CY2254A

Y 2254A CY2254A Pentium® Processor Compatible Clock Synthesizer/Driver Features • Multiple clock outputs to meet requirements of most Pentium® motherboards — Four pin-selectable CPU clocks @ 66.66 MHz, 60.0 MHz, and 50.0 MHz for support of Intel Triton™ PCIset based PC — 55.0 MHz pin-selectable CPU clock also available ( 2 option only) — Six PCI clocks at 1/2 CPU Clock frequency — One I/O clock @ 24 MHz — One Keyboard Controller clock @ 12 MHz ( 1 option) or one Universal Serial Bus clock @ 48 MHz ( 2 option) — Two Ref. clocks @ 14.318 MHz — Ref. 14.318 MHz Xtal oscillator input • CPU clock jitter < 200 ps cycle-to-cycle • Low skew outputs — < 250 ps between CPU clocks — < 250 ps between PCI clocks — < 500 ps between CPU and PCI clocks ( 2 option) — CPU clock leads PCI clock by +1 ns min. to +4 ns max. ( 1 option) • Freq. stability = 0.01% (max.) • Output duty cycle 45% min. to 55% max. • Test mode support ( 1 option only) • 3.3V or 5.0V operation • Internal pull-up resistors on S0, S1, and OE inputs Functional Description The CY2254A is a Clock Synthesizer/Driver that provides the multiple clocks required for a Pentium-based PC. The CY2254A has low-skew outputs (< 250 ps between the CPU Clocks, < 250 ps between the PCI Clocks). In addition, the CY2254A CPU clock outputs have less than 200 ps cycle-to-cycle jitter. Finally, both the PCI and CPU clock outputs meet the 1 V/ns slew rate requirement of a Pentium processor-based system. The CY2254A accepts a 14.318 MHz reference signal as its input. The CY2254A has 2 PLLs, one of which generates the CPU and PCI clocks, and the other generates the I/O and Keyboard Controller or USB clocks. The CY2254A runs off either a 3.3V or 5V supply. The CY2254A is available in two options. The 1 option supports the Intel Triton PCIset and provides a 12 MHz keyboard clock on pin 25. The 2 option provides a 48 MHz USB clock on pin 25 and supports the Cyrix® M1 processor. Logic Block Diagram REF0 (14.318 MHz) REF1 (14.318 MHz) SYS PLL XTALIN XTALOUT 14.318 MHz OSC. CPU PLL ROM S0 S1 1 option only 2 DELAY PCICLK0 PCICLK1 PCICLK2 PCICLK3 PCICLK4 PCICLK5 OE 2 2 KBDCLK (12 MHz) IOCLK (24 MHz) USBCLK (48 MHz) CPUCLK0 CPUCLK1 CPUCLK2 CPUCLK3 Pin Configuration Top View SOIC VDD XTALIN XTALOUT VSS OE CPUCLK0 CPUCLK1 VDD CPUCLK2 CPUCLK3 VSS S1 S0 VDD 1 2 3 4 5 6 7 8 9 10 11 12 13 14 28 27 26 25 24 23 22 21 20 19 18 17 16 15 REF0 REF1 VDD SEEBELOW IOCLK VSS PCICLK2 PCICLK3 VDD PCICLK4 PCICLK5 VSS PCICLK1 PCICLK0 OPTION 1 2 PIN 25 KBDCLK 12 MHz USBCLK 48 MHz Rev 1.0, November 25, 2006 2200 Laurelwood Road, Santa Clara, CA 95054 Tel:(408) 855-0555 Fax:(408) 855-0550 Page 1 of 7 www.SpectraLinear.com CY2254A Pin Summary Name VDD XTALIN VSS OE CPUCLK0 CPUCLK1 VDD CPUCLK2 CPUCLK3 VSS S1 S0 VDD PCICLK0 PCICLK1 VSS PCICLK5 PCICLK4 VDD PCICLK3 PCICLK2 VSS IOCLK KBDCLK USBCLK VDD REF1 REF0 26 27 28 [1] 1 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 1 2 3 4 5 6 7 8 9 2 Description Voltage supply Reference crystal input Reference crystal feedback Ground Output Enable, Active HIGH (internal