SPL-35-MR-IR1-TDA

SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 Features • Compatible with IEEE 802.3ah, 1000Base-BX10 • Compatible with OC-48/STM-16 Standards • GR 253/ STM G.957 compliant • Single 3.3V Supply • Simplex LC Connector • Digital Diagnostic SFF-8472 Compliant • SFP MSA SFF-8074i Compliant • 13dB Minimum Power Budget • 15km Minimum Reach • Commercial temperature available (-Cxx) • Industrial temperature available (-Txx) • 1310nm DFB Laser • Telcordia GR-468 Compliant • Color code Bail Latch : Bule • RoHS compliant (lead free soldered) General Operation Parameter Supply Voltage Total Current Power Supply Noise Rejection Operating Temperature (-Cxx) Operating Temperature (-Txx) Storage Temperature Data Rate OC-48 Data Rate FEC Data Rate Gigabit Ethernet Data Rate FC Data Rate 2xFC Transmitter Specifications (Optical) Parameter Optical Power Optical Crosstalk Average Launch Power (Tx:Off) Extinction Ratio Eye Mask Optical Rise Time (20% to 80% values) Optical Fall Time (20% to 80% values) Mean Wavelength Spectral Width (20dB) Side Mode Suppression Ratio Dispersion penalty (15km)a Relative Intensity Noise Transmitter Reflectance Reflectance Tolerance tr tf λ ∆λ SMSR dp RIN rp 1280 30 -24 Symbol Pop XT Poff ER Min -5 8.2 Typical -2.5 1310 0.5 Max 0 -45 -45 160 160 1335 1 1 -120 -12 dB/Hz dB dB Unit dBm dB dBm dB ps ps nm nm dB Topr Topr Tstg DR DR DR DR DR Symbol Vcc ICC Min. 3.135 100 -5 -40 -40 Typ. 3.3 2488.32 2700 1250 1062.5 2125 Max. 3.465 300 70 85 85 Unit V mA mVp-p ºC ºC ºC Mbps Mbps Mbps Mbps Mbps SONET/IEEE 802.3ah Compliant a) Measured at 2.7 Gb/s, BER of 10-12, PRBS of 223-1, at eye center 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 LUMINENTOIC.COM 1 LUMNDS1692-Apr3007 Rev 0.1 SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 Transmitter Specifications (Electrical) Parameter Input Differential Impedence PECL Single-Ended Data Input Swing TxFault_Fault TxFault_Normal TxDisable_Disable TxDisable_Enable Symbol Rin Vin, p-p Vfault Vnormal Vd Ven Min 80 250 2 Vee 2 Vee Typical 100 Max 120 1200 Vcc Vee + 0.5 Vcc Vee + 0.8 Unit Ω mV V V V V Receiver Specifications (Optical) Parameter Receiver Power Lowb Receiver Power Highb Damage Threshold for Receiver Wavelength LOS Assert LOS De-Assert LOS Hysteresis Receiver Reflectance Symbol Rsens,low Rsens,high Pin, damage λ Min 0 1480 -28 0.5 Typical -20 Max -18 0 1600 -18 -12 Unit dBm dBm dBm nm dBm dBm dB dB b) Measured at 10-10 BER, 2.7 Gb/s, 223-1 PRBS, and 10-12 BER, 1250 Mb/s, 27-1 PRBS Receiver Specifications (Electrical) Parameter PECL Single-Ended Data Output Swing Data Output Rise Time Data Output Fall Time Symbol Vout,p-p tr tf Min 185 Typical Max 800 175 175 Unit mV ps ps Timing and Electrical Parameter Tx Disable Negate Time Tx Disable Assert Time Time to Initialize, Including Reset of Tx Fault Tx Fault Assert Time Tx Disable to Reset LOS Assert Time LOS De-Assert Time Serial ID Clock Rate RX_LOS Voltage (High) RX_LOS Voltage (Low) LOS Output Voltage-Fault LOS Output Voltage-Normal MOD_DEF (0:2)-High MOD_DEF (0:2)-Low Symbol t_on t_off t_init t_fault t_reset t_loss_on t_loss_off f_serial_clock Rx_LOSH RX_LOSL VLOS fault VLOS normal Vh VI Min 10 2 2 Vee 2 Vee Typical Max 1 10 300 100 100 100 100 0.8 Vcc Vee + 0.5 Vcc Vee + 0.5 Unit ms µs ms µs µs µs µs KHz V V V V V V LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1692-Apr3007 Rev 0.1 SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 Diagnostics Parameter Temperature (-Cxx) Temperature (-Txx) Voltage Bias current TX Power RX Power Range -5 