-Cxx) Operating Temperature(-Rxx) Storage Temperature Data Rate OC48/STM-16 a) 20Hz to 155MHz Symbol Vcc ICC PSR Topr Topr Tstg DR Min. 3.135 100 -5 -20 -40 Typ. 3.3 2488.32 Max. 3.465 300 70 85 85 Unit V mA mVp-p ºC ºC ºC Mbps Transmitter Specifications, Optical Parameter Optical Power Average Launch Power of Off Tx Extinction Ratio Eye Mask Optical Jitter Generation Optical Rise Timeb Optical Fall Timeb Mean Wavelength Spectral Width (20dB) Dispersion Penalty 1600ps/nmc Relative Intensity Noise Reflectance Toleranced TJ tr tf λ ∆λ dp RIN rp -24 1500 1550 1 Symbol Pop Poff ER Min -2 8.2 Typical 0.5 Max 3 -30 SONET/SDH compliant 0.007 160 160 1580 1 2 -120 UI ps ps nm nm dB dB/Hz dB Unit dBm dBm dB b) 20%-80% values c) Measured at BER of 1e-10, PRBS of 223-1, at eye center d) 1dB degradation of receiver sensitivity LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1525-FEB1706 rev.A.0 OC-48 LR-2/STM16 L-16.2 SFP Transceiver SP-48-LR2 Transmitter Specifications , Electrical Parameter Input Differential Impedence PECL Single Ended data input swing TxFault_Fault TxFault_Normal TxDisable_Disable TxDisable_Enable Symbol Rin Vin, p-p Vfault Vnormal Vd Ven Min 80 250 2 Vee 2 Vee Typical 100 Max 120 1200 Vcc Vee + 0.5 Vcc Vee + 0.8 Unit Ω mV V V V V Receiver Specifications, Optical Parameter Receiver Power Lowe Receiver Power Highe Damage Threshold for Receiver Wavelengthf Maximum Reflectance of Receiver LOS Assert LOS De-assert LOS Hysteresis e) At 10-10 BER, PRBS 223-1 f) Operational over 1200-1625 nm range Symbol Rsens,low Rsens,high Pin, damage λ RX_r Min -6 4 1500 -42 0.5 Typical -30 1550 Max -28 1580 -27 -28 Unit dBm dBm dBm nm dB dBm dBm dB Electrical Output Parameter PECL Single Ended Data Output Swing Data Output Rise Time Data Output Fall Time Symbol Vout,p-p tr tf Min 185 Typical Max 800 175 175 Unit mV ps ps LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1525-FEB1706 rev.A.0 OC-48 LR-2/STM16 L-16.2 SFP Transceiver SP-48-LR2 Timing and Electrical Parameter Tx Disable Negate time Tx Disable assert time Time to initialize, including reset of Tx fault Tx fault Assert time Tx Disable to reset LOS Assert time LOS De-assert time Serial ID Clock Rate RX_LOS Voltage (high) RX_LOS Voltage (low) LOS output voltage-Fault LOS output voltage-Normal MOD_DEF (0:2)-High MOD_DEF (0:2)-Low Symbol t_on t_off t_init t_fault t_reset t_loss_on t_loss_off f_serial_clock Rx_LOSH RX_LOSL VLOS fault VLOS normal Vh VI Min 10 2 2 Vee 2 Vee Typical Max 1 10 300 100 100 100 100 0.8 Vcc Vee + 0.5 Vcc Vee + 0.5 Unit ms µs ms µs µs µs µs KHz V V V V V V Diagnostics Parameter Temperature(-CDx) Temperature(-RDx) Voltage Bias Current Tx Power Rx Power Range -5 to 70 -20 to 85 0 to Vcc 0 to 120 -2 to 3 -32 to -6 Accuracy ±3 ±3 0.1 5 ±3dB ±3dB Unit ºC ºC V mA dBm dBm Calibration Internal Internal Internal External External External Formula Tc(C) = Tad(16 bit signed twos complement)/256 Tc(C) = Tad(16 bit signed twos complement)/256 V(Volts) = Vad(16 bit unsigned integer)*0.1 I(mA) = Islope * Iad(16 bit unsigned integer)+Ioffset Tx_PWR(µW) = Tx_PWRslope*Tx_PWRad(16 bit unsigned integer)+Tx_ PWRoffset Rx_PWR(µW) = A0+A1*x+A2*x^2+A3*x^3+A4*x^4 LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1525-FEB1706 rev.A.0 OC-48 LR-2/STM16 L-16.2 SFP Transceiver SP-48-LR2 EEPROM Serial ID Name of Field Discription of Field Address 20 21 22 23 24 Vendor Name SFPVendor name (ASCII) 25 26 27 28 29 30 37 Vendor OUI IEEE vendor OUI code for LuminentOIC Inc. 38 39 40 41 42 43 Vendor PN Part number in ASCII, e.g. SP-48-LR2-CDA 44 45 46 47 48 49 Pinout Definitions Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 LUMINENTOIC.COM Function VeeT TX_FAULT TX_DISABLE MOD_DEF2 MOD_DEF1 MOD_DEF0 NC LOS VeeR VeeR VeeR RXDRXD+ VeeR VCCR VCCT VeeT TXD+ TXDVeeT Notes TX GND Open Collector Internally Pulled High Serial Data Input Serial Clock Input Internally Grounded Not Connected Open Collector RX Ground RX Ground RX Ground RX Data Negative RX Data Positive RX GND RX Power TX Power TX GND TX Data Positive TX Data Negative TX GND LUMNDS1525-FEB1706 rev.A.0 Hex 4C 55 4D 49 4E 45 4E 54 4F 49 43 00 06 B5 53 50 34 38 4C 52 32 43 44 41 S P 4 8 L R 2 C D A ASCII L U M I N E N T O I C 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 OC-48 LR-2/STM16 L-16.2 SFP Transceiver SP-48-LR2 Outline Drawing Units in mm(inch) Suggested Transceiver Interface 1µ H V CC 10 µF Protocol IC 0.1 µF 1µ H .01 µ F V CC T LuminentOIC R1 TX_DISABLE TX_FAULT SerDes 10k Ω TX_DISABLE TX_FAULT Laser Driver TD + .01 µF 100 Ω TD .01 µF VEE T VCC R 10 µF 0.1 µF RD + 100 Ω Receiver Amplifier .01 µF RD .01 µ F RX_LOS V CC RX_LOS R1 R1 R1 R1 VE E R E E P R OM MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R 1 = 4.7Κ to 10ΚΩ LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1525-FEB1706 rev.A.0 OC-48 LR-1/STM16 L-16.2 SFP Transceiver SP-48-LR2 O r de r in g In f o r m a t io n A v a ila ble O pt io n s: S P-4 8 -LR 2 -CD A S P-4 8 -LR 2 -CN A S P-4 8 -LR 2 -R D A S P-4 8 -LR 2 -R N A Pa r t n u m b e r i n g D e f i n i t i o n : S P - 4 8 - LR 2 - T e m p e r a t u r e D i a g n o s t i c R e v i s i o n • S P = S m a l l Fo r m P l u g g a b l e 4 8 = O C4 8 LR 2 = Lo n g r e a ch 8 0 k m • O pe r a t in g T e m pe r a t u r e C = C o m m e r a ci a l ( -5 t o 7 0 ) R = R e d u ce d I n d u s t r i a l ( -2 0 t o 8 5 ) • D = Digit a l Dia gno st ic N = N o Digit a l Dia gno st ic • Design R ev isio n Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1525-FEB1706 rev.A.0