pull-up resistor to VDD) CPU clock output CPU clock output Voltage supply CPU clock output CPU clock output Ground CPU clock select input, bit 1 (internal pull-up resistor to VDD) CPU clock select input, bit 0 (internal pull-up resistor to VDD) Voltage supply PCI clock output PCI clock output Ground PCI clock output PCI clock output Voltage supply PCI clock output PCI clock output Ground I/O clock output (24 MHz) Keyboard controller clock output (12 MHz) Universal Serial Bus clock output (48 MHz) Voltage supply Reference clock output (14.318 MHz) Reference clock output (14.318 MHz) XTALOUT[1] 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 Function Table Option 1, 2 1, 2 1, 2 1, 2 1 2 OE 0 1 1 1 1 1 S0 X 0 0 1 1 1 S1 X 0 1 0 1 1 XTALIN CPUCLK PCICLK High-Z 25.0 MHz 30.0 MHz 33.33 MHz TCLK/4 27.5 MHz Ref. Clock Output High-Z IOCLK High-Z KBDCLK 1 only High-Z 12 MHz 12 MHz 12 MHz TCLK/8 48 MHz USBCLK 2 only High-Z 48 MHz 48 MHz 48 MHz 14.318 MHz High-Z 14.318 MHz 50.0 MHz 14.318 MHz 60.0 MHz 14.318 MHz 66.66 MHz TCLK[2] TCLK/2 14.318 MHz 55.0 MHz 14.318 MHz 24 MHz 14.318 MHz 24 MHz 14.318 MHz 24 MHz TCLK TCLK/4 14.318 MHz 24 MHz Note: 1. For best accuracy, use a parallel-resonant crystal, CLOAD = 17 pF. 2. TCLK is a test clock on XTALIN (pin 2) during test mode. Rev 1.0, November 25, 2006 Page 2 of 7 CY2254A PCI Clock Driver Strength Requirements • Matched impedances on both rising and falling edges on the output drivers • Output impedance: 25 (typical) measured at 1.5V measured at 1.5V • Maximum output impedance: 40 Maximum Ratings (Above which the useful life may be impaired. For user guidelines, not tested.) Supply Voltage Input Voltage Storage Temperature (Non-Condensing) 0.5 to +7.0V 0.5V to VDD + 0.5 65 C to +150 C CPU Clock Driver Strength Requirements • Matched impedances on both rising and falling edges on the output drivers • Output impedance: 25 (typical) measured at 1.5V measured at 1.5V • Maximum output impedance: 40 Junction Temperature............................................... +150 C Package Power Dissipation.............................................. 1W Static Discharge Voltage............................................ >2000V (per MIL-STD-883, Method 3015) Operating Conditions[3] Parameter VDD TA CL Supply Voltage 3.3V Supply Voltage 5.0V Operating Ambient Temperature Max. Capacitive Load on CPUCLK PCICLK IOCLK KBDCLK / USBCLK REF0 REF1 Reference Frequency, Oscillator Nominal Value Power-up time for all VDD's to reach minimum specified voltage (power ramps must be monotonic) 14.318 0.05 Description Min. 3.135 4.5 0 Max. 3.6 5.5 70 20 30 20 20 30 15 14.318 50 MHz ms Unit V V C pF f(REF) tPU Electrical Characteristics VDD = 3.135V 3.6V, or 5.0V 10%, TA = 0 C to +70 C Parameter VIH VIL VOH[4] Description High-level Input Voltage Low-level Input Voltage High-level Output Voltage Except Crystal Inputs Except Crystal Inputs VDD = VDD Min. IOH = 6 mA IOH = 12 mA IOH = 4 mA IOH = 8 mA VOL[4] Low-level Output Voltage VDD = VDD Min. IOL = 6 mA IOL = 12 mA IOL = 4 mA IOL = 8 mA IIH IIL IOZ IDD Input