to 70 -40 to 85 0 to Vcc 0 to 120 -5 to 0 -18 to 0 Accuracy ±3 ±3 0.1 5 ±2dB ±2dB Unit Calibration Bit value ºC ºC V mA dBm dBm Internal Internal Internal External External External 1/256 C 1/256 C 100 µV 0.002mA 0.1 µw 0.1 µw Formula Tc(C)=Tad(16 bit signed twos complement)/256 Tc(C)=Tad(16 bit signed twos complement)/256 V(Volts)=Vad(16 bit unsigned integer)*0.1 I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer +TX_PWRoffset RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Pinout Definitions Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Function VeeT TX_FAULT TX_DISABLE MOD_DEF2 MOD_DEF1 MOD_DEF0 NC LOS VeeR VeeR VeeR RXDRXD+ VeeR VCCR VCCT VeeT TXD+ TXDVeeT Notes TX GND Open Collector Internally Pulled High Serial Data Input Serial Clock Input Internally Grounded Not Connected Open Collector RX Ground RX Ground RX Ground RX Data Negative RX Data Positive RX GND RX Power TX Power TX GND TX Data Positive TX Data Negative TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 LUMNDS1692-Apr3007 Rev 0.1 SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 EEPROM Serial ID Name of Field Description of Field Address 20 21 22 23 24 Vendor Name SFP Vendor name(ASCII) 25 26 27 28 29 30 37 Vendor OUI IEEE vendor OUI code for LuminentOIC Inc. 38 39 40 41 42 43 44 45 Vendor PN Part number in ASCII, e.g. SPL-35-MR-IR1-CDA 46 47 48 49 50 51 52 Hex 4C 55 4D 49 4E 45 4E 54 4F 49 43 00 06 B5 53 50 4C 33 35 4D 52 49 52 31 43 44 41 S P L 3 5 M R I R 1 C D A ASCII L U M I N E N T O I C LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1692-Apr3007 Rev 0.1 SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 Suggested Transceiver Interface Mechanicals Units in mm (inches) LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1692-Apr3007 Rev 0.1 SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 Suggested Transceiver Interface 1�H Vcc 10�F 0.1�F 1�H .01�F VCCT Protocol IC R1 10K� TX_DISABLE LuminentOIC SFP TX_DISABLE TX_FAULT SerDes TX_FAULT TD + .01�F Laser Driver 100� TD VEET .01�F VCCR 10�F 0.1�F Receiver Amplifier RD + 100� .01�F RD .01�F RX_LOS RX_LOS Vcc R 1 VEER EEPROM R1 R1 R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1=4.7K to 10K� LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1692-Apr3007 Rev 0.1 SFP Bi-Directional Transceiver Preliminary SPL-35-MR-IR1 Ordering Information Available Options:  SPL-35-MR-IR1-CDA SPL-35-MR-IR1-CNA SPL-35-MR-IR1-TDA SPL-35-MR-IR1-TNA Part numbering Definition: SPL - 35 - MR - IR1 • SPL = LC connector • 35 = Tx 1310nm/Rx 1550nm • MR = Multi Rate • IR1 = Reach 15 km • Operating Temperature C = Commercial temperature (-5 to 70ºC) T = Industrial temperature (-40 to 85ºC) • D = Digital Diagnostic (SFF-8472) N = No Diagnostic • Design Revision A = RoHS compliant (lead free soldered) - Temperature Diagnostic Revision Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at Luminent’s sole and absolute discretion. Luminent warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and Luminent expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. Luminent assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and Luminent makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. Luminent customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify Luminent for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that Luminent is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact Luminent to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © Luminent, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS1692-Apr3007 Rev 0.1