SPC-4F-01-43CDA

4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA Features • Single 3.3 V supply • 10 km reach • Supports 1.06/2.125/4.25Gb/s Fibre Channel Operation • Compatible with 1.25Gb/s Ethernet • 18 CWDM wavelengths, DFB Laser • SFP MSA SFF-8074i compliant • Digital Diagnostic SFF-8472 compliant • Telcordia GR-468 compliant • RoHS Compliant General Operating Parameter Supply Voltage Total Current Power Supply Noise Rejectiona Operating Case Temperature Storage Temperature Data Rate FC-400 Fibre Channel a) 20Hz to 155MHz Symbol Vcc Icc PSR Top Tst DR Min. 3.135 100 -5 -40 Typical 3.3 4250 Max. 3.465 300 70 85 Unit V mA mVp-p ºC ºC Mbps Transmitter Specifications (Optical) Parameter Optical Power Average Launch Power Of Off Tx Eye Mask Optical Rise Timeb Optical Fall Timeb Mean Wavelength Spectral Width (20dB) Dispersion Penalty (10 Km)c Relative Intensity Noise Reflection Toleranced b) 20%-80% values c) Measured at BER of 1e-12, PRBS of 27-1, at eye center d) 1 dB degradation of receiver sensitivity tr tf λ ∆λ20 dp RIN rp Symbol Pop Poff Min -5 1xxx-6.5nm -24 Typical -2.5 1xxx 0.5 - Max 0 -45 130 130 1xxx+6.5nm 1 1 -120 - Unit dBm dBm Fibre Channel Compliant ps ps nm nm dB dB/Hz dB LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA Transmitter Specifications (Electical) Parameter Input Differential Impedence PECL Single Ended Data Input Swing TxFault_Fault TxFault_Normal TxDisable_Disable TxDisable_Enable Symbol Rin Vin,p-p Vfault Vnormal Vd Ven Min 80 250 2 Vee 2 Vee Typical 100 Max 120 1200 Vcc Vee+0.5 Vcc Vee+0.8 Unit Ω mV V V V V Receiver Specifications Parameter Receive Power Receive Power Wavelength Maximum Reflectance Of Receiver LOS Assert LOS De-assert LOS Hysteresis e) 10-12 BER, PRBS 27-1 Electrical Output Parameter PECL Single Ended Data Output Swing Data Output Rise Time Data Output Fall Time Timing and Electrical Parameter Tx Disable Negate Time Tx Disable Assert Time Time To Initialize, Including Reset Of Tx Fault Tx Fault Assert Time Tx Disable To Reset LOS Assert Time LOS De-assert Time Serial ID Clock Rate RX_LOS Voltage (High) RX_LOS Voltage (Low) LOS Output Voltage-Fault LOS Output Voltage-Normal MOD_DEF (0:2)-High MOD_DEF (0:2)-Low VLOS fault VLOSnormal VH VL Symbol t_on t_off t_init t_fault t_reset t_loss_on t_loss_off f_serial_clock Min 10 2 2 2 Vee 2 Vee Typical Max 50 10 200 100 100 100 100 Vcc 0.8 Vcc Vee+0.5 Vcc Vee+0.5 Unit µs µs ms µs µs µs µs KHz V V V V V V Symbol Vout, p-p tr tf Min 185 Typical Max 800 175 175 Unit mV ps ps Lowe Highe Symbol Rsens,low Rsens,high Pin,damage λ RX_r Min -3 4 1200 -26 0.5 Typical -18 Max -16 1625 -27 -16 Unit dBm dBm dBm nm dB dBm dBm dB Damage Threshold For Receiver LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA λ Wavelength Ordering SPC-4F-01-xxCDA See table below for “XX” values λc Wavelength Guide Code 27 29 31 33 35 37 λC 1271 1291 1311 1331 1351 1371 Unit nm nm nm nm nm nm Code 39 41 43 45 47 49 λC 1391 1411 1431 1451 1471 1491 Unit nm nm nm nm nm nm Code 51 53 55 57 59 61 λC 1511 1531 1551 1571 1591 1611 Unit nm nm nm nm nm nm Diagnostics Parameter Temperature(-CDA) Voltage Bias Current TX Power RX Power Range -5 to 70 0 to Vcc 0 to 120 -5 to 0 -16 to -3 Accuracy ±3 0.1 5 ±3 dB ±3 dB Unit ºC V mA dBm dBm Calibration External External External External External Formula Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset V(Volts) = Vslope*Vad (16 bit unsigned integer) + Voffset I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer +TX_PWRoffset RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA EEPROM Serial ID Name of Field Description of Field Address 20 21 22 23 24 Vendor Name SFP Vendor Name(ASCII) 25 26 27 28 29 30 37 Vendor OUI IEEE Vendor OUI Code For LuminentOIC Inc. 38 39 40 41 42 43 44 Vendor PN Part Number in ASCII, e.g. SPC-4F-01-xxCDA 45 46 47 48 49 50 51 Hex 4C 55 4D 49 4E 45 4E 54 4F 49 43 00 06 B5 53 50 43 34 46 30 31 x x 43 44 41 S P C 4 F 0 1 x x C D A ASCII L U M I N E N T O I C LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Function VeeT TX_FAULT TX_DISABLE MOD_DEF2 MOD_DEF1 MOD_DEF0 NC LOS Notes TX GND Open Collector Internally Pulled High Serial Data Input Serial Clock Input Internally Grounded Not Connected Open Collector RX Ground RX Ground RX Ground RX Data Negative RX Data Positive RX GND RX Power TX Power TX GND TX Data Positive TX Data Negative TX GND VeeR VeeR VeeR RXDRXD+ VeeR VccR VccT VeeT TXD+ TXDVeeT LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA Outline Drawing Units in mm(inches) LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA Suggested Transceiver Interface 1�H Vcc 10�F 0.1�F 1�H .01�F VCCT Protocol IC R1 TX_DISABLE 10K� TX_DISABLE LuminentOIC SFP TX_FAULT TX_FAULT Laser Driver .01�F SerDes TD + 100� TD VEET .01�F VCCR 10�F 0.1�F RD + Receiver Amplifier .01�F 100� RD - RX_LOS Vcc RX_LOS R 1 .01�F VEER EEPROM R1 R1 R1 MOD_DEF 2 MOD_DEF 1 R1=4.7K to 10K� MOD_DEF 0 LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS1663-Apr0908 Rev. A.0 4.25Gb/s Fibre Channel CWDM SFP Transceiver SPC-4F-01-xxCDA Ordering Information Available Options: SPC-4F-01-xxCDA Part Numbering Definition: SPC-4F - Reach - xx Temperature Diagnostic Revision SPC = CWDM SFP 4F = 4x Fibre Channel 01 = 10 km xx = 27 to 61 Operating Temperature C = Commercial (-5 to 70) D = Digital Diagnostic A = Design Revision Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at Luminent’s sole and absolute discretion. Luminent warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and Luminent expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. Luminent assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and Luminent makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. Luminent customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify Luminent for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that Luminent is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact Luminent to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © Luminent, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 8 LUMNDS1663-Apr0908 Rev. A.0