High Current Input Low Current Output Leakage Current Power Supply Current VIH = VDD, VDD = 3.3V VIH = VDD, VDD = 5.0V VIL = 0 V, VDD = 3.3V VIL = 0 V, VDD = 5.0V Three-state VDD = 3.6V, VIN = 0 or VDD VDD = 5.5V, VIN = 0 or VDD 10 CPUCLK PCICLK, REF0 KBDCLK, USBCLK REF1 CPUCLK PCICLK, REF0 KBDCLK, USBCLK REF1 5 10 100 250 +10 90 150 A A A A A mA mA 0.4 V 2.4 Test Conditions Min. 2.0 0.8 Max. Unit V V V Rev 1.0, November 25, 2006 Page 3 of 7 CY2254A Electrical Characteristics VDD = 3.135V 3.6V, or 5.0V 10%, TA = 0 C to +70 C (continued) Parameter Description Test Conditions Min. Max. Unit Note: 3. Electrical parameters are guaranteed with these operating conditions. 4. Guaranteed by design, not tested. Switching Characteristics[5] Parameter t1 t2 [4] Output All CPUCLK, PCICLK REF, KBDCLK, USBCLK REF, KBDCLK, USBCLK CPUCLK PCICLK CPUCLK, PCICLK Name Output Duty Cycle Output Rising and Falling Edge Rate Rise Time Fall Time CPU-CPU Clock Skew PCI-PCI Clock Skew CPU-PCI Skew [6] Description t1 = t1A t1B Min. 45% 1 Max. 55% Unit Measured between 0.4 and 2.4V Measured between 0.4 and 2.4V Measured between 2.4 and 0.4V Measured at 1.5V Measured at 1.5V Measured at 1.5V ( 1 option) Measured at 1.5V ( 2 option) V/ns 4 4 250 250 ns ns ps ps ns ps ps t3[4] t4[4] t5[4] t6[4] t7[4] t8[4] 1 4 500 200 CPUCLK Cycle-Cycle Clock Jitter CPU Clock Jitter Switching Waveforms Duty Cycle Timing t1B t1A 1.5V 1.5V 1.5V All Outputs Rise/Fall Time 2.4V 0.4V t2 t3 2.4V 0.4V t2 t4 3.3V 0V OUTPUT Rev 1.0, November 25, 2006 Page 4 of 7 CY2254A Switching Waveforms (continued) Clock Skew 1.5V CPUCLK/ PCICLK t5 t6 1.5V Note: 5. All parameters specified with outputs fully loaded. 6. Duty cycle is measured at 1.5V. Rev 1.0, November 25, 2006 Page 5 of 7 CY2254A Switching Waveforms (continued) CPU-PCI Clock Skew CPUCLK 1.5V PCICLK t7 1.5V Test Circuit VDD 1 0.1 F 4 VDD 0.1 F 26 0.1 F 23 8 20 0.1 F 11 17 14 0.1 F OUTPUTS CLOAD Note: All capacitors should be placed as close to each pin as possible. Rev 1.0, November 25, 2006 Page 6 of 7 CY2254A Ordering Information Ordering Code CY2254ASC 1 CY2254ASC 2 Package Name S21 S21 Package Type 28-Pin SOIC 28-Pin SOIC Operating Range Commercial Commercial Package Drawing and Dimensions 28-Lead (300-Mil) Molded SOIC S21 While SLI has reviewed all information herein for accuracy and reliability, Spectra Linear Inc. assumes no responsibility for the use of any circuitry or for the infringement of any patents or other rights of third parties which would result from each use. This product is intended for use in normal commercial applications and is not warranted nor is it intended for use in life support, critical medical instruments, or any other application requiring extended temperature range, high reliability, or any other extraordinary environmental requirements unless pursuant to additional processing by Spectra Linear Inc., and expressed written agreement by Spectra Linear Inc. Spectra Linear Inc. reserves the right to change any circuitry or specification without notice. Rev 1.0, November 25, 2006 Page 7 of 7